2005 MERCEDES-BENZ E500 Dual

266 Controls in detailUseful features1Left cup holder
2Right cup holder
Removing cup holder
Take out the cup holder.
Using two fingers in the horizontal slot
at the upper rear side of the cup holder,
lift cup holder upwards to remove.Storage compartment with cup holder
in the center armrest
The storage compartment in the center
armrest contains a removable dual cup
holder.
Opening storage compartment
1Cover

Slide cover1 in direction of arrow2.
Cup holder in the center armrest3Dual cup holder
4Telephone* compartment
Closing storage compartment
Slide cover1 back.iThe cup holder can be removed to in-
crease storage space and for cleaning.
Clean the cup holder only with clear,
lukewarm water.
Make sure to insert the cup holder in
the guides when reinstalling it
(page 267).


311 Operation
Tires and wheels
Tires and wheels
See an authorized Mercedes-Benz Center
for information on tested and recommend-
ed rims and tires for summer and winter
operation. They can also offer advice con-
cerning tire service and purchase.
Retreaded tires are not tested or recom-
mended by Mercedes-Benz, since previous
damage cannot always be recognized on
retreads. Mercedes-Benz can therefore
not assure the operating safety of the vehi-
cle when such tires are used.
See an authorized Mercedes-Benz Center
for information on tested and recommend-
ed rims and tires for summer and winter
operation.
Important guidelines

Only use sets of tires and rims of the
same type and make.


Tires must be of the correct size for the
rim.


Break in new tires for approximately
60 miles (100 km) at moderate
speeds.


Regularly check the tires and rims for
damage. Dented or bent rims can
cause tire inflation pressure loss and
damage to the tire beads.


If vehicle is heavily loaded, check tire
inflation pressure and correct as re-
quired.


Do not allow your tires to wear down
too far. Adhesion properties on wet
roads are sharply reduced at tread
depths under
1/8in (3 mm).


When replacing individual tires, you
should mount new tires on the front
wheels first (on vehicles with
same-sized wheels all around).
Warning!
G
Replace rims or tires with the same designa-
tion, manufacturer and type as shown on the
original part. See an authorized
Mercedes-Benz Center for further informa-
tion. If incorrectly sized rims and tires are
mounted:

The wheel brakes or suspension compo-
nents can be damaged


The correct operating clearance of the
wheels and the tires are no longer guar-
anteed
Warning!
G
Worn, old tires can cause accidents. If the
tire tread is badly worn, or if the tires have
sustained damage, replace them.
When replacing rims, only use genuine
Mercedes-Benz wheel bolts specified for the
particular rim type. Failure to do so can re-
sult in the bolts loosening and possibly an
accident.

325 Operation
Tires and wheels

Press the æ button.
The following message will appear in
the multifunction display field:Tire pres. monitor

reactivated

The tire pressure monitoring system
will now monitor the tire inflation pres-
sure values of all four tires.
The following message will appear in
the multifunction display field:
Tire pressure

displayed only
after driving
a few mins. This display appears until the individual
inflation pressure values are matched
with the tires. The individual values are
then displayed (
page 396).If you wish to cancel activation:

Press the ç button.
If one of the following messages appears in
the multifunction display:


reactivate tire
pressure monitor
after rectifying
pressure


Tire pressure

Please rectify


Check the tire inflation pressures and
correct them if necessary.

Reactivate the tire pressure monitoring
system.
iAfter you have reactivated the tire
pressure monitoring system, the cur-
rent tire inflation pressure values will
only be shown after several minutes of
driving. During this time, the following
message appears in the display:Tire pressure

displayed only
after driving
a few mins. The time before the tire inflation pres-
sures are shown depends on whether
or not

you have mounted new tires


the old tires are still on the vehicle
If you have mounted new tires, it will
take slightly longer before the tire infla-
tion pressures are shown in the display.

