Page 338 of 539
STARTING AND DRIVING
319
31L149b
Corner obstacles
Depending on the distance between your vehicle and the
obstacle, the display and beeps change as follows:
1 About 37.5 cm (1.1 ft.) to about 50 cm (1.5 ft.): 3 arcs
appear on the corner of the vehicle mark where the
obstacle is detected. At this time, the beeps remind you
that your vehicle is getting closer to the obstacle by
sounding intermittently.
2 About 25 cm (0.8 ft.) to about 37.5 cm (1.1 ft.): The
number of arcs will decrease from 3 to 2. The beeps
sound at shorter intervals than in step
1.
3 Less than about 25 cm (0.8 ft.): The number of arcs will
decrease from 2 to 1, and the bar blinks while the beeps
sound continuously.
Lexus park assist system failure warning
31L351
The system self check is automatically performed when
the Lexus park assist system is turned on. At this time if
an error is detected, the master warning light comes on
accompanied by 5 beeps, the faulty sensor blinks and
either of the following messages appear in the
multi information display.
“Check Park Sonar”
“Clean Park Sonar”
The sensors operate individually. When one sensor is
malfunctioning, you will notice sounding beeps and blinking
indicators to show that it is malfunctioning. If another sensor
detects an obstacle during this time, the approximate distance
to the obstacle will be shown by that sensor.
Page 339 of 539
STARTING AND DRIVING
320
W285
If the sensor is malfunctioning or a cable is broken, the
above message appears.
Although it is no problem to continue driving, have your vehicle
checked by your Lexus dealer as soon as possible.
W286
If icicles, snowflakes or mud gets on the sensor or it is
frozen, the sensor may not be able to detect an obstacle.
In either case, the above message appears.
Remove the foreign matter or deice the sensor. If the message
does not appear after cleaning, the system is operating
properly.
Lexus park assist system operating hints
31L355
Sensor detection range
1
About 1 m (3 ft.) 2About 50 cm (1.5 ft.)
The sensor detection range is limited around the bumper.
Be sure to confirm a safe distance around your vehicle
and drive slowly.
If more than one obstacle is detected in the same
direction, the indicators for the obstacle nearest to the
vehicle will turn on.
Page 340 of 539
STARTING AND DRIVING
321
CAUTION
Do not install an accessory or the like within the sensor
detection range. Doing so may cause the Lexus park
assist system to malfunction, resulting in an accident.
NOTICE
The sensors do not detect an obstacle just under the
bumper. A short object, thin stake or the like will be
detected once but might not be detected as your
vehicle gets very close to such an object.
If an obstacle is very close to your vehicle, it might
not be detected.
If a sensor is subjected to a strong impact, it will not
operate properly.
The Lexus park assist system may not work properly in
the following cases:
When icicles, snowflakes or mud gets on the sensors.
If removed, the system will work properly.
When the sensor is frozen.
If deiced, the system will work properly.
When the sensor is covered with something.
If removed, the system will work properly. Especially in cold weather, a malfunction warning screen may
appear on
the display due to frozen sensors. If the “Clean Park
Sonar” appears on the display, be sure to clean the sensor. If
the “Clean Park Sonar” appears despite no mud, ice or
snowflakes on the sensor, the sensor might have
malfunctioned. Have your vehicle checked by your Lexus
dealer.
In the following conditions, the detection range may be
affected:
When you stop your vehicle in extreme hot or cold weather.
Foreign matter such as snowflakes or mud gets on the
sensor.
Page 341 of 539
STARTING AND DRIVING
322The Lexus park assist system may detect the following by
mistake:
Bumpy roads or gravelled roads or grass when driving on
such surfaces, or on grass
Devices issuing ultrasonic waves, such as a horn from
another vehicle, motorcycle engine, air braking sound from
heavy−duty vehicles, if such a device is operated around
your vehicle
Rain or water splashing over the sensor
The ground on which the vehicle is tilted
Radio antenna or fender pole mounted on your vehicle
Mud, ice or snowflakes on the sensor
Tall curb stone
Towing eyelet mounted on your vehicle
Towing hitch mounted on your vehicle The Lexus park assist system may not detect the
following:
Thin objects such as wire or rope
Objects with a surface area too small to reflect ultrasonic
waves such as wire gauze or fence
Sound wave absorbing objects such as cotton or snow
Objects with a sharp edge
Shorter objects
Tall objects with the upper part projected
For vehicles with a Navigation System, the park assist
graphics appear both on the navigation display and
multi− information display. For details, see the separate
“Navigation System Owner’s Manual”.
