2005 MERCEDES-BENZ S CLASS engine oil

431 Technical data
Fuels, coolants, lubricants, etc.
Engine oils
Engine oils are specifically tested for their
suitability in our engines and durability for
our service intervals. Therefore, only use
approved engine oils and oil filters
required for vehicles with Maintenance
System (U.S. vehicles) or FSS (Canada
vehicles). For a listing of approved engine
oils and oil filters, refer to the Factory
Approved Service Products pamphlet, or
contact an authorized Mercedes-Benz
Center.
Using engine oils and oil filters of
specification other than those expressly
required for the Maintenance System
(U.S. vehicles) or FSS (Canada vehicles), or
changing of oil and oil filter at change
intervals longer than those called for by
the Maintenance System (U.S. vehicles) or
FSS (Canada Vehicles) will result in engine
damage not covered by the
Mercedes-Benz Limited Warranty.Please follow Maintenance System
(U.S. vehicles) or FSS (Canada vehicles)
recommendations for scheduled oil
changes. Failure to do so will result in
engine damage not covered by the
Mercedes-Benz Limited Warranty.
Engine oil additives
Do not blend oil additives with engine oil.
They may damage the engine.Damage or
malfunctions resulting from blending oil
additives are not covered by the
Mercedes-Benz Limited Warranty.Air conditioning refrigerant
R-134a (HFC) refrigerant and special PAG
lubricating oil is used in the air condition-
ing system.Never use R-12 (CFC) or miner-
al-based lubricating oil. Otherwise damage
to the system will occur.
Brake fluid
During vehicle operation, the boiling point
of the brake fluid is continuously reduced
through the absorption of moisture from
the atmosphere. Under extremely strenu-
ous operating conditions, this moisture
content can lead to the formation of bub-
bles in the system, thus reducing the sys-
tem’s efficiency.Therefore, the brake fluid
must be replaced every two years, prefera-
bly in the spring.Only brake fluid approved
by Mercedes-Benz is recommended. Your
authorized Mercedes-Benz Center will pro-
vide you with additional information.

432 Technical dataFuels, coolants, lubricants, etc.Premium unleaded gasoline
Fuel requirements
Use only premium unleaded fuel:

The octane number (posted at the
pu mp ) m ust b e 91 m i n. It is an a ve ra ge
of both the Research (R) octane num-
ber and the Motor (M) octane number:
(R+M)/2). This is also known as the
ANTI-KNOCK INDEX.
Unleaded gasoline containing oxygenates
such as Ethanol, IPA, IBA and TBA can be
used provided the ratio of any one of these
oxygenates to gasoline does not exceed
10%; MTBE must not exceed 15%.
The ratio of Methanol to gasoline must not
exceed 3% plus additional co-solvents.
Using mixtures of Ethanol and Methanol is
not allowed. Gasohol, which contains
10% Ethanol and 90% unleaded gasoline,
can be used.
These blends must also meet all other fuel
requirements, such as resistance to spark
knock, boiling range, vapor pressure, etc.
Gasoline additives
A major concern among engine manufac-
turers is carbon build-up caused by gaso-
line. Mercedes-Benz recommends only the
use of quality gasoline containing additives
that prevent the build-up of carbon depos-
its.
After an extended period of using fuels
without such additives, carbon deposits
can build up especially on the intake valves
and in the combustion area, leading to en-
gine performance problems such as:

Warm-up hesitation


Unstable idle


Knocking/pinging


Misfire


Power loss
!To maintain the engine’s durability and
performance, premium unleaded gaso-
line must be used. If premium unleaded
gasoline is not available and low octane
fuel is used, follow these precautions:

Have the fuel tank only partially
filled with unleaded regular and fill
up with premium unleaded as soon
as possible.


Avoid full throttle driving and abrupt
acceleration.


Do not exceed an engine speed of
3000 rpm if the vehicle is loaded
with a light load such as two
persons and no luggage.


Do not exceed 2/3 of maximum
accelerator pedal position if the ve-
hicle is fully loaded or operating in
mountainous terrain.

