Page 277 of 474

275 Operation
Engine compartment
SL 65 AMG1Filler cap
Unscrew filler cap1 from filler neck.
Add engine oil as required. Be careful 
not to overfill with oil.
Be careful not to spill any oil when adding. 
Avoid environmental damage caused by oil 
entering the ground or water.
Screw filler cap1 back on filler neck.
For more information on engine oil, see the 
“Technical data” section (
page 431) and 
(
page 433).
Transmission fluid level
The transmission fluid level does not need 
to be checked. If you notice transmission 
fluid loss or gear shifting malfunctions, 
have an authorized Mercedes-Benz Center 
check the automatic transmission. Oil level in the ABC system
The oil level in the ABC system does not 
need to be checked. If there is visible oil 
loss or if malfunction messages appear in 
the display, have an authorized 
Mercedes-Benz Center check the ABC 
system.
!Excess oil must be siphoned or drained 
off. It could cause damage to the 
engine and catalytic converter not 
covered by the Mercedes-Benz Limited 
Warranty. 
     
        
        Page 278 of 474

276 OperationEngine compartmentCoolantThe engine coolant is a mixture of water 
and anticorrosion/antifreeze. To check 
the coolant level, the vehicle must be 
parked on level ground and the engine 
must be cool. 
The coolant expansion tank is located on 
the passenger side of the engine compart-
ment. 
1Coolant expansion tank
Using a rag, turn the cap slowly approx-
imately one half turn to the left to re-
lease any excess pressure.
Continue turning the cap to the left and 
remove it.
The coolant level is correct if the level 
for cold coolant: is up to the upper 
mark on the bracing rib of the coolant 
expansion tank (translucent)
for warm coolant: is approx. 0.6 in 
(1.5 cm) higher
Add coolant as required.
Replace and tighten cap. 
For more information, see “Coolants” 
(
page 435).
Warning!
G
In order to avoid any possibly serious burns:
Use extreme caution when opening the 
hood if there are any signs of steam or 
coolant leaking from the cooling system, 
or if the coolant temperature gauge indi-
cates that the coolant is overheated.
Do not remove pressure cap on coolant 
reservoir if coolant temperature is 
above 158°F (70°C). Allow engine to 
cool down before removing cap. The 
coolant reservoir contains hot fluid and 
is under pressure.
Using a rag, slowly open the cap approx-
imately 
1/2 turn to relieve excess pres-
sure. If opened immediately, scalding 
hot fluid and steam will be blown out un-
der pressure.
Do not spill antifreeze on hot engine 
parts. Antifreeze contains ethylene gly-
col which may burn if it comes into con-
tact with hot engine parts.
!SL 600 and SL 65 AMG: Only open the 
cap on coolant expansion tank1. 
Never open the cap between the two 
charge-air coolers. Otherwise, the en-
gine could be damaged. 
     
        
        Page 280 of 474

278 OperationEngine compartmentWindshield washer system and headlamp cleaning system
The windshield washer reservoir is located 
in the engine compartment.
1Washer fluid reservoir
Fluid for the windshield washer system and 
the headlamp cleaning system is supplied 
from the windshield washer reservoir. It 
has a capacity of approx. 7.4 US qt. (7 l).During all seasons, add MB Windshield 
Washer Concentrate “S” to water. Pre-mix 
the windshield washer fluid in a suitable 
container.
Refill the reservoir with MB Windshield 
Washer Concentrate and water (or 
commercially available pre-mixed 
windshield washer solvent / antifreeze, 
depending on ambient temperatures).
Always use washer solvent/antifreeze 
where temperatures may fall below 
freezing point. Failure to do so could re-
sult in damage to the washer sys-
tem/reservoir.
For more information, see “Windshield and 
headlamp washer system” (
page 438).
Warning!
G
Washer solvent / antifreeze is highly flam-
mable. Do not spill washer 
solvent / antifreeze on hot engine parts, be-
cause it may ignite and burn. You could be 
seriously burned.!Only use washer fluid which is suitable 
for plastic lenses. Improper washer flu-
id can damage the plastic lenses of the 
headlamps. 
     
