STARTING AND DRIVING
371
The degree of the tread wear is very different among the
installed tires.
Rapid acceleration/deceleration or sharp turns are
continued.
Towing a trailer.
The loading is over the limit or unbalanced.
Initialization was not performed correctly after replacing or
rotating tires or wheels.
The outside temperature is below 0 C (32F) or above
40 C (104 F).
If the warning message appears again on the
multi−information display after adjusting tire inflation pressure,
the system may be malfunctioning. Have your vehicle
checked by your Lexus dealer as soon as possible.
CAUTION
When the tire pressure warning message appears,
observe the following instructions:
Adjust the tire inflation pressure to the specified level
as soon as possible.
Avoid abrupt steering wheel maneuvering and
braking. If the vehicle tires are deteriorated, you
could lose control of the steering wheel or the brakes,
causing death or serious injury.
Note: The tire pressure mon itoring system on your
vehicle will warn you when one of your tires is
significantly under inflated and when some
combinations of your tires are significantly
under inflated. However, there are other combinations
of significantly under inflated tires for which your tire
pressure warning system may not warn you. These
other combinations are relatively common, accounting
for approximately half the instances in which vehicles
have significantly under inflated tires. For example,
your system may not warn you when both tires on the
same side or on the same axle of your vehicle are
significantly under inflated. It is particularly important,
therefore, for you to check the tire inflation pressure in
all of your tires regularly and maintain proper pressure.
STARTING AND DRIVING
372
Tire pressure warning system reset switch
31L568b
The tire pressure warning system needs to be initialized
after tires or wheels are replaced or rotated.
To initialize the system, perform the following:
1. Park the vehicle at a safe place with the parking brake
applied and turn the ignition switch to “LOCK”.
2. Adjust the pressure of all the installed tires to the specified
level. (See “Tires and wheels” on pages 463 through 465.)
3. Turn the ignition switch to “ON”.
If the low tire pressure warning message “Low Tire” appears
in the multi−information display, push the reset switch for a few
seconds and make sure the warning message goes off.
4. With the vehicle stopped, push and hold the reset switch
until “Pressure Initial” appears in the multi−information display.
W266
Initialization is completed after driving at the speeds of 30
km/h (19 mph) or over for more than one hour. If the
following driving conditions are satisfied, initialization
will be completed in about one hour.
The vehicle speeds is between 50 km/h (31 mph) and
100 km/h (62 mph).
The roads are dry, smooth and straight.
The number of passengers is one or two (including the
driver).
If you make a mistake in the middle of initialization, perform the
operation from the beginning again.
Do not push the reset switch without adjusting the tire inflation
pressure to the specified level. Otherwise, the low tire
pressure warning may not turn on even if the tire inflation
pressure is low, or it may turn on when the tire inflation
pressure is actually normal.
If you push the reset switch while driving, initialization is not
performed.
If “Pressure Initial”does not appear when the reset switch is
held down, the system may be malfunctioning. Have your
vehicle checked by your Lexus dealer as soon as possible.