2005 LEXUS LS430 change time

INTERIOR EQUIPMENT
125
(c) Erasing the entire HomeLink\b memory
(all three programs)
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored
in the HomeLink
\b memory.
CAUTION
 When programming the HomeLink\b Universal
Transceiver, you may be operating a garage door or
other device. Make sure people and objects are out
of the way of the garage door or other device to
prevent potential harm or damage.
 Do not use this HomeLink
\b Universal Transceiver
with any garage door opener that lacks the safety
stop and reverse feature as required by federal safety
standards. (This includes any garage door opener
model manufactured before April 1, 1982.) A garage
door opener which cannot detect an object
(signaling the door to stop and reverse), does not
meet current federal safety standards. Using a
garage door opener without these features increases
risk of serious injury or death.
This device complies with Part 15 of the FCC Rules
and with RSS− 210 of the IC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
WARNING: This transmitter has been tested and
complies with FCC and IC rules. Changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the device.

STEERING WHEEL AND MIRRORS
233
155.Outer foot lights
16L659
The outer foot lights illuminate the ground near the doors
for about 15 seconds to ensure safe footing for the driver
and passengers who are about to get in the vehicle.*
The outer foot lights come on when:
you are getting closer to the vehicle carrying a smart key
and you enter the effective range of the smart key system
(about 1 m (3 ft) from each outside door handle),
 the doors are unlocked with the wireless remote control
function key, or
 the doors are unlocked with the power door lock switch on
the driver’s side. The outer foot lights go off 15 seconds after the lights come on
or when:

the lock switch on the outside door handle is pushed,
 the doors are locked with th e wireless remote control
function key,
 the doors are locked by inserting a key into the door
keyhole,
 the doors are locked with the power door lock switch on the
driver’s side, or
 the selector lever is moved out of “P” position with the
ignition on.
NOTE:
* The outer foot lights illuminating time can be changed.
Ask your Lexus dealer for details.

AIR CONDITIONING
243
(a) Climate control
SETTING OPERATION automatic control
21L054a
1. Push the “AUTO” button.
Air flow quantity, switching of the diffusers, on−off of the air
conditioning, and switching of the air intake between
RECIRCULATED AIR and OUTSIDE AIR are automatically
adjusted. If you use the air purifier automatic mode at the same
time, air purifying effect will be enhanced (If equipped). The
operation status is shown by each indicator.
When one of the manual control buttons is depressed while
operating in automatic mode, the mode relevant to the
depressed button is set. Other conditions continue to be
adjusted automatically.
Push the “OFF” button briefly to turn the air conditioning off.
If you keep the “OFF” button pushed, the data for the air filter
is reset.
21L283
2. Use the “TEMP” or “PASSENGER TEMP” button to set
the desired temperature.
The “TEMP” or “P ASSENGER TEMP” button is used to set the
desired temperatu re. The temperatur e will be controlled on the
driver and front and rear passenger sides (if rear air
conditioning is equipped) simultaneously or individually. The
figures on the panel indicate degrees Fahrenheit or
Centigrade.
“TEMP” button − Changes the temperature on the driver and
front and rear passenger sides (if rear air conditioning is
equipped) simultaneously or individually.
“PASSENGER TEMP” button − Changes the temperature
settings separate from the driver side.
“DUAL” button − Changes the mode of the temperature
setting.

AIR CONDITIONING
246If manual switching of air intake is desired
21L060a

Vehicles with rear air conditioning
21L156
Vehicles without rear air conditioning Each time you push the air intake control button, the mode
changes in order from the RECIRCULATED AIR mode to
AUTOMATIC mode to OUTSIDE AIR mode, then back to the
RECIRCULATED
AIR mode. Each indicator light shows which
mode is now selected.
1 RECIRCULATED mode If quick circulation of cooled air
is desired, select this mode.
2 EXHAUST GAS AUTOMATIC mode If the outside air
contains harmful substances like exhaust gas (i.e., when
the vehicle running just in front of your vehicle accelerates
rapidly), the system changes automatically from the
OUTSIDE AIR mode (with indicators
2
and 3 on) to
the RECIRCULATED mode (with indicators 1
and 2
on). If you use the EXHAUST GAS AUTOMATIC mode
and the air purifier automatic mode at the same time, air
purifying effect will be enhanced (If equipped).
3 OUTSIDE AIR mode The system will take fresh outside
air into the vehicle.
Turning off the air conditioning manually will cancel the
EXHAUST GAS AUTOMATIC mode. If you select the “AUTO”
mode during fan operating, the air conditioning turns on and
the EXHAUST GAS AUTOMATIC mode will operate.
For normal use, it is best to keep the air intake control button
set to OUTSIDE AIR mode. If recirculated air is used during
heating, the windows will fog up more easily.
To change the sensitivity of the sensor switching between
the RECIRCULA TED and OUTSIDE AIR in the AUTOMATIC
mode, push the air intake control button until you hear a
beep. The display changes as illustrated below.