        
        Page 317 of 474

315 Operation
Vehicle care
Vehicle care
Cleaning and care of the vehicle
While in operation, even while parked, your 
vehicle is subjected to varying external in-
fluences which, if gone unchecked, can at-
tack the paintwork as well as the 
underbody and cause lasting damage.Such damage is caused not only by ex-
treme and varying climatic conditions, but 
also by:
Air pollution
Road salt
Tar
Gravel and stone chipping
To avoid paint damage, you should imme-
diately remove:
Grease and oil
Fuel
Coolant
Brake fluid
Bird droppings
Insects
Tree resins, etc.
Frequent washing reduces and / or elimi-
nates the aggressiveness and potency of 
the above adverse influences.More frequent washings are necessary to 
deal with unfavorable conditions:
near the ocean
in industrial areas (smoke, exhaust 
emissions)
during winter operation
You should check your vehicle from time to 
time for stone chipping or other damage. 
Any damage should be repaired as soon as 
possible to prevent corrosion.
In doing so, do not neglect the underbody 
of the vehicle. A prerequisite for a thor-
ough check is a washing of the underbody 
followed by a thorough inspection. Dam-
aged areas need to be re-undercoated.
Your vehicle has been treated at the facto-
ry with a wax-base rustproofing in the body 
cavities which will last for the lifetime of 
the vehicle. Post-production treatment is 
neither necessary nor recommended by 
Mercedes-Benz because of the possibility 
of incompatibility between materials used 
in the production process and others ap-
plied later.
Warning!
G
Many cleaning products can be hazardous. 
Some are poisonous, others are flammable. 
Always follow the instructions on the partic-
ular container. Always open your vehicle’s 
doors or windows when cleaning the inside.
Never use fluids or solvents that are not de-
signed for cleaning your vehicle. 
     
        
        Page 328 of 474

326 Practical hintsWhat to do if …Problem
Possible cause
Suggested solution
;
(USA only)
3
(Canada only)
The red brake warning lamp 
comes on while driving and 
you hear a warning sound.
The red brake warning lamp 
comes on while driving 
You are driving with the parking brake set,
or
there is a malfunction in the SBC brake system.
There is insufficient brake fluid in the reservoir.
Release the parking brake 
(page 50).
Read and observe messages in the 
display (
page 335).
Risk of accident! Carefully stop the 
vehicle and notify an authorized 
Mercedes-Benz Center. Do not add 
brake fluid! This will not solve the 
problem.
Warning!
G
Driving with the brake warning lamp illumi-
nated can result in an accident. Have your 
brake system checked immediately if the 
brake warning lamp stays on. Do not add 
brake fluid before checking the brake sys-
tem. 
Overfilling the brake fluid reservoir can re-
sult in spilling brake fluid on hot engine 
parts and the brake fluid catching fire. You 
can be seriously burned.
!If you find that the brake fluid in the 
brake fluid reservoir has fallen to the 
minimum mark or below, have the 
brake system checked for brake pad 
thickness and leaks. 
     
        
        Page 331 of 474
329 Practical hints
What to do if …
Warning!
G
Driving when your engine is badly overheat-
ed can cause some fluids which may have 
leaked into the engine compartment to 
catch fire. You could be seriously burned.
Steam from an overheated engine can cause 
serious burns and can occur just by opening 
the engine hood. Stay away from the engine 
if you see or hear steam coming from it.
Turn off the engine, get out of the vehicle 
and do not stand near the vehicle until the 
engine has cooled down. 
     
        
        Page 351 of 474
349 Practical hints
What to do if …
Left display
Right display
Possible cause
Possible solution
USA only:;Canada only:3
Brake fluid
below min. level
Visit
workshop
There is insufficient brake fluid in 
the reservoir.
Risk of accident! Stop the vehicle as soon as 
it is safe to do so and notify an authorized 
Mercedes-Benz Center.
Do not add brake fluid! This will not solve the 
problem.
!If you find that the brake fluid in the 
brake fluid reservoir has fallen to the 
minimum mark or below, have the 
brake system checked for brake pad 
thickness and leaks.
Warning
G
Driving with this message displayed can re-
sult in an accident. Have your brake system 
checked immediately. Do not add brake flu-
id before checking the brake system. Over-
filling the brake fluid reservoir can result in 
spilling brake fluid on hot engine parts and 
the brake fluid catching fire. You can be se-
riously burned. 
     
        
        Page 354 of 474

352 Practical hintsWhat to do if …
During severe operating conditions, e.g. 
stop-and-go traffic, the coolant tempera-
ture may rise close to 248°F (120°C).
Left display
Right display
Possible cause
Possible solution
•
Coolant
Stop, put engine off!
The coolant is too hot.
Stop the vehicle and turn off the engine.
Only start the engine again after the message 
disappears. You could otherwise damage the 
engine.
Warning!
G
Driving when your engine is badly overheat-
ed can cause some fluids which may have 
leaked into the engine compartment to 
catch fire. You could be seriously burned.
Steam from an overheated engine can cause 
serious burns and can occur just by opening 
the engine hood. Stay away from the engine 
if you see or hear steam coming from it.
Turn off the engine, get out of the vehicle 
and do not stand near the vehicle until the 
engine has cooled down.
!The engine should not be operated with 
the coolant temperature above 248°F 
(120°C). Doing so may cause serious 
engine damage which is not covered by 
the Mercedes-Benz Limited Warranty.