2005 MERCEDES-BENZ S430 Trunk handle

384 Practical hintsUnlocking/locking in an emergencyUnlocking the trunk
A minimum height clearance of 6 ft.
(1.85 m) is required to open the trunk lid.
The trunk lid lock is located next to the
handle above the rear license plate recess.
1Unlocking and opening
Insert the mechanical key into the
trunk lid lock until it stops.

Turn the mechanical key counterclock-
wise to position1.
The trunk unlocks and opens.
Locking the vehicle
If you are unable to lock the vehicle with
the SmartKey or the SmartKey with
KEYLESS-GO*, do the following:
Close the passenger doors and the
trunk lid.

Press the central locking switch in the
center console (
page 113).

Check to see whether the locking
knobs on the passenger doors have
moved down.

If necessary push them down manually.
Except for the driver's door, the vehicle
should now be locked.1Unlocking

Remove the mechanical key out of the
SmartKey (
page 383).

Insert the mechanical key into the driv-
er’s door lock until it stops.

Turn the mechanical key clockwise to
position1.
The driver’s door is locked.
!The trunk lid swings open upwards au-
tomatically. Always make sure that
there is sufficient overhead clearance.

402 Practical hintsFlat tireLowering the vehicle
Lower vehicle by turning crank coun-
terclockwise until vehicle is resting ful-
ly on its own weight.

Remove the jack.
1 - 5 Wheel bolts

Tighten the five wheel bolts evenly, fol-
lowing the diagonal sequence illustrat-
ed (1 to 5), until all bolts are tight.
Observe a tightening torque of
110 lb-ft (150 Nm).

Before storing the jack in the trunk, it
should be fully collapsed, with handle
folded in.

Place the wheel bolt wrench, alignment
bolt and jack back in the vehicle tool kit
in the trunk and close the covering lid.Replacing jack support tube cover

Slide tongue of cover under the upper
edge of the tube opening.

Applying even pressure, press cover
until it snaps into place. Be careful not
to damage the locking tabs or clamp
the plastic retaining strap.
Warning!
G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
110 lb-ft (150 Nm).
!You can also screw the faulty wheel
down into the spare wheel well in the
trunk.
Do not activate the tire inflation pres-
sure monitor* until the depressurized
tire is no longer in the vehicle.

456 IndexLight alloy wheels
Cleaning 335
Light sensor 366
Lighter see Cigarette lighter 252
Lighting 131
Automatic headlamp mode 132
Combination switch 135
Courtesy lighting 139
Daytime running lamp mode 133
Door entry lamps 139
Exterior lamp switch 131
Front fog lamps 134
High beam flasher 135
High beams 135
Instrument cluster illumination 140
Interior 137
Locator lighting 133
Low beam 131
Manual headlamp mode 132
Night security illumination 133Parking lamps 131
Rear fog lamp 134
Settings (control system) 164
Trunk 138, 139
Limiting opening height of trunk lid* 105
Limiting the gear range 176
Limp Home Mode 185
Line of fall 440
Loading 240
Cargo tie-down hooks 241
Instructions 241
Roof rack 240
Loading terminology 322
Loading the vehicle 299
Locator lighting 133
Setting 166
Lock button 440
Door handle (KEYLESS-GO*) 58
SmartKey 92
SmartKey with KEYLESS-GO* 96Locking 55, 58, 92
Fuel filler flap 283
Global (SmartKey with
KEYLESS-GO*) 99
Global, SmartKey 94
Glove box 244
Vehicle in an emergency 384
Vehicle with KEYLESS-GO* 101
with the KEYLESS-GO* 58
with the SmartKey 58
Loss of SmartKey 96
Loss of Smartkey with
KEYLESS-GO* 102
Low beam headlamps
Messages in display 366, 367
Replacing bulbs 390
Lowering
Vehicle 402
Lumbar support adjustment 122