339 Operation
Tires and wheels
TIN (T
ire I
dentification N
umber)
Unique identifier which facilitates efforts
by tire manufacturers to notify purchasers
in recall situations or other safety matters
concerning tires and gives purchases the
means to easily identify such tires. The TIN
is comprised of “Manufacturer's identifica-
tion mark”, “Tire size”, “Tire type code”
and “Date of manufacture”.
Tire load rating
Numerical code associated with the
maximum load a tire can support.
Tire ply composition and material used
This indicates the number of plies or the
number of layers of rubber-coated fabric in
the tire tread and sidewall. Tire manufac-
turers also must indicate the ply materials
in the tire and sidewall, which include
steel, nylon, polyester, and others.Tire speed rating
Part of tire designation; indicates the
speed range for which a tire is approved.
Traction
Force exerted by the vehicle on the road
via the tires. The amount of grip provided.
Tread
The portion of a tire that comes into
contact with the road.
Treadwear indicators
Narrow bands, sometimes called
“wear bars” that show across the tread of
a tire when only
1/6in (1.6 mm) of tread
remains.Uniform Tire Quality Grading Standards
A tire information system that provides
consumers with ratings for a tire's traction,
temperature and treadwear. Ratings are
determined by tire manufacturers using
government testing procedures. The
ratings are molded into the sidewall of the
tire.
Vehicle capacity weight
Rated cargo and luggage load plus
68 kilograms (150 lbs) times the vehicle's
designated seating capacity.
Vehicle maximum load on the tire
Load on an individual tire that is
determined by distributing to each axle its
share of the maximum loaded vehicle
weight and dividing it by two.

365 Practical hints
What to do if …
Lamp in center consoleProblem
Possible cause
Suggested solution
75The indicator lamp illuminates and remains
illuminated with the weight of a typical adult
or someone larger than a small individual on
the front passenger seat.
The system is malfunctioning.

Have the system checked as soon as
possible by an authorized
Mercedes-Benz Center.

Also note any messages in the
multifunction display and follow cor-
rective steps (
page 374).
Warning!
G
If the
75
indicator lamp illumi-
nates and remains illuminated with the
weight of a typical adult or someone larger
than a small individual on the front passen-
ger seat, do not have any passenger use the
front passenger seat until the system has
been repaired.

374 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause
Possible solution
Front passenger
airbag activated
See Operator’s Manual
Air bag is activated while
driving even though a child,
small individual, or object
below the system's weight
threshold is on the front
passenger seat, or the
front passenger seat is
empty. Objects on the seat
or forces acting on the seat
may make the system
sense supplemental
weight.
Stop the vehicle in a safe location as soon as possible
and check the following:
Make sure that there is nothing between seat cush-
ion and child seat and check installation of the child
seat.

Make sure that no objects applying supplemental
weight onto the seat are present.

Make sure that no objects which apply forces to the
seat are present (e.g. objects such as books, brief-
cases etc. lodged behind or around the seat, head
restraints pushing against roof etc.). The system
may recognize such forces as supplemental weight
and sense that an occupant on the front passenger
seat is of a heavier weight than actually present.
(Continued on next page)

375 Practical hints
What to do if …
Display symbol
Display messages
Possible cause
Possible solution
Front passenger
airbag activated
See Operator’s Manual
If performing any of the above corrective steps is suc-
cessful, the message
Front passenger airbag deacti-
vated
will appear in the multifunction display,
confirming the situation has been remedied. Note that
after performing the corrective steps, it may take up to
60 seconds for the message
Front passenger airbag
deactivated
to appear.
If the message
Front passenger airbag activated

remains on in the multifunction display and/or the
75 indicator lamp remains out even after per-
forming the above corrective steps, have the system
checked as soon as possible by an authorized
Mercedes-Benz Center.
Warning!
G
If the message
Front passenger airbag
activated
remains on in the multifunction
display and/or the
75
indicator
lamp remains out even after performing the
above corrective steps, do not have any
children12 years old and under and other
small individuals use the front passenger
seat until the system has been repaired.

376 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause
Possible solution
Front passenger
airbag deactivated
See Operator’s Manual
Air bag is deactivated while
driving even though an
adult or someone larger
than a small individual is
occupying the front pas-
senger seat. Forces acting
on the seat may make the
system sense a decrease
in weight.
Stop the vehicle in a safe location as soon as possible
and check the following:
Do not lean on armrests or lift yourself up using han-
dle over the door.

Adjust the seat in a height position (
page 38).

Make sure that no objects which apply forces to the
seat are present (e.g. objects such as books, brief-
cases etc. lodged underneath, behind or around the
seat). Such forces may cause the system to sense
that an occupant of a lesser weight than actually
present is on the front passenger seat.

Re-position yourself.

Sit properly belted in a nearly upright position with
your back against the seat backrest.
If performing any of the above corrective steps is
successful, the message
Front passenger airbag
activated
will appear in the multifunction display,
confirming the situation has been remedied.
(Continued on next page)