For vehicles sold in Canada
This ISM device complies with Canadian ICES −001.
Page 348 of 539
STARTING AND DRIVING
329
5Resuming the preset speed
If the preset speed is cancelled by pulling the control lever, by
depressing the brake pedal or vehicle stability control
activation, pushing the lever up in the “+ RES” direction will
restore the speed set prior to cancellation. However, once the
vehicle speed falls below about 40 km/h (25 mph), the preset
speed will not be resumed.
Cruise control failure warning
If the “CRUISE” indicator light in the instrument cluster flashes
when using the cruise control, push the “ON −OFF” button to
turn the system off and then push it again to turn it on.
If any of the following conditions then occurs, there is some
trouble in the cruise control system.
The indicator light does not come on.
The indicator light flashes again.
The indicator light goes out after it comes on.
If this is the case, contact your Lexus dealer and have your
Lexus inspected.
DYNAMIC RADAR/LASER CRUISE CONTROL
The vehicles with pre collision safety system are
equipped with dynamic radar cruise control. For the
vehicles without pre collision safety system, dynamic
laser cruise control can be equipped as optional.
Dynamic radar/laser cruise control allows you to drive at
a selected cruising speed over about 45 km/h (28 mph)
with your foot off the accelerator pedal, maintaining an
appropriate vehicle to vehicle distance.
31L359a
Dynamic radar cruise control
(Vehicles with pre collision safety system)
1 Millimeter wave grille cover
2Millimeter wave radar sensor
Page 349 of 539
STARTING AND DRIVING
330
31L363
Dynamic laser cruise control
(Vehicles without pre collision safety system)
1 Laser radar sensor
31L631
Inside view
1
Master warning light 2Multi information display
3“CRUISE” indicator light
4DISP2 switch (for changing vehicle to vehicle
distance)
5 Cruise control lever
The dynamic radar/laser cruise control function has 2 cruise
control modes: vehicle−to−vehicle distance control mode for
maintaining an appropriate distance between vehicles, and a
conventional (fixed speed) cruise control mode for cruising at
preset speeds.
Page 351 of 539
STARTING AND DRIVING
332To change to the vehicle
−to−vehicle distance control mode
from the conventional (fixed speed) cruise control mode, push
the lever in the “MODE” dire ction for longer than about 1
second.
CAUTION
In the conventional (fixed speed) cruise control mode,
a warning tone does not sound to warn you if you are too
close to the vehicle ahead, as neither the presence of
the vehicle ahead nor the vehicle to vehicle distance is
detected. Pay special attention to the distance between
your vehicle and the vehicle ahead. Always confirm the
setting in the multi information display.
For the vehicle −to−vehicle distance control mode, see the
following description. For the conventional (fixed speed)
cruise control mode, see page 355.
Vehicle to vehicle distance control mode
Dynamic radar cruise control—
The millimeter wave radar sensor in this system primarily
detects the reflected wave from the rear end of the vehicle
ahead of you to determine the presence of the vehicle
ahead as well as measuring the vehicle to vehicle
distance. The detection range of the sensor is about 120
m (400 ft.) ahead.
When the dynamic radar cruise control is on, the driving
pattern (power, normal) of the automatic transmission is fixed
in the normal position, regardless of the position of the selector
switch.
CAUTION
The dynamic radar cruise control is not a
collision avoidance system and will not prevent
accidents. The dynamic radar cruise control is a vehicle
speed control device that is intended for use only on
freeways or roads where the traffic is light or moderate.
To avoid serious injury, you must use caution and be
attentive to road and traffic conditions while using
dynamic radar cruise control.
Page 352 of 539
STARTING AND DRIVING
333
Dynamic laser cruise control—
The laser radar sensor in this system primarily detects the
reflectors of the vehicle ahead of you to determine the
presence of the vehicle ahead as well as measuring the
vehicle to vehicle distance. The detection range of the
sensor is about 120 m (400 ft.) ahead.
When
the dynamic laser cruise control is on, the driving pattern
(power, normal) of the automatic transmission is fixed in the
normal position, regardless of the position of the selector
switch.
CAUTION
The dynamic laser cruise control is not a
collision avoidance system and will not prevent
accidents. The dynamic laser cruise control is a vehicle
speed control device that is intended for use only on
freeways or roads where the traffic is light or moderate.
To avoid serious injury, you must use caution and be
attentive to road and traffic conditions while using
dynamic laser cruise control.
(a) Dynamic radar/laser cruise control operations
31L360b
The dynamic radar/laser cruise control function operates
automatically and depending on whether a vehicle is
detected ahead may change the speed of your vehicle as
follows:
