2005 MERCEDES-BENZ SLK CLASS ESP

186 Controls in detailAutomatic climate control*Decreasing
Press blue temperature control
switchƒborc.
The automatic climate control system
will correspondingly adjust the interior
air temperature.
The selected temperature will be indi-
cated in displaye.
Adjusting air volume
Turn air volume control1
(page 185) to the desired position.
The indicator lamp on the automatic
mode switchU (
page 185) goes
out. The air volume is no longer adjust-
ed automatically.
The following symbols are found on the
control:
Adjusting air distribution
Turn air distribution control8
(page 185) to the desired position.
The indicator lamp on the automatic
mode switchU (
page 185) goes
out. The air distribution is no longer ad-
justed automatically.
The following symbols are found on the
control:
Air recirculation mode
Switch to air recirculation mode to prevent
unpleasant odors from entering the vehicle
from the outside. This setting cuts off the
intake of outside air and recirculates the
air in the interior.
Activating
Press air recirculation switch,
(page 185).
The indicator lamp on the air recircula-
tion switch, comes on.
Symbol
Function
between1
and6
Ventilation with increasing
blower speed
Symbol
Function
Z
Directs air to the windows
b
Directs air into the entire
vehicle interior
Y
Directs air to the footwells
a
Directs air through the
center, side and cockpit air
vents
Warning!
G
When the outside temperature is below
41°F (5°C), only switch to air recirculation
mode for short periods to prevent window
fogging.

187 Controls in detail
Automatic climate control*
Deactivating
Press air recirculation switch,
again (
page 185).
The indicator lamp on the air recircula-
tion switch, goes out.
iThe air recirculation mode activates au-
tomatically at high outside tempera-
tures.
A quantity of outside air is added after
approximately 30 minutes.iIf you press the air recirculation
switch, and keep it pressed, the
side windows will close.
Warning
G
Never operate the side windows if there is
the possibility of anyone being harmed by
the closing procedure.
In the event that the procedure causes po-
tential danger, the closing of the door win-
dows can be immediately halted by
releasing the, button or by pressing the
respective power window switch.
The closing of the rear side windows can be
immediately halted by releasing the
,button.
iThe air recirculation mode deactivates
automatically:

after 30 minutes if the outside tem-
perature is above approximately
41°F (5°C)


after five minutes if the outside
temperature is below approximate-
ly 41°F (5°C)


after five minutes if the air condi-
tioning is turned off (
page 188)
iIf you press the air recirculation
switch, and keep it pressed
and no side window was operated
manually, the side windows will reopen
to their previous position.

196 Controls in detailAudio systemAdjusting treble
Press O button repeatedly until TREBLE
appears in the display.

Press
+or
– soft key to increase or
decrease tone level accordingly.
or

Press
RES
soft key briefly to reset treble
tones to their center level.
The radio switches back to the
standard radio menu eight seconds
after the last soft key is pressed.Returning sound functions to factory
settings

Press O button to call up settings
menu in the display.

Press
RES
soft key briefly; the respec-
tive sound function is reset to its center
level.
or

Press and hold
RES
soft key until
RESET

appears in the display.
The sound settings for bass and treble
are returned to their center level and
the volume is set to a predefined level.
The radio switches back to the
standard radio menu four seconds
after the last soft key is pressed.Adjusting balance

Press P button.BALANCE
appears in the display.

Press X or Y soft key.
The volume is distributed between the
left and right sides of the vehicle.
or

Press
RES
soft key briefly.
The balance is reset to its center level.
The radio switches back to the
standard radio menu eight seconds
after the last button is pressed.

197 Controls in detail
Audio system
Returning volume distribution to
factory settings
Press P button to call up settings
menu in the display.

Press
RES
soft key briefly; the
respective volume distribution is reset
to its center (flat) level.
or

Press and hold
RES
soft key until
RESET

appears in the display.
The volume distribution settings for the
balance is set to the center level.
The radio switches back to the
standard radio menu four seconds
after the last soft key is pressed.Telephone* muting
If your vehicle equipment includes a
Mercedes-Benz specified mobile
telephone*, you can adjust its volume
separately from the volume of the audio
system while the telephone is being used.
Radio operation
Selecting radio mode
Press b button.
Calling up wavebands
You can choose from among the FM, AM
and WB wavebands.
Weather band (
page 201).
iFM waveband: 87.7......107.9 MHz
AM waveband: 530......1 710 KHz

199 Controls in detail
Audio system
Direct frequency input
Select desired waveband.

Press * button.

Enter desired frequency with
buttons1to R.Manual tuning

Select desired waveband.

PressGorHbutton for approx.
three seconds.

