
302 Practical hintsWhat to do if …Lamps in instrument clusterGeneral information:
If a bulb in the instrument cluster fails to
come on during the bulb self-check when switching on ignition, have it checked and
replaced if necessary.Problem
Possible cause
Suggested solution
-
The yellow ABS malfunction
indicator lamp comes on while
driving.
The ABS has detected a malfunction and has
switched off. The BAS and the ESP are also
switched off (see messages in display).
The brake system is still functioning normally
but without the ABS available.
If the ABS control unit is malfunctioning,
other systems such as the navigation
system* or the automatic transmission* may
also be malfunctioning.
Continue driving with added caution.
Wheels may lock during hard braking,
reducing steering capability.
Read and observe messages in the
display (
page 309).
Have the system checked at an autho-
rized Mercedes-Benz Center as soon
as possible.
Failure to follow these instructions
increases the risk of an accident.
The charging voltage has fallen below ten
volts. The ABS has switched off.
The battery might not be charged sufficiently.
Switch off electrical consumers that
are currently not needed, e.g. seat
heating*.
If necessary, have the generator
(alternator) and battery checked.
When the voltage is above this value
again, the ABS is operational again.

304 Practical hintsWhat to do if …Problem
Possible cause
Suggested solution
ú
(USA only)
±
(Canada only)
The yellow engine malfunction
indicator lamp comes on while
driving.
There is a malfunction in:
The fuel management
system
The ignition system
The emission control
system
Systems which affect
emissions
Such malfunctions may result
in excessive emissions values
and may switch the engine to
its limp-home (emergency
operation) mode.
Have the vehicle checked as soon as
possible by an authorized
Mercedes-Benz Center.
An on-board diagnostic connector is
used by the service station to link the
vehicle to the shop diagnostics sys-
tem. It allows the accurate identifica-
tion of system malfunctions through
the readout of diagnostic trouble
codes. It is located in the front left
area of the footwell next to the
parking brake pedal.

309 Practical hints
What to do if …
Vehicle status messages in the multifunction display
Warning and malfunction messages
appear in the multifunction display located
in the instrument cluster.
Certain warning and malfunction messag-
es are accompanied by an audible signal.
Address these messages accordingly and
follow the additional instructions given in
this Operator’s Manual.
Selecting the vehicle status message
memory menu in the control system
(page 130) displays both cleared and
uncleared messages.
High-priority messages appear in the
multifunction display in red color.
Certain messages of high priority cannot
be cleared from the multifunction display
using the reset button (
page 117).Other messages of high priority and
messages of less immediate priority can
be cleared from the multifunction display
using the reset button (
page 117). They
are then stored in the vehicle status mes-
sage memory (
page 130). Remember
that clearing a message will only make the
message disappear. Clearing a message
will not correct the condition that caused
the message to appear.
On the pages that follow, you will find a
compilation of the most important warning
and malfunction messages that may
appear in the multifunction display. High
priority messages appear in red color.
Warning!
G
All categories of messages contain
important information which should be
taken note of and, where a malfunction is
indicated, addressed as soon as possible at
an authorized Mercedes-Benz Center.
Failure to repair condition noted may cause
damage not covered by the Mercedes-Benz
Limited Warranty, or result in property
damage or personal injury.
Warning!
G
No messages will be displayed if either the
instrument cluster or the multifunction
display is inoperative.
Contact your nearest authorized
Mercedes-Benz Center.iSwitching on ignition, causes all lamps
as well as the multifunction display to
come on. Make sure that they are all in
working order before starting your jour-
ney.

366 Practical hintsTowing the vehicle
!
To be certain to avoid a possibility of
damage to the drivetrain, however, we
recommend the drive shaft be discon-
nected at the rear axle drive flange
(vehicles with 4MATIC: disconnected at
the front and rear axle drive flanges) for
any towing beyond a short tow to a
nearby garage.
Warning!
G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:
the engine will not run
there is a malfunction in the power
supply or in the vehicle’s electrical
system
as that will be necessary to adequately
control the towed vehicle.
Prior to towing the vehicle with all wheels on
the ground, make sure the SmartKey is in
starter switch position2.
If the SmartKey is left in starter switch
position0 for an extended period of time, it
can no longer be turned in the switch. In this
case, the steering is locked. To unlock,
remove SmartKey from starter switch and
reinsert.
iTo signal turns while being towed with
the hazard warning flasher in use,
switch on ignition and activate the
combination switch for the left or right
turn signal in the usual manner – only
the selected turn signal will operate.
Upon canceling the turn signal, the
hazard warning flasher will operate
again.

