2005 MAZDA MODEL TRIBUTE audio

[x] Cancel search: audio

Page 13 of 272

MAZDA MODEL TRIBUTE 2005  Owners Manual (in English) Passenger airbag off
indicator
(pg. 97)Hazard flasher control
(pg. 183)Audio system
(pg. 21)
Cigarette lighter*
Fog lamp control*
(pg. 33)Climate controls
(pg. 31)
Rear window defroster
control
(pg. 3

Page 21 of 272

MAZDA MODEL TRIBUTE 2005  Owners Manual (in English) AM/FM STEREO SINGLE CD AUDIO SYSTEM — SATELLITE
READY CAPABILITY
1.CD:To begin CD play, insert a
CD into the slot, label side up.
The system will auto-load the
CD and begin play after a short
pause.

Page 22 of 272

MAZDA MODEL TRIBUTE 2005  Owners Manual (in English) 3.CLOCK:Press and release
CLOCK to alternate between
the time and the audio display.
The clock can be set at any
time when the ignition switch is
in the ACC or ON position.
Press and hold CLOCK for ap

Page 24 of 272

MAZDA MODEL TRIBUTE 2005  Owners Manual (in English) 11.DISC: Press to skip forward
to the beginning of the next CD.
12.DISC
Press to skip back to
the beginning of the previous
CD.
13.Volume/ON/OFF:Press to turn
the system on/off. Turn to
adjust the vol

Page 25 of 272

MAZDA MODEL TRIBUTE 2005  Owners Manual (in English) 17.SAT:Your radio comes equipped with Satellite ready capability. This
enables you to view the song titles, artist, and further information.
The kit to enable Satellite reception is available through

Page 26 of 272

MAZDA MODEL TRIBUTE 2005  Owners Manual (in English) 3.CLOCK:Press and release
CLOCK to alternate between
the time and the audio display.
The clock can be set at any
time when the ignition switch is
in the ACC or ON position.
Press and hold CLOCK for ap

Page 28 of 272

MAZDA MODEL TRIBUTE 2005  Owners Manual (in English) 10.RPT:Press during CD play to
listen to a selection repeatedly.
RPT will illuminate in the
display and the current
selection will be repeated. Press
again to disengage repeat play.
11.DISC
: Press to

Page 30 of 272

MAZDA MODEL TRIBUTE 2005  Owners Manual (in English) •Tighten very loose tapes by inserting a finger or pencil into the hole
and turning the hub.
•Remove loose labels before inserting tapes.
•Allow tapes which have been subjected to extreme heat,