2005 MAZDA MODEL MPV ECU

Black plate (239,1)
8. Rotate the small lever on top of the
retaining plate and pull the retaining
plate out from the center hole of the
tire.
NOTE
A flat tire which has been removed
from the vehicle for repair cannot be
carried in the spare tire carrier. Secure
the flat tire with the tire clamp and wing
nut in the luggage compartment (page
7-12).
To secure the spare tire
1. Place the tire with the outer side facing
upward, rotate the small lever on top of
the retaining plate and slide the
retaining plate through the center hole
of the tire.
Rotate the small lever into place.
Lever
Spare tire
2. Raise the spare tire slowly in reverse
order of removal.
WARNING
Carrier Placement for the Specialized
Temporary Spare Tire:
Placing the specialized temporary
spare tire in the spare tire carrier
wrong side up or using any tire other
than the small temporary spare tire
designed for use with this vehicle is
dangerous. It will result in poor
attachment and insufficient ground
clearance in the spare tire carrier and
the danger of the tire falling off. This
could result in someone being badly
injured or even killed.
Place the specialized temporary spare
tire in the spare tire carrier correctly.
In Case of an Emergency
Flat Tire
7-7
Mazda MPV_8T50-EA-04G_Edition1 Page239
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (245,1)
3. Install the lug nuts with the beveled
edge inward; tighten them by hand.
WARNING
Don't Apply Oil or Grease to Lug
Nuts, Bolts:
Applying oil or grease to lug nuts and
bolts is dangerous. The lug nuts could
loosen while driving and cause the tire
to come off, resulting in an accident.
In addition, lug nuts and bolts could
be damaged if tightened more than
necessary. Do not apply oil or grease
to lug nuts and bolts and do not
tighten the lug nuts beyond the
recommended tightening torque.4. Turn the lug wrench counterclockwise
and lower the vehicle. Use the lug
wrench to tighten the nuts in the order
shown.
If you're unsure of how tight the nuts
should be, have them inspected at an
Authorized Mazda Dealer.
Nut tightening torque
N·m (kgf·m, ft·lbf)108―147
(11―15, 80―108)
WARNING
Loose Lug Nuts:
Improperly or loosely tightened lug
nuts are dangerous. The wheel could
wobble or come off. This could result
in loss of vehicle control and cause a
serious accident. Always securely and
correctly tighten the lug nuts.
In Case of an Emergency
Flat Tire
7-13
Mazda MPV_8T50-EA-04G_Edition1 Page245
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (246,1)
WARNING
Metric Studs and Lug Nuts:
Because the wheel studs and lug nuts
on your Mazda have metric threads,
using a non-metric nut is dangerous.
On a metric stud, it would not secure
the wheel and would damage the stud,
which could cause the wheel to slip off
and cause an accident. Be sure to
reinstall the same nuts you removed or
replace them with metric nuts of the
same configuration.
Incorrect Tire Air Pressure:
Driving on tires with incorrect air
pressure is dangerous. Tires with
incorrect pressure could affect
handling and result in an accident.
Don't drive with any tires that have
incorrect air pressure. When you
check the regular tires' air pressure,
check the spare tire, too.
5. Put the flat tire in the special vinyl bag
and tie it at the top.
6. With the tire facing outward, punch a
hole through the vinyl bag and the
center hole, using the flat tire securing
bolt.
7. Lift the anchor clip on the back of
third-row seat.
8. Install the flat tire with the tire securing
bolt hooked in the anchor clip as
shown below.
7-14
In Case of an Emergency
Flat Tire
Mazda MPV_8T50-EA-04G_Edition1 Page246
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (247,1)
9. Secure the flat tire with the tire clamp
and wing nut as shown below.
Have the damaged tire repaired or
replaced as soon as possible.
NOTE
lIf the tire rattles even through the
wing nut is tightened, reverse the tire
clamp and retighten the wing nut.
lTo prevent the jack and tool from
rattling, store them properly.
In Case of an Emergency
Flat Tire
7-15
Mazda MPV_8T50-EA-04G_Edition1 Page247
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (268,1)
Changing engine oil
WARNING
Checking or Changing Engine Oil:
Hot engine oil is dangerous. If the
engine has been running, the engine
oil becomes very hot. You could be
seriously burned. Don't check or
change the engine oil when the engine
is hot.
1. Warm up the engine for a few minutes
and turn it off. Remove the oil-filler
cap.
2. Remove the drain plug and drain the
oil into a suitable container.
3. Replace the plug tightly after the oil
has thoroughly drained.
4. Fill the engine with new oil to the
MAX mark on the dipstick.
5. Securely reinstall the oil-filler cap.
Tighten
Loosen
Drain plug
Forward
6. Start the engine and inspect around the
drain plug for leaks.
7. Turn it off and wait 5 minutes for the
oil to return to the oil pan.Check the oil level and fill to the MAX
mark if necessary.
Oil capacity (General reference only,
refer to Specifications section for
capacities.)
NOTE
lThe indicated engine oil capacities
are for general reference purposes
only. When adding or changing oil,
verify the engine oil level with the
oil dipstick.
lUse only specified engine oil (page
10-4).