433 Technical data
Fuels, coolants, lubricants, etc.
In areas where carbon deposits may be en-
countered due to lack of availability of gas-
olines which contain these additives,
Mercedes-Benz recommends the use of
additives approved by us for use on
Mercedes-Benz vehicles. Refer to Factory
Approved Service Products Pamphlet for a
listing of approved product(s). Follow di-
rections on product label.
Do not blend any specific fuel additives
with fuel. This only results in unnecessary
cost and may be harmful to the engine op-
eration.
Damage or malfunction resulting from
poor fuel quality or from blending addition-
al fuel additives other than those tested
and approved by us for use on
Mercedes-Benz vehicles listed in the Fac-
tory Approved Service Products Pamphlet
are not covered by the Mercedes-Benz
Limited Warranty.
Coolants
The engine coolant is a mixture of water
and anticorrosion/antifreeze, which pro-
vides:

Corrosion protection


Freeze protection


Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -22°F (-30°C) and corro-
sion protection.
If the antifreeze mixture is effective to
-22°F (-30°C), the boiling point of the cool-
ant in the pressurized cooling system is
reached at approximately 266°F (130°C).The coolant solution must be used
year-round to provide the necessary corro-
sion protection and increase boil-over pro-
tection. Refer to Maintenance Booklet for
replacement interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification (see
Factory Approved Service Products pam-
phlet) are used to renew the coolant con-
centration or bring it back up to the proper
level.
To provide important corrosion protection,
the solution must be at least 45% anticor-
rosion/antifreeze [equivalent to freeze
protection to approximately - 22°F
(-30°C)]. If you use a solution that is more
than 55% anticorrosion/antifreeze [freeze
protection to approximately - 49°F
(-45°C)], the engine temperature will in-
crease due to the lower heat transfer capa-

439 Technical terms
Engine number
The number set by the manufacturer
and stamped on the cylinder block to
uniquely identify each engine pro-
duced.
Engine oil viscosity
Measurement for the inner friction (vis-
cosity) of the oil at different tempera-
tures. The higher the temperature an
oil can tolerate without becoming thin,
or the lower the temperature it can tol-
erate without becoming viscous, the
better the viscosity.
ESP
(E
lectronic S
tability P
rogram)
Improves vehicle handling and direc-
tional stability.ETD
(E
mergency T
ensioning D
evice)
Device which deploys in certain frontal
and rear collisions exceeding the sys-
tem's threshold to tighten the seat
belts.
->SRS
FSS (Canada vehicles)
(F
lexible S
ervice S
ystem)
Maintenance service indicator in the
multifunction display that informs the
driver when the next vehicle mainte-
nance service is due. FSS evaluates
engine temperature, oil level, vehicle
speed, engine speed, distance driven
and the time elapsed since your last
maintenance service, and calls for the
next maintenance service accordingly.
Gear range
Number of gears which are available to
the automatic transmission for shifting.
The automatic gear shifting process
can be adapted to specific operating
conditions using the selector lever.GPS
(G
lobal P
ositioning S
ystem)
Satellite-based system for relaying
geographic location information to and
from vehicles equipped with special re-
ceivers. Employs DVD digital maps for
navigation.
Instrument cluster
The displays and indicator/warning
lamps in the driver’s field of vision, in-
cluding the tachometer, speedometer,
engine temperature and fuel gauge.
KEYLESS-GO*
System for entering and operating the
vehicle without the use of a SmartKey.
Kickdown
Depressing the accelerator past the
point of resistance shifts the transmis-
sion down to the lowest possible gear.
This very quickly accelerates the vehi-
cle and should not be used for normal
acceleration needs.

