Page 307 of 474

305 Operation
Tires and wheels
Tire and loading terminology
Accessory weight
The combined weight (in excess of those 
standard items which may be replaced) of 
automatic transmission, power steering, 
power brakes, power windows, power 
seats, radio, and heater, to the extent that 
these items are available as 
factory-installed equipment (whether 
installed or not).
Air pressure
The amount of air inside the tire pressing 
outward on each square inch of the tire. 
Air pressure is expressed in pounds per 
square inch (psi), or kilopascal (kPa) or 
bars.
Aspect ratio
Dimensional relationship between tire 
section height and section width 
expressed in percentage.Bar
Another metric unit for air pressure. There 
are 14.5038 pounds per square inch (psi) 
to 1 bar; there are 100 kilopascals (kPa) 
to 1 bar.
Bead
The tire bead contains steel wires wrapped 
by steel cords that hold the tire onto the 
rim.
Cold tire inflation pressure
Tire inflation pressure when your vehicle 
has been sitting for at least three hours or 
driven no more than one mile (1.6 km). 
Curb weight
The weight of a motor vehicle with stan-
dard equipment including the maximum 
capacity of fuel, oil, and coolant, and, if so 
equipped, air conditioning and additional 
optional equipment, but without passen-
gers and cargo.DOT (D
epartment o
f T
ransportation)
A tire branding symbol which denotes the 
tire meets requirements of the 
U.S. Department of Transportation.
GAWR (G
ross A
xle W
eight R
ating)
The GAWR is the maximum permissible 
axle weight. The gross vehicle weight on 
each axle must never exceed the GAWR for 
the front and rear axle indicated on the 
certification label located on the driver’s 
door B-pillar.
GVW (G
ross V
ehicle W
eight)
The GVW comprises the weight of the 
vehicle including fuel, tools, spare wheel, 
installed accessories, passengers and 
cargo and, if applicable, trailer tongue 
load. The GWV must never exceed the 
GWVR indicated on the certification label 
located on the driver’s door B-pillar. 
     
        
        Page 308 of 474

306 OperationTires and wheelsGVWR (G
ross V
ehicle W
eight R
ating)
This is the maximum permissible vehicle 
weight of the fully loaded vehicle (weight of 
the vehicle including all options, passen-
gers, fuel, and cargo and, if applicable, 
trailer tongue load). It is indicated on 
certification label located on the driver’s 
door B-pillar.
Kilopascal (kPa)
The metric unit for air pressure. There are 
6.9 kPa to one psi; another metric unit for 
air pressure is bars. There are 
100 kilopascals (kPa) to one bar.
Maximum load rating
The maximum load in kilograms and 
pounds that can be carried by the tire.
Maximum loaded vehicle weight
The sum of curb weight, accessory weight, 
vehicle capacity weight and production 
options weight.Maximum tire inflation pressure
This number is the greatest amount of air 
pressure that should ever be put in the tire 
under normal driving conditions.
Normal occupant weight
The number of occupants the vehicle is 
designed to seat, multiplied by 
68 kilograms (150 lbs).
Occupant distribution
The distribution of occupants in a vehicle 
at their designated seating positions.
Production options weight
The combined weight of those installed 
regular production options weighing over 
5 lbs (2.3 kilograms) in excess of those 
standard items which they replace, not 
previously considered in curb weight or 
accessory weight, including heavy duty 
brakes, ride levelers, roof rack, heavy duty 
battery, and special trim.PSI (P
ounds per s
quare i
nch)
A standard unit of measure for air pressure 
-> bar, kilopascal (kPa).
Recommended tire inflation pressure
Recommended tire inflation pressure 
listed on placard located on driver’s door 
B-pillar for normal driving conditions. 
Provides best handling, tread life and 
riding comfort.
Rim
A metal support for a tire or a tire and tube 
assembly upon which the tire beads are 
seated.
Sidewall
The portion of a tire between the tread and 
the bead. 
     
        
        Page 317 of 474

315 Operation
Vehicle care
Vehicle care
Cleaning and care of the vehicle
While in operation, even while parked, your 
vehicle is subjected to varying external in-
fluences which, if gone unchecked, can at-
tack the paintwork as well as the 
underbody and cause lasting damage.Such damage is caused not only by ex-
treme and varying climatic conditions, but 
also by:
Air pollution
Road salt
Tar
Gravel and stone chipping
To avoid paint damage, you should imme-
diately remove:
Grease and oil
Fuel
Coolant
Brake fluid
Bird droppings
Insects
Tree resins, etc.
Frequent washing reduces and / or elimi-
nates the aggressiveness and potency of 
the above adverse influences.More frequent washings are necessary to 
deal with unfavorable conditions:
near the ocean
in industrial areas (smoke, exhaust 
emissions)
during winter operation
You should check your vehicle from time to 
time for stone chipping or other damage. 
Any damage should be repaired as soon as 
possible to prevent corrosion.
In doing so, do not neglect the underbody 
of the vehicle. A prerequisite for a thor-
ough check is a washing of the underbody 
followed by a thorough inspection. Dam-
aged areas need to be re-undercoated.
Your vehicle has been treated at the facto-
ry with a wax-base rustproofing in the body 
cavities which will last for the lifetime of 
the vehicle. Post-production treatment is 
neither necessary nor recommended by 
Mercedes-Benz because of the possibility 
of incompatibility between materials used 
in the production process and others ap-
plied later.
Warning!
G
Many cleaning products can be hazardous. 
Some are poisonous, others are flammable. 
Always follow the instructions on the partic-
ular container. Always open your vehicle’s 
doors or windows when cleaning the inside.
Never use fluids or solvents that are not de-
signed for cleaning your vehicle. 
     
