2005 MAZDA MODEL MX-5 coolant temperature

Black plate (110,1)
Meters and Gauges
Speedometer ...................................................................................................... page 5-19
Odometer, Trip Meter and Selector .................................................................... page 5-19
Tachometer ........................................................................................................ page 5-20
Engine Coolant Temperature Gauge .................................................................. page 5-20
Fuel Gauge ........................................................................................................ page 5-20
Engine Oil Pressure Gauge ................................................................................ page 5-21
5-18
Driving Your Mazda
Instrument Cluster and Indicators
MX-5 Miata_8T72-EA-04G_Edition1 Page110
Wednesday, June 9 2004 3:4 PM
Form No.8T72-EA-04G

Black plate (112,1)
qTachometer
The tachometer shows engine speed in
thousands of revolutions per minute
(rpm).
Red zone
CAUTION
Don't run the engine with the
tachometer needle in the RED ZONE.
This may cause severe engine damage.
qEngine Coolant Temperature
Gauge
The engine coolant temperature gauge
shows the temperature of the engine
coolant.
If the needle exceeds normal range toward
H, it indicates overheating.
CAUTION
Driving with an overheated engine can
cause serious engine damage (page
7-11).
qFuel Gauge
The fuel gauge shows approximately how
much fuel is in the tank. We recommend
keeping the tank over 1/4 full. When the
low fuel warning light illuminates or
when the needle is near E, refuel as soon
as possible.
5-20
Driving Your Mazda
Instrument Cluster and Indicators
MX-5 Miata_8T72-EA-04G_Edition1 Page112
Wednesday, June 9 2004 3:5 PM
Form No.8T72-EA-04G

Black plate (209,1)
Overheating
If the temperature gauge indicates
overheating, the vehicle loses power, or
you hear a loud knocking or pinging
noise, the engine is probably too hot.
WARNING
Cooling Fan and Engine
Inspection:
Inspecting the engine with the ignition
switch in the ON position is
dangerous. The cooling fan could turn
on unexpectedly even when the engine
isn't running. You could be seriously
injured by the fan. Turn the ignition
switch off and remove the key from the
ignition switch when you inspect the
engine.
Cooling System Cap:
When the engine and radiator are hot,
scalding coolant and steam may shoot
out under pressure and cause serious
injury. Don't remove the cooling
system cap when the engine and
radiator are hot.
Steam from Overheated Engine:
Steam from an overheated engine is
dangerous. The escaping steam could
seriously burn you. Open the hood
ONLY after steam is no longer
escaping from the engine.If the temperature gauge indicates
overheating:
1. Drive safely to the side of the road and
park off the right-of-way.
2. Put a vehicle with an automatic
transmission in park (P), a manual
transmission in neutral.
Apply the parking brake.
3. Turn off the air conditioner.
4. Check whether coolant or steam is
escaping from under the hood or from
the engine compartment.
If steam is coming from the engine
compartment:
Don't go near the front of the vehicle.
Stop the engine.
Wait until the steam dissipates, then
open the hood and start the engine.
If neither coolant nor steam is
escaping:
Open the hood and idle the engine until
it cools.
CAUTION
If the cooling fan does not operate
while the engine is running, the engine
temperature will increase. Stop the
engine and call an Authorized Mazda
Dealer.
5. Make sure the cooling fan is operating,
then turn off the engine after the
temperature has decreased.
6. When cool, check the coolant level.
If it's low, look for coolant leaks from
the radiator and hoses.
In Case of an Emergency
Overheating
7-11
MX-5 Miata_8T72-EA-04G_Edition1 Page209
Wednesday, June 9 2004 3:6 PM
Form No.8T72-EA-04G

