2005 LEXUS LS430 headlight bulb

SWITCHES
57
HEADLIGHT DIMMER AND TURNSIGNAL SWITCH
12L164
For high beam, push the lever forward. Pull it back for low
beam. For the headlight flasher, pull it further back.
A blue light in the instrument cluster indicates high beam or
headlight flasher is on.
The headlight flasher works even when the headlight switch is
off.
12L165
For signaling turns, move the lever up or down in the
conventional manner.
The ignition switch must be in the “ON” position.
The turn signal is self −cancelling after a turn, but after a lane
change, you may have to cancel it by hand. You can also signal
a lane change by moving the turn signal lever partway and
holding it there.
If the green light in the instrument cluster flashes faster than
normal, it indicates that the front or rear turn signal bulb has
burned out. If this indicator light does not come on, the fuse
or the indicator light itself has probably failed.

SECTION 6 – 4
487
SERVICE PROCEDURES AND
SPECIFICATIONS
Electrical components
Specifications488
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . .
Checking battery condition 496
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Battery recharging precautions 499
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking and replacing the blade type fuses 499
. . . . . . . . . . . . . . . .
Checking the cartridge type fuses 502
. . . . . . . . . . . . . . . . . . . . . . . . . .
Adding washer fluid 503
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
.
Checking the headlight aim 504
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Replacing light bulbs 505
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\

ELECTRICAL COMPONENTS
505
64L230
2. Turn the vertical movement adjusting bolt 2 the same
number of turns and in the same direction as step 1 using a
Phillips−head screwdriver.
REPLACING LIGHT BULBS
The illustrations on the following pages show the locations of
light bulbs. If it is necessary to replace a bulb, take your vehicle
to your Lexus dealer as soon as possible. Use bulbs with the
bulb numbers and wattage ratings given in the table.
The tail and stop lights consist of a number of LEDs. If any LED
burns out, we recommend you take your vehicle to your Lexus
dealer to have the light inspected as soon as possible.
CAUTION
 To prevent burning yourself, do not replace the light
bulbs while they are hot.
 Halogen bulbs have pressurized gas inside and
require special handling. They can burst or shatter if
scratched or dropped. Hold a bulb only by its plastic
or metal case. Do not touch the glass part of a bulb
with bare hands.
 Do not touch the high voltage socket when the
headlights turn on. 20000 V is momentarily
generated and may cause severe injury by an electric
shock.
 Do not disassemble, repair or take apart the headlight
bulbs, connector, power supply circuits and rotated
components. Or you may be injured by electric
shocks. Call your dealer when the headlights fail to
work or have to be replaced or disposed of.

ELECTRICAL COMPONENTS
506
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights such as headlights may
temporarily fog up when the lens becomes wet in the rain or in
a car wash. This is not a pr oblem because the fogging is
caused by the temperature dif ference between the outside and
inside of the lens, just like the windshield fogs up in the rain.
However, if there is a large drop of water on the inside of the
lens, or if there is water pooled inside the light, contact your
Lexus dealer. LIGHT LOCATION
64L209
Light Bulbs
Bulb No. W Type
1 Headlight (High beam) 9005 60 A
2 Parking light −−−5D
3 Headlight (Low beam) −−−35 B
4 Front turn signal light −−−21 D
5 Front side marker light −−−5D
6 Fog light 9006 51 C