        
        Page 329 of 474

327 Practical hints
What to do if …
Problem
Possible cause
Suggested solution
ú
(USA only)
±
(Canada only)
The yellow engine malfunction 
indicator lamp comes on while 
driving.
There is a malfunction in:
The fuel injection system 
The ignition system 
The emission control system 
Systems which effect emissions
Such malfunctions may result in excessive 
emissions values and may switch the engine 
to its limp-home (emergency operation) 
mode.
Have the vehicle checked as soon as 
possible by an authorized 
Mercedes-Benz Center.
An on-board diagnostic connector is 
used by the service station to link the 
vehicle to the shop diagnostics sys-
tem. It allows the accurate identifica-
tion of system malfunctions through 
the readout of diagnostic trouble 
codes. It is located in the front left 
area of the footwell next to the park-
ing brake.
The fuel cap is not closed tightly.
Check the fuel cap (
page 267).
If it is not closed properly:
Close the fuel cap.
If it is closed properly:
Have the fuel system checked by an 
authorized Mercedes-Benz Center. 
     
        
        Page 330 of 474

328 Practical hintsWhat to do if …Problem
Possible cause
Suggested solution
ú
(USA only)
±
(Canada only)
The yellow engine malfunction 
indicator lamp comes on while 
driving.
Your fuel tank is empty.
After refuelling, start, turn off, and re-
start the engine three or four times in 
succession. 
The limp-home mode is canceled. You 
do not need to have your vehicle 
checked.
D
The red coolant warning lamp 
comes on when the engine is 
running.
There is insufficient coolant in the reservoir.
If this warning lamp comes on frequently, 
there is a leak in the cooling system.
If the coolant level is correct, the electric ra-
diator fan may be broken. 
Immediately add coolant to prevent 
engine from overheating 
(page 276).
Have the cooling system checked.
If the coolant temperature is below 
248 °F (120 °C), you can continue 
driving to the nearest authorized 
Mercedes-Benz Center.
Avoid high engine loads (e.g. driving 
uphill) and stop-and-go driving.
D
The red coolant warning lamp 
comes on while driving and you 
hear a warning sound.
The coolant temperature has exceeded 
248 °F (120 °C).
Stop as soon as possible and allow 
the engine and coolant to cool down. 
     
        
        Page 332 of 474
330 Practical hintsWhat to do if …Problem
Possible cause
Suggested solution
E
The red DTR indicator lamp 
comes on while driving and you 
hear a warning sound.
You are gaining too rapidly on the vehicle 
ahead of you.
The distance warning system has recog-
nized a stationary obstacle on your prob-
able line of travel.
Apply the brakes immediately.
Carefully observe the traffic situation. 
You may need to brake or maneuver 
to avoid hitting an obstacle.
E
The white DTR indicator lamp 
comes on while driving.
The Distronic* distance sensor has recog-
nized a vehicle in front of you.
A
The yellow fuel tank reserve 
warning lamp lights while driv-
ing.
The fuel level has dropped below the reserve 
mark.
Refuel at the next gas station 
(page 267).
The fuel cap is not closed tightly.
Check the fuel cap (
page 267). 
     
        
        Page 335 of 474

333 Practical hints
What to do if …
Problem
Possible cause
Suggested solution
H
The yellow warning lamp for the 
tire pressure monitoring system 
comes on.
The tire pressure monitoring system de-
tects a loss of pressure in at least one tire.
Bring the vehicle to a halt, avoiding 
abrupt steering and braking maneuvers. 
Observe the traffic situation around you.
Take note of the messages in the multi-
function display.
The warning lamp goes out once the tire in-
flation pressure monitor has been reactivat-
ed after the tire inflation pressure has been 
corrected.
Warning!
G
When the tire pressure monitoring system 
warning light is lit, one or more of your tires 
is significantly under-inflated. You should 
stop and check your tires as soon as possi-
ble, and inflate them to the proper pressure 
as indicated on the vehicle’s tire information 
placard. Driving on a significantly under-in-
flated tire causes the tire to overheat and 
can lead to tire failure.
Under-inflation also reduces fuel efficiency 
and tire tread life, and may affect the vehi-
cle’s handling and stopping ability. Each tire, 
including the spare, should be checked 
monthly when cold and set to the recom-
mended inflation pressure as specified in 
the vehicle placard and owner’s manual.
iThe recommended tire inflation pres-
sures for your vehicle can be found on 
the tire placard on the driver’s door 
B-pillar, not in the owner’s manual. 
     
        
        Page 353 of 474

351 Practical hints
What to do if …
Left display
Right display
Possible cause
Possible solution
?
Engine
Service
There may be a malfunction in the 
fuel injection system
ignition system
exhaust system
fuel system
Have the engine checked as soon as possible 
by an authorized Mercedes-Benz Center 
(page 327).
B
Coolant
Check level
The coolant level is too low.
Add coolant (
page 276).
If you have to add coolant frequently, have the 
cooling system checked by an authorized 
Mercedes-Benz Center.
Warning!
G
Do not spill antifreeze on hot engine parts. 
Antifreeze contains ethylene glycol which 
may burn if it comes into contact with hot 
engine parts. You can be seriously burned.
!Do not ignore the low engine coolant 
level warning. Extended driving with 
this message and symbol displayed 
may cause serious engine damage not 
covered by the Mercedes-Benz Limited 
Warranty. Do not drive without suffi-
cient amount of coolant in the cooling 
system. The engine will overheat, caus-
ing major engine damage.