Page 217 of 364

Black plate (217,1)
NOTE
lCheck the tire inflation pressure label
(driver's door) for the correct tire
inflation pressure.
lDo not use the compressor for longer
than 10 minutes because using the
compressor for long periods could
damage it.
lIf the tire does not inflate, repair of
the tire may not be possible. If the
tire does not reach the correct
inflation pressure within a 10-minute
period, it probably has received more
extensive damage. When this
happens, the emergency flat tire
repair kit cannot be used to repair the
tire. Contact an Authorized Mazda
Dealer.
lIf the tire has been over-inflated,
loosen the screw cap on the
compressor and bleed some of the air
out.
17. When the tire has been inflated to the
proper inflation pressure, turn the
compressor switch off and remove the
compressor hose from the tire valve.
18. Install the tire valve cap.
19. Put the emergency flat tire repair kit
in the trunk and continue driving.
CAUTION
lDrive carefully to an Authorized
Mazda Dealer and keep the vehicle
speed below 80 km/h (50 mph).
lIf the vehicle is driven 80 km/h (50
mph) or higher, the vehicle might
begin to vibrate.
NOTE
(With Tire Pressure Monitoring
System)
If the tire is not properly inflated, the
tire pressure monitoring system warning
light will illuminate (page 5-26).
20. After driving the vehicle for 10
minutes or 5 km (3 miles), check the
tire pressure with the tire pressure
gauge equipped with the compressor.
If the tire pressure has fallen below
the correct tire pressure, inflate the
tire to the correct pressure again
following the steps from number 15.
CAUTION
lIf the tire inflation pressure falls
below 130 kPa (1.3 kgf/cm2or bar,
18.9 psi), repair cannot be done with
the repair kit. Park the vehicle on a
level surface off the right-of-way and
contact an Authorized Mazda Dealer.
lIf the tire inflation pressure
continues to remain low after
repeating steps 14 to 21, park the
vehicle on a level surface off the
right-of-way and contact an
Authorized Mazda Dealer.
NOTE
When checking the tire inflation
pressure with the tire pressure gauge on
the compressor unit, make sure the
compressor switch is turned off.
In Case of an Emergency
Flat Tire
7-11
RX-8_8T69-EA-04G_Edition1 Page217
Wednesday, June 9 2004 2:12 PM
Form No.8T69-EA-04G
Page 232 of 364
Black plate (232,1)
Tiedown Hooks
CAUTION
Don't use the tiedown hooks under the
front and rear for towing.
They are designed ONLY for tying
down the vehicle when it's being
transported. Using them for towing will
damage the bumper.
qTiedown Hooks
1. Remove the tiedown eyelet and the lug
wrench from the trunk (page 7-3).
2. Wrap the lug wrench with a soft cloth
to prevent damage to the bumper and
open the cap located on the front and
rear bumper.
Front
Rear
CAUTION
The cap cannot be completely removed.
Do not use excessive force as it may
damage the cap or scratch the painted
bumper surface.
3. Securely install the tiedown eyelet
using the lug wrench.
Front
Rear
7-26
In Case of an Emergency
Emergency Towing
RX-8_8T69-EA-04G_Edition1 Page232
Wednesday, June 9 2004 2:12 PM
Form No.8T69-EA-04G
Page 267 of 364
Black plate (267,1)
Light Bulbs
Headlights (High-beam)Front side-marker lights
Front turn signal lights
Headlights (Low-beam)
Fog lights
Parking lights Overhead light/Map lights (Front)
Vanity mirror lights
Courtesy lights
Overhead light (Rear)
Trunk light
High-mount brake light
License plate light
Brake lights/Taillights
Reverse lights
Rear side-marker lights
Rear turn signal lights
Some models.
Maintenance and Care
Owner Maintenance
8-33
RX-8_8T69-EA-04G_Edition1 Page267
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 272 of 364

Black plate (272,1)
Vanity mirror lights
Edge
3. Install the new bulb in the reverse order
of removal.
Trunk light
1. Press both sides of the lens cap to
remove it.
2. Disconnect the bulb by pulling it out.
3. Install the new bulb in the reverse order
of removal.
qReplacing a Bulb (Rear)
Rear turn signal lights, Brake lights/
Taillights, Reverse lights
1. Pull the center section of the plastic
retainer and remove the retainers and
partially open the trunk side trim.
Removal
Installation
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
Brake lights/Taillights Rear turn signal lights
Reverse lights
4. Install the new bulb in the reverse order
of removal.
Rear side-marker lights
Due to the complexity and difficulty of
the procedure, the bulbs should be
replaced by an Authorized Mazda Dealer.
8-38
Maintenance and Care
Owner Maintenance
RX-8_8T69-EA-04G_Edition1 Page272
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 273 of 364
Black plate (273,1)
High-mount brake light
1. Turn the center section of the plastic
retainer counterclockwise and remove
the retainers and trunk rear trim.
Removal
Installation
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order
of removal.
License plate light
1. Press the front of the lens to detach the
front tabs.2. Wrap a flathead screwdriver with a soft
cloth to prevent damage to the lens and
remove the lens by carefully prying on
the edge of the lens with a flathead
screwdriver.
3. Disconnect the bulb by pulling it out.
Edge
4. Install the new bulb in the reverse order
of removal.
Maintenance and Care
Owner Maintenance
8-39
RX-8_8T69-EA-04G_Edition1 Page273
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 312 of 364

