EXTERIOR EQUIPMENT
11 8The moon roof also can be opened using the wireless remote
control. For details, see page 19.
Jam protection function
If something gets caught between the moon roof and frame
during slide closing operation, the moon roof stops and
opens half way, and the deflector stops and raises fully.
If something gets caught between the moon roof and frame
during tilting down operation, the moon roof stops and
opens fully.
If the moon roof receives a strong impact, this function may
work even if nothing is caught.
If the battery is disconnected or run down
The moon roof may not operate automatically and the jam
protection function will not function correctly after you
reconnect, replace or recharge the battery. In any of these
cases, you should normalize the moon roof.
To normalize the moon roof, push and hold the switch on the
ªTILT UPº side until the moon roof tilts all the way up and then
tilts down a little automatically.
Make sure that the moon roof opens and closes automatically.
If the moon roof cannot be operated properly, have it checked
by your Lexus dealer.
CAUTION
To avoid serious personal injury, you must do the
following.
While the vehicle is moving, always keep the heads,
hands and other parts of the bodies of all occupants
away from the roof opening. Otherwise, they could
be seriously injured if the vehicle stops suddenly or
if the vehicle is involved in an accident.
Before you close the moon roof, always make sure
there is nobody around the moon roof. You must also
make sure nobody places his or her head, hands and
other parts of the body in the roof opening. If
someone's neck, head or hands get caught in the
closing roof, it could result in death or serious injury.
When anyone closes the moon roof, first make sure
it is safe to do so.
Be sure to remove the ignition key when you leave
your vehicle.
Never leave anyone (particularly a small child) alone
in your vehicle, especially with the ignition key still
inserted. Otherwise, he/she could use the moon roof
switch and get trapped in the roof opening.
Unattended p erson (particularly a small child) can be
involved in a serious accident.
Never sit on top of the vehicle around the roof
opening.
OCCUPANT RESTRAINT SYSTEMS
165
This indicator comes on when the ignition key is turned to
the ªONº position. It goes off after about 6 seconds. This
means the seat belt pretensioners are operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver's seat position sensor, driver's seat belt buckle switch,
front passenger occupant classification system, ªAIRBAG ONº
indicator light, ªAIRBAG OFFº indicator light, front passenger's
seat belt buckle switch, front seat belt pretensioner
assemblies, inflators, warning light, ªRSCA OFFº indicator
light, interconnecting wiring and power sources. (For details,
see ªService reminder indicators and warning buzzersº on
page 62.) If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.
The light does not come on when the ignition key is turned
to the ªONº position or remains on for more than 6 seconds
or flashes.
The light comes on or starts flashing while driving.
If either front seat belt does not retract or cannot be pulled
out due to a malfunction or activation of the relevant front
seat belt pretensioner.
The front seat belt pretensioner assembly or surrounding
area has been damaged.
OCCUPANT RESTRAINT SYSTEMS
176
The indicator comes on when the ignition key is turned to
the ªONº position. It goes off after about 6 seconds. This
means the SRS front airbags are operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver's seat position sensor, driver's seat belt buckle switch,
front passenger occupant classification system, ªAIRBAG ONº
indicator light, ªAIRBAG OFFº indicator light, front passenger's
seat belt buckle switch, front seat belt pretensioner
assemblies, inflators, warning light, ªRSCA OFFº indicator
light, interconnecting wiring and power sources. (For details,
see ªService reminder indicators and warning buzzersº on
page 62.) If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.
The light does not come on when the ignition key is turned
to the ªONº position or remains on for more than 6 seconds
or flashes.
The light comes on or starts flashing while driving.
The SRS warning light and ªAIRBAG OFFº indicator light will
be illuminated if there is a malfunction in the front passenger
occupant classification system.
OCCUPANT RESTRAINT SYSTEMS
192
The indicator comes on when the ignition key is turned to
the ªONº position. It goes off after about 6 seconds. This
means the SRS side airbags and curtain shield airbags are
operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver's seat position sensor, driver's seat belt buckle switch,
front passenger occupant classification system, ªAIRBAG ONº
indicator light, ªAIRBAG OFFº indicator light, front passenger's
seat belt buckle switch, front seat belt pretensioner
assemblies, inflators, warning light, ªRSCA OFFº indicator
light, interconnecting wiring and power sources. (For details,
see ªService reminder indicators and warning buzzersº on
page 62 for instructions.) If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.
The light does not come on when the ignition key is turned
to the ªONº position or remains on for more than 6 seconds
or flashes.
The light comes on or starts flashing while driving.
The SRS warning light and ªAIRBAG OFFº indicator light will
be illuminated if there is a malfunction in the front passenger
occupant classification system.