Black plate (233,1)
Engine Coolant
qInspecting Coolant Level
WARNING
Hot Engine:
A hot engine is dangerous. If the
engine has been running, parts of the
engine compartment can become very
hot. You could be burned. Carefully
inspect the engine coolant in the
coolant reservoir, but do not open it.
Do not use a match or live flame in the
engine compartment. DO NOT ADD
COOLANT WHEN THE ENGINE IS
HOT.
Cooling Fan and Engine
Inspection:
Inspecting the engine with the ignition
switch in the ON position is
dangerous. The cooling fan could turn
on unexpectedly even when the engine
isn't running. You could be seriously
injured by the fan. Turn the ignition
switch off and remove the key from the
ignition switch when you inspect the
engine.
Cooling System Cap:
When the engine and radiator are hot,
scalding coolant and steam may shoot
out under pressure and cause serious
injury. Don't remove the cooling
system cap when the engine and
radiator are hot.Inspect the antifreeze protection and
coolant level in the coolant reservoir at
least once a year―at the beginning of the
winter season―and before traveling
where temperatures may drop below
freezing.
Inspect the condition and connections of
all cooling system and heater hoses.
Replace any that are swollen or
deteriorated.
The coolant should be at full in the
radiator and between the FULL and LOW
marks on the coolant reservoir when the
engine is cool.
If it's at or near LOW, add enough coolant
to the coolant reservoir to provide
freezing and corrosion protection and to
bring the level to FULL.
CAUTION
Radiator coolant will damage paint.
Rinse it off quickly if spilled.
Do not overfill.
If new coolant is required frequently,
consult an Authorized Mazda Dealer.
Maintenance and Care
Owner Maintenance
8-17
MX-5 Miata_8T72-EA-04G_Edition1 Page233
Wednesday, June 9 2004 3:6 PM
Form No.8T72-EA-04G

Black plate (235,1)
4. Drain the system completely. Insert and
tighten the plug. Add as much
ethylene-glycol-based coolant mixture
and water as necessary to provide
freezing and corrosion protection.
5. In extremely cold climates, add the
mixture percentage recommended in
the coolant mixture percentage table.
6. Run the engine at idle with the cooling
system cap off. Slowly add additional
coolant if necessary.
7. At this point, wait until the engine
reaches normal operating temperature;
then depress the accelerator two or
three times. Add more coolant, if
necessary, until the system is full.
8. Install the cooling system cap. Inspect
all connections for leaks. Inspect the
level in the coolant reservoir one more
time.Brake Fluid
qInspecting Brake Fluid Level
Inspect the fluid level in the reservoir
regularly. It should be kept at MAX.
The level normally drops with
accumulated distance, a condition
associated with wear of brake linings. If it
is excessively low, have the brake system
inspected by an Authorized Mazda
Dealer.
Maintenance and Care
Owner Maintenance
8-19
MX-5 Miata_8T72-EA-04G_Edition1 Page235
Wednesday, June 9 2004 3:6 PM
Form No.8T72-EA-04G

Black plate (293,1)
D
Dimensions ....................................... 10-5
Door Locks ......................................... 3-9
Driving In Flooded Area ................... 4-12
Driving Tips ........................................ 4-8
Automatic transmission .............. 5-13
Break-in period ............................ 4-8
Driving in flooded area .............. 4-12
Hazardous driving ........................ 4-9
Money-saving suggestions ........... 4-8
Rocking the vehicle ...................... 4-9
Turbocharged vehicles ............... 4-13
Winter driving ............................ 4-10
E
Emergency Starting ........................... 7-13
Flooded engine ........................... 7-13
Jump-starting .............................. 7-13
Push-starting .............................. 7-15
Emergency Towing ........................... 7-16
Emission Control System .................... 4-4
Engine
Coolant ....................................... 8-17
Exhaust gas .................................. 4-6
Hood release .............................. 3-18
Oil .............................................. 8-14
Overheating ................................ 7-11
Starting ......................................... 5-3
Engine Compartment Overview ........ 8-13
Engine Coolant
Overheating ................................ 7-11
Engine Coolant Temperature
Gauge ................................................ 5-20
Exhaust Gas ........................................ 4-6
Exterior Care ..................................... 8-43
F
Flasher
Hazard warning .......................... 5-34
Headlights .................................. 5-29
Flat Tire ............................................... 7-3
Changing ...................................... 7-5
Spare tire and tool storage ............ 7-3
Fluids
Classification .............................. 10-4
Owner maintenance .................... 8-11
Fog Lights ......................................... 5-30
Foot Brake .......................................... 5-4
Front seats ........................................... 2-2
Fuel
Filler lid and cap ........................ 3-17
Gauge ......................................... 5-20
Requirements ............................... 4-2
Tank capacity ............................. 10-5
Fuses ................................................. 8-37
Panel description ........................ 8-39
Replacement ............................... 8-37
G
Glove Box ......................................... 6-70
H
Hazard Warning Flasher .................... 5-34
Hazardous Driving .............................. 4-9
Headlights
Control ....................................... 5-29
Flashing ...................................... 5-29
High-low beam .......................... 5-29
On reminder ............................... 5-29
Hood Release .................................... 3-18
Horn .................................................. 5-33
Index
11-3
MX-5 Miata_8T72-EA-04G_Edition1 Page293
Wednesday, June 9 2004 3:6 PM
Form No.8T72-EA-04G