2005 MAZDA MODEL MPV seats

GETTING STARTED
Always check the Owner’s Manual for more operating information and safety features
Getting
Started
Getting
Started
Quick Tips 2005 Mazda MPV page 8
page 9
Tip: Each time switch is
pressed, a beeper will
sound, this is normal Power sliding doors*
The power sliding doors can be
opened/closed by using: Exterior/
interior door handles, keyless
remote, lower dashboard power
sliding door switches and one
switch on each sliding door post
WARNING: Read all information
and warnings related to power
sliding doors in Owner’s Manual
Opening/closing using door
handles
Power sliding doors automatically
open/close by sliding door
approximately 2” in desired direction
from fully opened/closed positions;
buzzer will sound before door operates
Tip: If the system is
completely inoperative,
both sliding doors can be
operated manually
Operation from rear seatsPress switch for 1 second, doors
automatically open or close after
buzzer sounds; press again to stop
Tips: The system operates only
in PARK position
The system may not operate
correctly if battery voltage
is low Operation from driver’s seat
Power sliding doors main switch:
Press (2) to disable/enable system
Opening/closing using switches:
Stop vehicle, shift into park and
apply parking brake; unlock
sliding doors and press main
switch (2) to ON position; press
left/right switches (1) to open/close
Press switch for 1 second,
doors automatically open or
close after beep sounds; press
again to stop sliding doors while
they are opening/closing
If power sliding doors malfunction
and beep sounds continuously;
press main switch to OFF position
to disable, see your Mazda Dealer
2
1
Tip: Make sure MAIN
SWITCH is in ON position
Manual sliding door
Closing/opening sliding door from
the outside: Pull the door handle
outward to release the lock,
slide door front/rear
Closing/opening sliding door
from inside: Pull door handle
downward, open/close the door
by sliding toward the front/rear
Tip: Make sure fuel lid is closed
before opening left side sliding
door, fuel lid cannot be opened
with left siding door open
*Denotes optional equipment

82
3
1
5
4
SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Seats
Quick Tips 2005 Mazda MPV page 16
page 17
Manual seat controls1. Fore-aft adjustment
Lift lever, slide seat
2. Head restraint
To raise/lower: Pull up/push
stop-catch (8) and push down
3. Seatback angle
To adjust: Lift and hold lever, lean
forward or backward, release lever
4. Seat tilt (Driver’s only)
Rotate front/rear dial to change
angle of seat front/rear
5. Lumbar adjustment
(Driver’s only)
Power driver’s seat controls6. Fore/aft adjustment
Slide switch horizontally
Raise/lower seat cushion
Pull/push center vertically
Raise/lower front of seat
Pull/push front vertically
Raise/lower rear of seat
Pull/push rear vertically
7. Seatback angle
Press front/rear of switch
WARNINGS: Do not adjust
seats while driving
Safety belts must always be
worn when vehicle is in motion
All air bags are supplemental and
do not replace safety belt usage
Always wear your safety belt
and properly secure children
12 and under in a rear seat
Use age appropriate child
restraints and safety seats, see
Owner’s Manual and state or
province laws
Never place rear-facing infant-
safety seat in front of any air
bag, an infant is in serious
danger of being injured or killed
If you must install a
forward-facing child-safety
seat in the front seating
position, move vehicle seat
as far back as possible
Front passenger seat
side table
Pull up to locked position; push
down to verify table is secure
Expand table rearward
by pulling out the rear
Lowering side
table: Pull lever
(2) under table
frontal section
and fold down
completely
WARNING: Do not use front
passenger seat side table
while vehicle is in motion
Shoulder belt
height
adjustment
To raise/lower
belt: Push button
(1) and move belt
to desired position
WARNINGS: Make sure adjuster
locks in one of its positions
Removing and reinstalling
front seats for modification
purposes is dangerous and
may compromise the air
bag system
1
2
*Denotes optional equipment
82
5
67

SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Child-safety
Seats
Quick Tips 2005 Mazda MPV page 18
page 19
*Denotes optional equipment
Child-safety seat
To install in 2nd row outboard
seats: Use dual locking mode
retractor seat belts; see Owner’s
Manual for proper installation
and child seat tether and LATCH
system instructionsWARNING: Read all
informationand warnings
in Owner’sManual and
attached to seat before
using child-safety seat
Safety belt emergency
locking mode
Belts lockonly on hard acceleration,
braking, cornering or impacts of
about 5 mph or moreAutomatic locking mode
(front passenger and all
rear safety belts only)
Must be used when installing
child-safety seat
To activate: Pull webbing fully
out of retractor until click is heard;
belt will only tighten
To disengage: Unbuckle belt and
allow webbing to retract fullyWARNING: Make sure all
adjustable seats are properly
latched, because during a
sudden stop or collision the
seat or seatback could move,
causing injury
Third-row seatInsert seat belts in retainers;
remove head restraints; pull strap
(1), push seatback toward front of
vehicle until it locks with a click
Pull strap (2); lift seatback and
seat bottom up to vertical; gently
lower the seat into seat well12

CLIMATE CONTROLS
Always check the Owner’s Manual for more operating information and safety features
Climate
Controls
Climate
Controls
Quick Tips 2005 Mazda MPV page 20
page 21
Rear climate controlsRear heater type*
Supplies only hot air via floor outlets
Rear cooler type*
Supplies only cold air via roof outlets
Front climate controls1. Temperature control
Rotate knob to blue for
cool, red for warm
Control positions for
maximum defrost
Fan to maximum, temperature
to maximum hot, air flow
selector knob to
2. Air Conditioning
Press on/off
3. Fan control
Rotate knob
4. Rear window defrost
Press ON/OFF
Turns ON for approximately
15 minutes, after 15 minutes,
cycles ON or OFF unless
ignition is turned off
Tip: Indicator light stays
on during defroster
ON/OFF cycling
7. Rear air conditioning
switch*
0= fan off
REAR = enables fan speed
control from the rear
1= low
2= medium
3= high
Tips: To help prevent windshield
fogging in humid weather,
select before starting engine
To prevent moisture buildup,
never drive with system off
Objects placed under the front
seats may interfere with air
flow to the rear
5. Air flow selections
= air to dash
= air to dash and floor
= air to floor
= air to floor and windshield
= air to windshield
6. Air intake selection
switch
Press for cooling
with inside/outside air
When or is selected,
is automatically set so
that windshield fogging is
prevented,can not
be selected
/
0
0123REAR
12
3
4A/C
15342
6
7
132
Rear heater/cooler type*
1. Cool air from roof vent
2. Warm air from floor vent
3. Fan control
Rotate knob
*Denotes optional equipment