OCCUPANT RESTRAINT SYSTEMS
194
FRONT PASSENGER OCCUPANTCLASSIFICATION SYSTEM
Your vehicle is equipped with a front passenger occupant
classification system. This system detects the conditions
1 Ð 4 in the table shown below, and based on these
conditions activates or deactivates the airbags. The
system monitors the weight and load on the front
passenger seat, and the seat belt buckle switch in
determining conditions 1 Ð 4.
In order for the system to detect the conditions correctly,
do not do any of the following:
Apply a heavy load to the front passenger seat or equipment
(e.g. armrest).
Attach a commercial seatback table, etc. to the front
passenger seatback.
Put weight on the front passenger seat by putting your
hands or feet on the seat seatback from the rear passenger
seat.
The ªAIRBAG OFFº indicator lights will be illuminated
when the ignition switch is in the ªONº position and a child
or child restraint system is in the front passenger seat (see
table±condition 2). This indicates that in the event of a
severe frontal or passenger's side impact, the front
passenger airbag and side airbag on the front passenger
seat are deactivated and will not deploy.
OCCUPANT RESTRAINT SYSTEMS
195
If the front passenger occupant classification system
determines that a person of adult size sits in the front
passenger seat but the ªAIRBAG OFFº indicator light is
illuminated, one of the following is likely to have occurred:
The rear passenger lifts the front passenger seat cushion
with their legs.
Objects are placed under the front passenger seat.
A front passenger seat seatback is in contact with a rear
seat.
To ensure the system correctly detects an adult sitting in the
front passenger seat, make sure the above do not occur.
Make sure the ªAIRBAG ONº indicator light is illuminated when
an adult sits in the front passenger seat. If the ªAIRBAG OFFº
indicator light is illuminated, ask the passenger to sit up
straight, well back in the seat, and with the seat belt worn
correctly. If the ªAIRBAG OFFº indicator light still remains
illuminated, either ask the passenger to move to the rear seat,
or if that is not possible, move the front passenger seat fully
rearward. The ªAIRBAG ONº and ªAIRBAG OFFº indicator light will
be initially illuminated when the ignition switch is turned
to the ªONº position. It will remain for about four seconds
and then go off. After about two seconds, the front
passenger occupant classification system operates and
judges whether to turn the indicator light on or not.
The SRS warning light and ªAIRBAG OFFº indicator light
will be illuminated if there is a malfunction in the front
passenger occupant classification system.
OCCUPANT RESTRAINT SYSTEMS
199
ROLL SENSING OF CURTAIN
SHIELD AIRBAGS OFF SWITCH
The roll sensing of curtain shield airbags off switch
(ªRSCA OFFº switch) can turn off the curtain shield
airbags and seat belt pretensioners in a vehicle rollover.
This switch should only be used if inflation is not desired
(such as extreme off±road driving).
When you push the ªRSCA OFFº switch for a few seconds with
the ignition switch on, the ªRSCA OFFº indicator light comes
on and the roll sensing function is turned off. When you push
the switch again, the indicator light goes off and the roll sensing
function is turned on. (For details about the roll sensing
function, see ªSRS side airbags and curtain shield airbagsº on
page 179.) In a severe side impact, the curtain shield airbags on impacted
side will inflate even if the roll sensing function is turned off.
(For details about the curtain shield airbags, see ªSRS side
airbags and curtain shield airbagsº on page 179.)
In a severe frontal impact, the seat belt pretensioners will work
even if the roll sensing function is turned off. (For details about
the seat belt pretensioners, see ªSeat belt pretensionersº on
page 162.)
If the ignition switch is turned to ªACCº or ªLOCKº with the\
roll
sensing
function off and then the ignition switch is turned back
to ªONº, the roll sensing function will turn back on
automatically.CAUTION
Before normal driving, make sure the ªRSCA OFFº
indicator light is off.
When the roll sensing function is turned off (and the
ªRSCA OFFº indicator light is on), the curtain shield
airbags and seat belt pretensioners will not work in
a vehicle rollover. Turning off the curtain shield
airbags and seat belt pretensioners reduces
occupant protection which your vehicle safety
systems can provide in accidents and increase the
likelihood of death or serious injuries.
OCCUPANT RESTRAINT SYSTEMS
208
4. To remove the infant seat, press the buckle release button
and allow the belt to retract completely. The belt will move
freely again and be ready to work for an adult or older child
passenger.(B) Convertible seat installation
A convertible seat must be used in forward±facing or
rear±facing
position depending on the age and size of the
child. When installing, follow the manufacturer's
instructions about the appropriate age and size of the
child as well as directions for installing the child restraint
system.
Install the child restraint system on the front passenger seat
only when it is unavoidable. Your vehicle is equipped with a
front passenger occupant classification system. In order to
activate the occupant classification system correctly, install the
forward±facing child restraint system on the front passenger
seat in the following order:
1. Turn the ignition key to the ªONº position.
2. Move the front passenger seat to the rearward position.
3. Put the child restraint system on the front passenger seat
without putting your weight on the front passenger seat.
4. Insert the seat belt tab into the seat belt buckle.