Page 303 of 498

301 Operation
Driving instructions
Winter driving instructions
The most important rule for slippery or icy 
roads is to drive sensibly and to avoid 
abrupt acceleration, braking and steering 
maneuvers. Do not use the cruise control 
system under such conditions.
When the vehicle is in danger of skidding, 
move gear selector lever to position N. Try 
to keep the vehicle under control by cor-
rective steering action.Road salts and chemicals can adversely af-
fect braking efficiency. Increased pedal 
force may become necessary to produce 
the normal braking effect.
Depressing the brake pedal periodically 
when traveling at length on salt-strewn 
roads can bring road-salt-impaired braking 
efficiency back to normal.
If the vehicle is parked after being driven 
on salt-treated roads, the braking efficien-
cy should be tested as soon as possible af-
ter driving is resumed.
For more information, see “Winter driving” 
(
page 342).
iFor information on driving with snow 
chains, see “Snow chains” 
(page 343).
Warning!
G
On slippery road surfaces, never downshift 
in order to obtain braking action. This could 
result in drive wheel slip and reduced vehi-
cle control. Your vehicle’s ABS will not pre-
vent this type of control loss.
Warning
G
Make sure not to endanger any other road 
users when carrying out these braking ma-
neuvers.
Warning!
G
If the vehicle becomes stuck in snow, make 
sure snow is kept clear of the exhaust pipe 
and from around the vehicle with the engine 
running. Otherwise, deadly carbon monox-
ide (CO) gases may enter vehicle interior re-
sulting in unconsciousness and death.
To assure sufficient fresh air ventilation, 
open a window slightly on the side of the ve-
hicle not facing the wind.Warning!
G
The outside temperature indicator is not de-
signed to serve as an ice-warning device and 
is therefore unsuitable for that purpose. In-
dicated temperatures just above the freez-
ing point do not guarantee that the road 
surface is free of ice. 
     
        
        Page 305 of 498

303 Operation
Driving instructions
Telephones* and two-way radios
Radio transmitters, such as a portable tele-
phone or a citizens band unit should only 
be used inside the vehicle if they are con-
nected to an antenna that is installed on 
the outside of the vehicle.
Refer to the radio transmitter operation in-
structions regarding use of an external 
antenna.
Catalytic converter
Your Mercedes-Benz is equipped with 
monolithic-type catalytic converters, an 
important element in conjunction with the 
oxygen sensors to achieve substantial con-
trol of the pollutants in the exhaust emis-
sions. Keep your vehicle in proper 
operating condition by following our 
recommended maintenance instructions 
as outlined in your Maintenance Booklet.
Warning!
G
Never operate radio transmitters equipped 
with a built-in or attached antenna (i.e. with-
out being connected to an external antenna) 
from inside the vehicle while the engine is 
running. Doing so could lead to a malfunc-
tion of the vehicle’s electronic system, pos-
sibly resulting in an accident and/or serious 
personal injury.
!To prevent damage to the catalytic 
converters, only use premium unleaded 
gasoline in this vehicle.
Any noticeable irregularities in engine 
operation should be repaired promptly. 
Otherwise, excessive unburned fuel 
may reach the catalytic converter, 
causing it to overheat and potentially 
start a fire.
Warning!
G
As with any vehicle, do not idle, park or op-
erate this vehicle in areas where combusti-
ble materials such as grass, hay, or leaves 
can come into contact with the hot exhaust 
system, as these materials could be ignited 
and cause a vehicle fire. 
     
        
        Page 407 of 498

405 Practical hints
Replacing bulbs
Rear lamps
Notes on bulb replacement
Only use 12 volt bulbs of the same type 
and with the specified watt rating. 
Switch lights off before changing a bulb 
to prevent short circuits. 
Always use a clean lint-free cloth when 
handling bulbs. 
Your hands should be dry and free of oil 
and grease.
If the newly installed bulb does not 
come on, visit an authorized 
Mercedes-Benz Center.
Have the LEDs and bulbs for the follow-
ing lamps replaced by an authorized 
Mercedes-Benz Center.
Additional turn signal lamps in the 
exterior rear view mirrors
High mounted brake lamp
Bi-Xenon* lamps
Front fog lamps
Lamp
Type
7
High mounted brake 
lamp
LED
8
Brake lamp
P 21 W
9
Turn signal lamp
P 21 W
a
Tail, parking and stand-
ing lamp, side marker
P 21/4 W
W 5 W
b
Backup lamp
P 21 W
c
License plate lamps
C 5 W
d
Rear fog lamp, driver’s 
side
P 21/4 W 
Warning!
G
Keep bulbs out of reach of children.
Bulbs and bulb sockets can be very hot. Al-
low the lamp to cool down before changing 
a bulb.
Halogen lamps contain pressurized gas. A 
bulb can explode if you:
touch or move it when hot
drop the bulb
scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is 
dangerous to replace the bulb or repair the 
lamp and its components. We recommend 
that you have such work done by a qualified 
technician.
iHave the headlamp adjustment 
checked regularly.