Changing oil filter
Because you need a special tool to
retighten the filter, an Authorized Mazda
Dealer should do the work.
8-12
Maintenance and Care
Owner Maintenance
Mazda MPV_8T50-EA-04G_Edition1 Page268
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (281,1)
WARNING
Keep Flames Away:
Flames and sparks near open battery cells are dangerous. Hydrogen gas, produced
during normal battery operation, could ignite and cause the battery to explode. An
exploding battery can cause serious burns and injuries. Keep all flames including
cigarettes and sparks away from open battery cells. When working near a battery, do
not allow metal tools to contact the positive (
) or negative () terminal of the
battery. Do not allow the positive (
) terminal to contact the vehicle body.
Battery-Related Explosion:
Flames and sparks near open battery cells are dangerous. Hydrogen gas, produced
during normal battery operation, could ignite and cause the battery to explode. An
exploding battery can cause serious burns and injuries. Keep all flames, including
cigarettes, and sparks away from open battery cells.
qBattery Maintenance
To get the best service from a battery:
lKeep it securely mounted.
lKeep the top clean and dry.
lKeep terminals and connections clean,
tight, and coated with petroleum jelly
or terminal grease.
lRinse off spilled electrolyte
immediately with a solution of water
and baking soda.
lIf the vehicle will not be used for an
extended time, disconnect the battery
cables.
qInspecting Electrolyte Level
A low level of electrolyte fluid will cause
the battery to discharge quickly.
Upper level
Lower level
Maintenance and Care
Owner Maintenance
8-25
Mazda MPV_8T50-EA-04G_Edition1 Page281
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (290,1)
2. Push the tab as shown in the figure,
and then remove the high-mount brake
light unit.
3. Turn the socket and bulb assembly
counterclockwise and remove it.
4. Disconnect the bulb from the socket.
5. Install the new bulb in the reverse order
of removal.
NOTE
An unsecured high-mount brake light
will allow water to leak into the vehicle.
Make sure the high-mount brake light is
tightly fastened to the vehicle and if
water still leaks, consult an Authorized
Mazda Dealer.
License plate lights
1. Slide the unit as shown in the figure to
remove it.
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order
of removal.
qReplacing Interior Light Bulbs
Overhead light/Map lights
1. Wrap a small flathead screwdriver with
a soft cloth to prevent damage to the
lens and remove the lens by carefully
prying on the edge of the lens with the
screwdriver.
2. Disconnect the bulb by pulling it out.
8-34
Maintenance and Care
Owner Maintenance
Mazda MPV_8T50-EA-04G_Edition1 Page290
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (332,1)
A
Accessory Socket .............................. 6-57
Add-On Non-Genuine Parts and
Accessories ....................................... 9-13
Air Bag Systems ............................... 2-56
Air Filter ............................................ 8-20
Antenna ............................................. 6-14
Anti-Lock Brake System (ABS) ......... 5-6
Warning light ............................... 5-7
Appearance Care ............................... 8-42
Ashtray .............................................. 6-49
Audio System ................................... 6-14
Audio control switch .................. 6-42
Operating tips for audio
system ........................................ 6-14
Safety certification ..................... 6-44
Automatic Transaxle
Driving tips ................................ 5-12
Fluid ........................................... 8-17
Overdrive ................................... 5-11
Shift-lock override ..................... 5-11
Shift-lock system ........................ 5-11
Transaxle ranges .......................... 5-9
B
Battery
Emergency starting .................... 7-18
Maintenance ............................... 8-24
Specifications ............................. 10-4
Beep Sounds
Ignition key reminder ................. 5-32
Lights-on reminder ..................... 5-32
Power sliding door beep ............. 5-32
Seat belt warning beep ............... 5-32
Before Starting the Engine .................. 4-6
After getting in ............................. 4-6
Before getting in .......................... 4-6
Body Lubrication .............................. 8-19
B
Bottle Holder ..................................... 6-53
Brake
Fluid ........................................... 8-15
Brakes
Anti-lock brake system (ABS) ..... 5-6
Foot brake .................................... 5-4
Pad wear indicator ........................ 5-7
Parking brake ............................... 5-4
Warning light ............................... 5-5
Break-In Period ................................... 4-7
Bulb Replacement ............................. 8-30
C
Capacities .......................................... 10-4
Carbon Monoxide ............................... 4-5
Cargo Securing Loops ...................... 6-56
Catalytic Converter ............................. 4-3
Cell Phones ....................................... 9-14
Child Restraint
Child restraint precautions ......... 2-41
Installing child-restraint
systems ....................................... 2-45
LATCH child-restraint
systems ....................................... 2-53
Child Safety Locks for Rear Doors ... 3-11
Cigarette Lighter ............................... 6-49
Climate Control System ...................... 6-2
Gas specifications ...................... 10-5
Clock ................................................. 6-24
Courtesy Lights ................................. 6-48
Cruise Control ................................... 5-13
Cup Holder ........................................ 6-51
Customer Assistance ........................... 9-2
D
Dashboard Illumination .................... 5-23
11-2
Index
Mazda MPV_8T50-EA-04G_Edition1 Page332
Monday, June 28 2004 4:1 PM
Form No.8T50-EA-04G