Black plate (312,1)
qLight Bulbs
Exterior light
Light bulbCategory
Wattage ECE R SAE
HeadlightsHigh beam 65 H9―
Low beamHalogen 55 H7―
Xenon fusion 35 D2S―
Front turn signal lights 21 WY21W―
Parking lights 5 W5W―
Fog lights
í55 H11―
Front side-marker lights 3.8―#194
High-mount brake light 21 W21W #7440
Rear turn signal lights 21 WY21W―
Brake lights/Taillights 21/5 W21/5W #7443
Reverse lights 21 W21W #7440
License plate light 5 W5W―
Rear side-marker lights 0.57――
The rear side-marker light bulbs cannot be replaced because they are an LED-type bulb. The rear combination
component must be replaced.
Interior light
Light bulbCategory
Wattage ECE R
Trunk light 5 W5W
Overhead light/Map lights (Front) 5 W5W
Overhead light (Rear) 10―
Courtesy lights 5 W5W
Vanity mirror lights 1.8―
qTires
NOTE
The tires have been optimally matched with the chassis of your vehicle.
When replacing tires, Mazda recommends that you replace tires of the same type
originally fitted to your vehicle. For details, contact an Authorized Mazda Dealer.
10-6íSome models.
Specifications
RX-8_8T69-EA-04G_Edition1 Page312
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 320 of 364

Black plate (320,1)
S
Steering Wheel .................................. 3-29
Horn ........................................... 5-55
Storage Box ...................................... 6-48
Storage Compartments ...................... 6-47
Center console ............................ 6-48
Coin box ..................................... 6-47
Glove box ................................... 6-47
Overhead console ....................... 6-47
Storage box ................................ 6-48
Sunshade ........................................... 3-23
Sunvisors .......................................... 6-39
T
Tachometer ........................................ 5-32
Temporary Spare Tire ....................... 8-31
Theft-Deterrent System ..................... 3-27
Tiedown
Hook .......................................... 7-26
Tire Pressure Monitoring System ...... 5-25
System error activation .............. 5-27
Tire pressure monitoring system
warning light .............................. 5-26
Tires and wheels ......................... 5-28
Tires
Flat tire ......................................... 7-3
Inflation pressure ........................ 8-28
Replacement ............................... 8-30
Rotation ...................................... 8-29
Snow tires .................................... 4-9
Spare tire and tool storage ............ 7-3
Specifications ............................. 10-6
Tire chains .................................. 4-10
Uniform tire quality grading system
(UTQGS) ................................... 9-16
Tool ..................................................... 7-3
T
Towing
Description ................................. 7-25
Emergency towing ..................... 7-25
Recreational towing ................... 7-27
Trailer towing ............................. 4-12
Traction Control System (TCS) ........ 5-21
TCS/DSC indicator light ............ 5-22
Trailer Towing .................................. 4-12
Trip Meter ......................................... 5-31
Trunk Lid .......................................... 3-12
Trunk Light ....................................... 3-14
Trunk Release Slide Lever ................ 3-15
Turn and Lane-Change Signals ......... 5-51
V
Vanity Mirrors ................................... 6-39
Vehicle Information Labels ............... 10-2
W
Warning Lights ................................. 5-36
ABS ............................................ 5-41
Air bag system ........................... 5-41
Automatic transmission .............. 5-42
Brake system .............................. 5-38
Charging system ......................... 5-39
Check engine .............................. 5-40
Door-ajar .................................... 5-42
Engine coolant level ................... 5-40
Engine oil level .......................... 5-39
Front seat belt pretensioner
system ........................................ 5-41
Low fuel ..................................... 5-42
Low washer fluid level ............... 5-42
Seat belt ...................................... 5-42
Tire pressure monitoring
system ........................................ 5-43
11-6
Index
RX-8_8T69-EA-04G_Edition1 Page320
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page:
< prev 1-8 9-16 17-24