443 Index
A
ABC 231, 437
Messages in display 349, 354
Setting vehicle level 230, 232
ABS 25, 80, 437
Malfunction indicator lamp 338
Messages in display 350
Warning lamp 338
Accelerator position, automatic
transmission 180
Accessory weight 322
Accident
In case of 54
Activating
Air conditioner (cooling) 203
Air conditioning 202
Air recirculation mode 199
Anti-theft alarm system 87
Central locking (control system) 168
Charcoal filter 200
Distance warning function* 226
Distronic* 222
Easy-entry/exit feature 170ESP 84
Exterior lamps 132
Exterior rear view mirror parking
position 187
Front and rear fog lamp 132, 134
Hazard warning flasher 136
Headlamps 50
High beams 135
Ignition 34
Ignition with KEYLESS-GO* start/stop
button 36
Immobilizer 57, 86
Limiting opening height of trunk
lid* 169
Manual shift program S 55 AMG 183
Rear window defroster 201
Residual heat 203
Seat heater 125, 126
Seat ventilation* 127
Tow-away alarm 89
Windshield wipers 52Adaptive Damping System (ADS) 229,
437
Adding
Coolant 293
Engine oil 291
Additional turn signals 390
Adjustable air vents, rear passenger
compartment 204
Adjusting 37
Air distribution 196
Air volume 198
Backrest tilt 38
Drive-dynamic seat* 172
Exterior rear view mirror 41
Head restraint height 39
Head restraint tilt 39
Instrument cluster illumination 140
Interior rear view mirror 41
Lumbar support 122
Mirrors 41
Multicontour backrest* 122
Power seat bench* 117
Seat cushion depth 38, 123

451 Index
Driving systems 214
ABC 231
AIRMATIC 229
Airmatic 229
Cruise control 214
Distronic* 217
Driving safety systems 80
Parktronic system* 235
Vehicle level control 230, 232
E
Easy-entry/exit feature 114
Activating 170
Electrical fuses 411
Electrical system 427
Electrically folding exterior rear view
mirrors 188
Electronic Stability Program see ESP 82,
439
Emergency call system* 255
Emergency calls
Initiating an emergency call 257
With Tele Aid 256
Emergency operation (Limp Home
Mode) 185Emergency operations
Closing the power tilt/sliding
sunroof 386
Locking the vehicle 384
Opening the power tilt/sliding
sunroof 386
Remote door unlock 262
Unlocking the vehicle 383
Emergency tensioning device see
ETD 69, 439
Emission control 282
Emission control information label 418
Ending
A call (telephone) 154
Engine 420
Compartment 286
Message in display 340, 341
Starting 46
Starting with KEYLESS-GO* 47
Starting with the SmartKey 46
Turning off with the SmartKey or the
SmartKey with KEYLESS-GO* 57
Engine cleaning 332
Engine compartment 286
Fuse box in 413
Hood 286Engine malfunction indicator lamp 340,
341
Engine number 418, 439
Engine oil 287
Adding 291
Additives 431
Checking level 287
Consumption 287
Display messages 362
Filler neck 291
Messages in display 289, 362
Viscosity 439
Engine oil level see Oil level 285
Entry position
Messages in display 364
ESP 82, 439
Four wheel electronic traction system
with ESP 85
Switching off 83
Switching on 84
Synchronizing 352
Warning lamp 342, 343
ETD 439
Safety guidelines 64
ETD (Emergency tensioning device) 69
Exterior lamp switch 131

458 IndexMP3-CD operation
Selecting tracks 150
Mph or km/h in speedometer 163
Multicontour backrest* 122
Multifunction display 143, 440
Selecting language 164
Standard display 147
Multifunction display messages
ABC 349, 354
ABS 350
BAS 351
Brake fluid 357
Brake pads 357
Check engine 340, 341
Coolant 359
Coolant level 358
Distronic* 351
Doors 361
Engine 340, 341
Engine oil level 362
Entry position 364Hood 364
Lamps 367
Parking brake 356
Selector lever 353
SmartKey 364
SmartKey with KEYLESS-GO* 364
TeleAid 370
Telephone* 370
Tires 372–378
Trunk 371
Washer fluid 371
Multifunction steering wheel 26, 144,
440
Buttons 144
N
Navigation system
Operating 155
See separate COMAND* operating in-
structions
Night security illumination 133
Normal occupant weight 323
Nubuck leather upholstery
Cleaning 336O
Occupant distribution 323
Occupant safety 60
Air bags 61
Children and air bags 62
Children in the vehicle 71
Fastening the seat belt 43
Infant and child restraint systems 71
LATCH child seat anchors 76
Seat belts 43, 64
Oil
Adding 291
Consumption 287
Dipstick 287
Filler neck 291
Viscosity 439
Oil level
Checking 285
Oil level via control system
Checking 288