Press button repeatedly until desired
frequency has been reached.
Step-by-step station tuning takes place
in ascending or descending order. Each
time the button is pressed, the radio
tunes further by 0.2 MHz. During
manual tuning, the radio is muted.
Automatic seek tuning

Select desired waveband.

PressGorHbutton briefly.
The radio will tune to the next highest
or next lowest receivable frequency.Scan search


Starting scan search
Select desired waveband.

Press
SC soft key.
SC will appear in the display. The
radio briefly (approximately
eight seconds) tunes in all receiv-
able stations on the waveband
selected.


Ending scan search
Press
SC soft key orGorH.
The station last played will be
selected and
SC disappears from
the display.
iYou can only enter frequencies within
the respective waveband.
If a button is not pressed within
four seconds, the radio will return to
the last station tuned.
iIf no station is received after two
consecutive scans of the complete
frequency range, then the scan stops
at the frequency from which it began.

204 Controls in detailAudio systemSelecting a station
The following options are available:

Selecting a station using the selected
category (
page 205),


Tuning via station presets
(page 204),


Tuning via scan search (
page 205).


Tuning via manual channel input
(page 204).


Tuning via the program category list
(page 204).
Tuning via station presets
Ten satellite radio station presets are
available.
You can access the presets via number
keys.Accessing via number keys

Enter number of preset you wish to
select, e.g. 1.
The radio plays the station stored
under this number and the PTY function
changes to the category corresponding
to the station.
Tuning via manual channel input
Example: tuning in channel 16

Press *.
Input line appears in the main radio
menu.

Use number keys to enter desired
channel within eight seconds,
e.g.1 6.
The system tunes to channel 16.
The station you have selected begins to
play.
Tuning via the program category list
The category list contains all currently
receivable categories of programs. It is
arranged alphabetically.iYou can only enter available channel
numbers.

207 Controls in detail
Audio system
CD mode
Safety precautions
General notes
The system may not be able to play audio
CDs with copy protection.
Playing copied CDs may cause
malfunctions during playback.Warning!
G
The single CD player and the CD changer*
are Class 1 laser products. There is a danger
of invisible laser radiation if the housing is
opened or damaged.
Do not open the housing. The single CD
player and the CD changer* do not contain
any parts that can be serviced by the user.
For safety reasons, have any service work
which may be necessary performed only by
qualified personnel.
Warning!
G
In order to avoid distraction which could
lead to an accident, the driver should insert
CDs with the vehicle at a standstill and
operate the audio system only if permitted
by road, weather and traffic conditions.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your car covers a
distance of 44 feet (approximately 14 m)
every second.iThe audio system plays both CD-Rs and
CD-RWs with audio data.
!If you affix stickers to the CDs, they can
become warped due to the heat that
develops in the CD drive or
CD changer.
In certain situations, the CDs can then
no longer be ejected and cause
damage to the drive. Such damage is
not covered by the Mercedes-Benz
Limited Warranty.!Your CD drive or CD changer has been
designed to play CDs which
correspond to the EN 60908 standard.
You can therefore only use CDs with a
maximum thickness of 1.3 mm.
If you insert thicker data carriers, e.g.
ones that have data on both sides (one
side with DVD data, the other side with
audio data), they cannot be ejected and
will damage the drive.

209 Controls in detail
Audio system
Ejecting a CD
Make sure the system is switched on.

Press gbutton.
The system ejects the CD.
Remove CD0

will appear in the display.

Remove CD from slot.
With the CD removed,
NO CD
will appear
in the display.Operational readiness of CD changer*
If a CD changer has been installed in the
vehicle, it can be operated from the front
control panel of the audio system.
The CD changer is located in the glove box.
1CD loading slot
2Magazine slot button
A magazine is integrated into the CD
changer as a fixed element. It holds a max-
imum of six CDs.
The CD changer features six magazine slot
buttons2 for controlling the loading pro-
cedure.A light-emitting diode in the buttons shows
the status of the corresponding magazine
slot.
CD loading slot1 is above buttons2
and is used to load CDs.
Loading the CD magazine
iIf a CD has been inserted incorrectly or
cannot be read,
WRONG CD0
will appear
in the display.
iIf you do not take the CD out of the CD
slot within approx. 15 seconds, the
system automatically pulls the CD back
in and plays it.
If a CD is pulled back in, press
gbutton, the CD will then be
ejected.
LEDsno LED is lit
Magazine slot is
empty.
green LED flashes
CD can be loaded.
red LED is lit
Magazine slot is in
use.
red LED flashes
CD is being ejected.
iIf a CD has been inserted incorrectly or
cannot be read,
WRONG CD0
will appear
in the display.
Loading one or more CDs interrupts the
CD playback.