2005 Lexus IS300 oil viscosity

DRIVING TIPS
271
Make sure the engine oil viscosity is suitable for the cold
weather.
See page 335 for recommended viscosity. Leaving a heavy
summer oil in your vehicle during winter months may cause
harder starting. If you are not sure about which oil to use, call
your Lexus dealer ± they will be pleased to help.
Check the electronic ignition system for loose
connections or obvious damage.
Keep the door locks from freezing.
Squirt
lock de±icer or glycerine into the locks to keep them from
freezing.
Use a washer fluid containing an antifreeze solution.
This product is available at your Lexus dealer and most auto
parts stores. Follow the manufacturer's directions for how
much to mix with water.
NOTICE
Do not use engine antifreeze or any other substitute
because it may damage your vehicle's paint.
Do not use your parking brake when there is a possibility
it could freeze.
When parking, put the transmission into ªPº (automatic) or into
first or reverse (manual) and block the front wheels. Do not use
the parking brake, or snow or water accumulated in and around
the parking brake mechanism may freeze the parking brake,
making it hard to release. Keep ice and snow from accumulating under the fenders.
Ice and snow built up under your fenders can make steering
difficult. During bad winter driving, stop and check under the
fenders occasionally.
Depending on where you are driving, we recommend you
carry some emergency equipment.
Some of
the things you might put in the vehicle are tire chains,
window scraper, bag of sand or salt, flares, small shovel,
jumper cables, etc.
04 06.30

INTRODUCTION
320
NOTICE

Remember that battery and ignition cables carry high
currents or voltages. Be careful of accidentally causing a short circuit.

Add only ªT oyota Super Long Life Coolantº or similar
high quality ethylene glycol based non±silicate, non± amine, non±nitrite, and non±borate coolant withlong±life hybrid organic acid technology to fill theradiator. ªToyota Super Long Life Coolantº is a mix-ture of 50% coolant and 50% deionized water (for the
U.S.A.) or 55% coolant and 45% deionized water (forCanada).

If you spill some of the coolant, be sure to wash it offwith water to prevent it from damaging the parts orpaint.

Before closing the engine hood, check to see that you
have not forgotten any tools, rags, etc.

Do not drive with the air cleaner removed, or excessive engine wear could result. Also backfiringcould cause a fire in the engine compartment.

Do not overfill automatic transmission fluid, or thetransmission could be damaged.

Be careful not to scratch the glass surface with thewiper frame.
PARTS AND TOOLS
Here is a list of parts and tools you will need to perform
do±it±yourself maintenance. Remember all Lexus parts are
designed in metric sizes, so your tools must be metric.
CHECKING THE ENGINE OIL LEVEL
Parts (if level is low):

ªToyota Genuine Motor Oilº or equivalent
Oil grade: API grade SL ªEnergy±Conservingº or ILSAC
multigrade engine oil. For recommended oil viscosity, see page 335.
Tools:

Rag or paper towel

Funnel (only for adding oil)
CHECKING THE ENGINE COOLANT LEVEL
Parts (if level is low):

ªToyota Super Long Life Coolantº or similar high quality
ethylene glycol based non±silicate, non±amine, non±nitrite,
and non±borate coolant with long±life hybrid organic acid technology.
ªToyota Super Long Life Coolantº is a mixture of 50%
coolant and 50% deionized water (for the U.S.A.) or 55% coolant and 45% deionized water (for Canada).
Tools:

Funnel (only for adding coolant)
04 06.30

ENGINE
327
± LUBRICATION SYSTEM
Oil capacity Drain and refillwith filter
without filter
5.4 L (5.7 qt., 4.8 lmp.qt.)
5.1 L (5.4 qt., 4.5 lmp.qt.)
Oil gradeAPI grade SL ªEnergy±Conservingº or ILSAC multigrade engine oil\
Recommended oil viscosity (SAE):
62L005±1S
OIL14
Outside temperature
NOTE:
ªToyota Genuine Motor Oilº is used in your Lexus vehicle. Use Lexus app\
roved ªToyota Genuine Motor Oilº or equivalent to satisf y
the above grade and viscosity. Please contact your Lexus dealer for further details.
04 06.30

ENGINE
332The amount of engine oil consumed depends on the
viscosity of the oil, the quality of the oil and the way the
vehicle is driven.
More oil is consumed under driving conditions such as high
speeds and frequent acceleration and deceleration.
A new engine consumes more oil, since its pistons, piston rings
and cylinder walls have not become conditioned.
Oil consumption:
Max. 1.0L per 1000 km (1.1 qts./600 miles,
0.9 Imp. qts./600 miles)
When judging the amount of oil consumption, keep in
mind that the oil may have become diluted, making it
difficult to judge the true level accurately.
For example, if a vehicle is used for repeated short trips and
consumes a normal amount of oil, the dipstick may not show
any drop in the oil level at all, even after 1000 km (600 miles)
or more. This is because the oil is gradually becoming diluted
with fuel or moisture, making it appear that the oil level has not
changed.
The diluting ingredients evaporate out when the vehicle is then
driven at high speeds, as on an expressway, making it appear
that oil is excessively consumed after driving at high speeds.
Importance of engine oil level check
One of the most important points in proper vehicle
maintenance is to keep the engine oil at the optimum level so
that oil function will not be impaired. Therefore, it is essential
that the oil level be checked regularly. Lexus recommends that
the oil level be checked every time you refuel the vehicle.
NOTICE
Failure to check the oil level regularly could lead to serious engine trouble due to insufficient oil.
For detailed information on oil level check, see ªChecking the
engine oil levelº on page 333.
04 06.30