AIR CONDITIONING
247
The sensitivity of the sensor can be adjusted only while the
vehicle has stopped.
21L108
When
you push either side of the “TEMP” button several times,
the sensitivity changes from “+3” down to “–3”. If you d\
o not
operate any button for a few seconds, the previous display
returns.
If manual onoff of the air conditioning is desired
Push the “A/C” button to turn the air conditioning on and push
it again to turn the air conditioning off. If you turn off the air
conditioning manually, the EXHAUST GAS AUTOMATIC
mode will be cancelled.
If the outside temperature is lowered down to around 0 C
(32 F), the air conditioning will turn off automatically. At this
time, the indicator on the A/C button is off and the EXHAUST
GAS AUTOMATIC indicator light remains on. However, the
EXHAUST GAS AUTOMA TIC mode does not operate. When
the air conditioning turns on as with the raised temperature, the
EXHAUST GAS AUTOMATIC mode resumes. If the system is used for ventilation, heating in dry weather or
removing frost or exterior fog on the windshield, turn the air
conditioning off
once it is no longer required. This will improve
fuel economy. The air conditioning can be used for year −round
automatic temperature control including cooling and
dehumidifying operation.
If the air conditioning compressor does not operate, the
indicator of the “A/C” button will blink. If the indicator of the
“A/C” button blinks even when the “A/C” button is pushed
again, have the compressor checked by your nearest Lexus
dealer.

AIR CONDITIONING
255
These
are the controls added to the front air conditioning when
your vehicle is equipped with a rear air conditioning. The
controls for the rear passengers and for the front passengers
both work the same, so operation can be made with the
controls on either panel.
(a) Controls and Functions
This rear air conditioning is equipped with dustproof and
deodorant filter with photocatalyst. When light in the
xenon tube (ultraviolet rays) hits the filter, odious
ingredients adsorbed in the filter are oxidized and
decomposed to deliver clean air in the interior.
REAR AIR CONDITIONING ONOFF
Push the “AUTO” button to turn the air conditioning on,
and push the “OFF” button to turn it off.
AIR FLOW CONTROL
The mode changes every time the “LO HI A/C” button is
pushed.
AUTO mode − Turns the fan operation to automatic.
LO speed mode − Turns the fan at low speed.
HI speed mode − Turns the fan at high speed.
(b) Rear Cooling
1. Turn the front air conditioning on. The rear cooler will not
turn on if the front air conditioning is off.
2. Turn the rear air conditioning on. The fan speed and rear
cooler are adjusted automatically.
3. Use either of the “LO HI A/C” buttons to adjust the desired
fan speed and the rear cooler. Each indicator light shows
which mode is now selected.
(c) Air Purifier
The air purifier operates whenever the rear air conditioning or
the rear fan operation is on, regardless of front air conditioning
activation.

AUDIO
264(c) DSP Control

Automatic Sound Levelizer (ASL)
20L358
When the audio sound becomes difficult to be heard due to
road noise, wind noise, etc. during driving, push the “ASL”
button. The system adjusts to the optimum volume and tone
quality according to the noise level. While the Automatic
Sound Levelizer (ASL) is on, “ASL” appears on the display. 
Positioning selector
20L359a
By selecting the listening position, the system controls the
output timing of the speakers to allow sound to be heard
evenly, creating the ideal music environment.
Each time you push the “POS” button, the position changes as
in the following and the letter displays for 6 seconds on the
screen.
ALL
DRIVER FRONT
REAR

AUDIO
266
20L361a
NOTICE
Do not put any object on the panel or push it hard. Doing
this may damage the panel.
20L362a
Your automatic changer can store up to 6 CDs and play
selected CDs or continuously play all the CDs set in the player.
When you set CDs into the player, make sure their labels face
up. If not, the player will display “ERROR1” and the CD
number.
NOTICE
 Never try to disassemble or oil any part of the CD
player. Do not insert anything except a CD into the
slot.
 Do not insert a CD upon another one, or it will damage
the automatic changer. Insert only one CD into the
slot at a time.