2005 MAZDA MODEL B2300 TRUCK reset

[x] Cancel search: reset

Page 27 of 257

MAZDA MODEL B2300 TRUCK 2005  Owners Manual (in English) the CD player. The label may peel and cause the CD to become
jammed. It is recommended that homemade CDs be identified
with permanent felt tip marker rather than adhesive labels.
Ballpoint pens may da

Page 28 of 257

MAZDA MODEL B2300 TRUCK 2005  Owners Manual (in English) 4.CLK (Clock):Press CLK until
SELECT HOUR or SELECT
MINUTE is displayed. Press
MENUto adjust the
hours/minutes. Press CLK to display the time when the ignition is
off.
5.MUTE:Press to mute the
playing

Page 29 of 257

MAZDA MODEL B2300 TRUCK 2005  Owners Manual (in English) 7.TUNE/DISC:Press to manually go down/up (/) the radio
frequency, select the previous/next CD or to select various settings
in menu mode. In MP3 directory mode, press
/to access the
previous/next dire

Page 30 of 257

MAZDA MODEL B2300 TRUCK 2005  Owners Manual (in English) 16.ON/OFF/Volume:Press to turn
ON/OFF. Turn to
increase/decrease volume.
If the volume is set above a
certain level and the ignition is
turned off, the volume will come
back on at a“nominal”listen

Page 152 of 257

MAZDA MODEL B2300 TRUCK 2005  Owners Manual (in English) 3. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift lever,
it is possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to

Page 160 of 257

MAZDA MODEL B2300 TRUCK 2005  Owners Manual (in English) If vehicle speed drops more than 10 mph (16 km/h), the speed control
will cancel automatically. Resume speed with accelerator pedal.
If speed control cancels after climbing the hill, reset speed by pr

Page 162 of 257

MAZDA MODEL B2300 TRUCK 2005  Owners Manual (in English) This switch is located under the
right-hand side of the glove box,
just above the carpet.
To reset the switch:
1. Turn the ignition OFF.
2. Check the fuel system for leaks.
3. If no leaks are apparent

Page 217 of 257

MAZDA MODEL B2300 TRUCK 2005  Owners Manual (in English) 2. Put the gearshift lever in P (Park), turn off all accessories and start
the engine.
3. Run the engine until it reaches normal operating temperature.
4. Allow the engine to idle for at least one min
Page:   < prev 1-8 9-16 17-24 next >