ENGINE
335
NOTICE
Be careful not to spill engine oil on the vehiclecomponents.
Avoid overfilling, or the engine could be damaged.Check the oil level on the dipstick once again afteradding the oil.
Engine oil selection
ªToyota Genuine Motor Oilº is used in your Lexus vehicle. Use
Lexus approved ªToyota Genuine Motor Oilº or equivalent to
satisfy the following grade and viscosity.
Oil grade:
API grade SL ªEnergy±Conservingº or ILSAC multigrade
engine oil.
Recommended viscosity (SAE):
SOIL14
Outside temperature
SAE 5W±30 is the best choice for good fuel economy, and
good starting in cold weather.
If SAE 5W±30 oil is not available, SAE 10W±30 oil may be
used. However, it should be replaced with SAE 5W±30 at
the next oil change.
04 06.30

ENGINE
336
Oil identification marks
SOIL11

API Service Symbol
ILSAC Certification Mark
Either or both API registered marks are added to some oil
containers to help you select the oil you should use.
The API Service Symbol is located anywhere on the outside
of the container.
The top portion of the label shows the oil quality by API
(American Petroleum Institute) designation such as SL. The
center portion of the label shows the SAE viscosity grade
such as SAE 5W±30. ªEnergy±Conservingº, shown in the
lower portion, indicates that the oil has fuel±saving capabilities.
 The ILSAC (International Lubricant Standardization and
Approval Committee) Certification Mark is displayed on the front of the container. To ensure excellent lubrication performance for your engine,
ªToyota Genuine Motor Oilº is available, which has been
specifically tested and approved for all Lexus engines.
Please contact your Lexus dealer for further details about
ªToyota Genuine Motor Oilº.
04 06.30

CHASSIS
342
SPECIFICATIONS
± MANUAL TRANSMISSIONOil capacity
2.6 L (2.7 qt., 2.3 lmp.qt.)
Oil typeMultipurpose gear oil API GL±4 or GL±5
Recommended oil viscositySAE 75W±90
± DIFFERENTIALOil capacity
1.15 L (1.22 qt., 1.01 lmp.qt.)
Oil typeHypoid gear oil API GL±5
Oil viscosityAbove ±18C (0F): SAE 90
Below ±18 C (0F): SAE 80W or SAE 80W±90
± AUTOMATIC TRANSMISSION
Fluid capacity Drain and refill
2.0 L (2.1 qt., 1.8 lmp.qt.)
Fluid typeToyota Genuine ATF Type T ± IV*
*:Change automatic transmission fluid only as necessary.
Generally, it is necessary to change automatic transmission
fluid only if your vehicle is driven under one of the Special
Operating Conditions listed in your ªOwner's Manual
Supplement/Scheduled Maintenanceº. When changing the
automatic transmission fluid, use only ªToyota Genuine ATF
Type T±IVº ( ATF JWS3309 or NWS6500) to aid in assuring
optimum transmission performance.NOTICE
Using automatic transmission fluid other than ªToyota Genuine ATF Type T±IVº may cause deterioration inshift quality, locking up of your transmissionaccompanied by vibration, and ultimately damage theautomatic transmission of your vehicle.
04 06.30

cv3
GAS STATION INFORMATION

Fuel selection:
Select premium unleaded gasoline with an Octane Rat-
ing of 91 (Research Octane Number 96) or higher for
optimum engine performance. However, if such pre-
mium type cannot be obtained, you may temporarily use
unleaded gasoline with an Octane Rating as low as 87
(Research Octane Number 91).

Fuel tank capacity:
66 L (17.5 gal., 14.5 lmp.gal.)

Engine oil:
ªToyota Genuine Motor Oilº or equivalent
Oil grade: API grade SL ªEnergy±Conservingº or ILSAC
multigrade engine oil.
Recommend oil viscosity ± SAE 5W±30 if normal
temperatures are below 38 C (100F)
Oil capacity: L (qt., lmp.qt.)
Drain and refill with filter 5.4 (5.7, 4.8)
without filter 5.1 (5.4, 4.5)
See page 335 for detailed information.

Engine coolant:
Capacity: 7.5 L (7.9 qt., 6.6 lmp.qt.)
Coolant type ± ªToyota Super Long Life Coolantº or
similar high quality ethylene glycol based non±silicate,
non±amine, non±nitrite, and non±borate coolant with
long±life hybrid organic acid technology. (Coolant with
long±life hybrid organic acid technology is a
combination of low phosphates and organic acids.)
Do not use plain water alone. For checking the engine coolant, see page 337.

Automatic transmission:
Fluid type ± Toyota Genuine ATF Type T±IV
See page 342 for detailed information.

Tire information:
See page 351 through 374 for detailed information.

Tire inflation pressure:
Tire size: 225/45ZR17, 215/45ZR17 or P205/55R16 89V
Tire pressure: cold tires
kPa (kgf/cm
2 or bar, psi)
Ti
re sizeFrontRear
225/45ZR17 ± 240 (2.4, 35)
215/45ZR17 230 (2.3, 33) 230 (2.3, 33)
P205/55R16 89V 230 (2.3, 33) 230 (2.3, 33)
For sustained high speeds above 160 km/h (100 mph), in
countries where such speeds are permitted by law, add the
tire pressure given below to the front tires and rear tires, but
never exceed the maximum cold tire pressure molded on the tire sidewall.
225/45ZR17 70kPa (0.8 kgf/cm
2, 0.7 bar, 10 psi)
215/45ZR17 70kPa (0.8 kgf/cm2, 0.7 bar, 10 psi)
P205/55R16 89V
Sedan 70kPa (0.8 kgf/cm
2, 0.7 bar, 10 psi)
SportCross Front: 70kPa (0.8 kgf/cm2, 0.7 bar, 10 psi)
Rear: 90kPa (0.9 kgf/cm2, 0.9 bar, 15 psi)
04 06.30