271
Controls in detail
Useful features
Programming or reprogramming the in-
tegrated remote control
Step 1:
Switch on the ignition (
page 33).
Step 2:
If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise, press
and hold the two outer signal transmit-
ter buttons 2 and 4 and release
them only when the indicator lamp 1
begins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and/or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3. Step 3:
Hold the end of the hand-held remote
control transmitter
6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping the indicator lamp 1 in view.
Step 4:
Using both hands, simultaneously
press the hand-held transmitter
button 5 and the desired integrated
signal transmitter button (2 , 3
or 4 ). Do not release the buttons until
completing step 5.
The indicator lamp 1 on the integrat-
ed remote control will flash, first slowly
and then rapidly.
iCanada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions:
(1) This device may not cause interfer- ence, and
(2) this device must accept any inter- ference received, including interfer-
ence that may cause undesired
operation of the device.
Any unauthorized modification to this
device could void the user’s authority
to operate the equipment.
454 IndexInstrument cluster 24, 119, 439Cleaning 337
Coolant temperature display 120
Illumination 119
Lamps in 343–344
Multifunction display 123
Outside temperature indicator 121
Selecting language 138
Instrument lighting 119
Instruments and controls see Cockpit
Interior lighting 117 Activating automatic control 117
Deactivating automatic control 117
Delayed shut-off (Control system) 147
Manual operation 118
Interior rear view mirror Adjusting 42
Antiglare (manual) 167
Interior storage spaces Armrest 255
Cup holders 256
Intermittent wiping 54 J
Jack 373
Jump starting 404
K
Key dependency memory
Settings 149
Key positions in starter switch 33
Key, mechanical 377
Key, SmartKey Battery check lamp 92
Checking the batteries 93
Factory setting 92
Global locking 92
Global unlocking 92
Loss of 94
Messages in display 365
Positions in starter switch 33
Remote control 90
Restoring to factory setting 93
Selective setting 92
Starting the engine 48, 49
Unlocking with 32
Kickdown 165, 439
Kilometers/miles in speedometer 137
Kilopascal 324
Km/h or mph in speedometer 137 L
Labels, identification 416
Lamp bulbs, exterior 384
Lamps, exterior
Front 385
Light sensor 367
Messages in display 366–370
Rear 385
Lamps, indicator and warning ABS 340
Air bag Off 66
Battery (SmartKey) 92
Brake 25
Brakes 341
CHECK ENGINE 342
Engine diagnostics 342, 344
ESP 343
Fuel reserve 344
Instrument cluster 343–344
Low beam 25
Seat belts 344
Service indicator 330
SRS 61, 344
Language Multifunction display 138
Setting 138