393 Technical data
Fuels, coolants, lubricants, etc.
Switching fuels
For best performance and driveability it is
recommended to use either one or the
other fuel. A refueling pattern that
alternates between the two different fuels
should be avoided if possible.
When switching fuels, make sure:
Fuel level is below half full.
Fuel level is above reserve (fuel reserve
warning lamp is not lit).
Amount of added fuel is more than
5 gallons (20 liters).
Ignition is off during refill.
Immediately after refueling engine is
started and operated for at least five
minutes.
These precautions and recommendations
are supposed to prevent any difficulties
when starting and operating the engine
which otherwise may be experienced
before the engine has fully adapted to the
different fuel. If in spite of these recommendations the
engine does not perform properly, adding
more gasoline [at least 3 gallons
(12 liters)] to the fuel may improve the
engine behavior.
Cold weather performance
It is possible that starting times will signif-
icantly increase at temperatures
below 32°F (0°C). At low temperatures
the use of a block heater (Canada only) is
recommended (see an authorized
Mercedes-Benz Center for further
information). Rough idling may also be
experienced at such temperatures before
the engine is fully warmed up.Hot weather performance
At ambient temperatures above 95°F
(35°C) start times may increase and be
accompanied by a rough idle following the
start.
Cruising range
E85 fuel contains less energy per gallon
than gasoline. To make sure that engine
performance with Ethanol fuel is similar to
that when using gasoline, the engine must
burn more Ethanol fuel. As a result, it is to
be expected that the fuel consumption will
increase when using E85 compared to
gasoline operation.
Maintenance
Please inform your Mercedes-Benz Center
if you use or have used E85 fuel when your
vehicle is delivered for maintenance or
repairs.
!E85 fuel is unsuitable for use when
ambient temperatures fall below 14°F
(-10°C).
iUse of E85 may reduce your driving
range.

405 Index
A
ABS 77, 399
ABS control 77
Indicator lamp 25
Malfunction indicator lamp 302
Messages in display 310
Accelerator position,
automatic transmission* 163
Accident
In case of 53
Activating
Air conditioning (cooling) 181
Air recirculation mode 179
Anti-theft alarm system* 84
Central locking (control system) 145
Climate control 175
Climate control system 177
Defrosting 178
Easy-entry/exit feature* 146
Electric air pump 358
ESP 81Exterior headlamps 49
Exterior lamps 110
Exterior rear view mirror
parking position* 170
Hazard warning flasher 114
Headlamps 49
High beam headlamps 50
High beams 113
Ignition 33
Immobilizer 56, 83
Low beam headlamps 49
Manual shift program
(C 55 AMG only) 166
Rear window defroster 173
Seat heating* 105
Tow-away alarm* 85
Windshield wipers 51
Adding
Coolant 283
Engine oil 281
Additional turn signals 345
Adjustable air vents,
rear passenger compartment 182Adjusting 35
Air distribution 178
Air volume 178
Backrest contour 104
Backrest side bolsters 104
Backrest tilt, manual seat 36
Backrest tilt, power seat* 38
Exterior rear view mirrors 41
Folding back rear seat
head restraints, electrical 102
Folding back rear seat
head restraints, manual 102
Head restraint height,
manual seat 37
Head restraint height,
power seat* 38
Head restraint height, rear seats 101
Head restraint tilt, manual seat 37
Head restraint tilt, power seat* 39
Head restraint tilt, rear seats 103
Instrument cluster illumination 117
Interior rear view mirror 41
Manual seat 36
Mirrors 41

418 IndexIgnition 33
Switching on,
automatic transmission* 47
Switching on,
manual transmission 46
Immobilizer 83
Activating 83
Deactivating 83
Indicator lamps see
Lamps, indicator and warning
Infant and child restraint systems 67
Installing 72
LATCH-type child seat anchors 73
Information
About service and warranty 10
Inside door handle 92
Installing
Infant and child restraint systems 72
Ski sack* (Canada only) 237
Towing eye bolt 368
Wiper blades 352Instrument cluster 24, 117, 401
Cleaning 298
Coolant temperature gauge 118
Illumination 117
Lamps in 302–307
Multifunction display 121
Outside temperature indicator 119
Selecting language 136
Instrument lighting 117
Instruments and controls see Cockpit
Interior lighting 115
Activating automatic control 115
Deactivating automatic control 115
Delayed shut-off 145
Manual operation 115
Interior rear view mirror
Adjusting 41
Antiglare 168Interior storage spaces 241
Armrest 242
Cup holder in rear seat armrest 244
Cup holders in front of
seat armrest 243
Glove box 241
Parcel net in
front passenger footwell 245
Intermittent wiping 52
J
Jack 329
Jump starting 363
K
Key 191
Key dependency memory
Settings 147
Key positions in starter switch 33
Key, mechanical 337