2005 KIA Rio run flat

Knowing Your Vehicle3-34Tether Anchor Installation
Your vehicle is equipped with an anchor for securing
the tether strap of a child restraint system (child seat).
The child restraint anchor fittings are installed on the
shelf behind the rear seat or in the trunk on the inboard
side of the rear bumper in the 5-door hatchback.
2FDA304/2FDA305
Child Seat Anchorage PositionFor small children and babies, the use of a child seat or
infant seat is strongly recommended. This child seat or
infant seat should be of appropriate size for the child
and should be installed in accordance with the manu-
facturer’s instructions. It is further recommended that
the seat be placed in the vehicle’s rear seat since this
can make an important contribution to safety. Your
vehicle is provided with three child restraint hook
holders on the package tray behind the rear seat for
installing the child seat or infant seat.
WARNING - Child Restraint
Placement
Never use a child restraint in the front passen-
ger seat. A child in a child restraint installed in
the front passenger seat can be severely or
fatally injured by an air bag which could
impact the child restraint with great force
when the air bag inflates.
WARNING
If the tether strap is clipped incorrectly, the
child restraint seat may not be restrained
properly in the event of a collision.
RIO ENG CNA 3.qxd 7/29/05 5:13 PM Page 34

Suggestions for Economical
OperationYour vehicle’s fuel economy is mainly dependent on
your style of driving, how you drive, where you drive
and when you drive.
Each of these factors has an effect on how many miles
(kilometers) you can get from a gallon (liter) of fuel.
To operate your vehicle as economically as possible,
use the following driving suggestions to help save
money in both fuel and repairs:
 Avoid lengthy warm-up idling. Once the engine
is running smoothly, begin driving. Remember,
though, that on cold days, engine warm-up may take
a little longer.
 Save fuel by accelerating slowly after stopping.
 Keep the engine in tune and follow the
recommended periodic maintenance schedule.
This will increase the life of all parts and lower your
operating costs.
 Do not use the air conditioner unnecessarily.
 Slow down when driving on rough roads. For longer tire life and better fuel economy, always
keep the tires inflated to the recommended
pressures.
 Maintain a safe distance from other vehicles to
avoid sudden stops. This will reduce wear on brake
linings and pads and save fuel because extra fuel is
required to accelerate back to driving speed.
 Do not carry unnecessary weight in the vehicle.
 Do not rest your foot on the brake pedal while
driving. This can cause needless wear, possible
damage to the brakes, and poor fuel economy.
 Improper wheel alignment causes the tires to roll
at excessive angles, which results in faster tire wear.
It takes more power to overcome this improper
alignment, which wastes fuel.
 Open windows at high speeds can reduce fuel
economy.
 Crosswinds and headwinds reduce fuel economy. To
help offset some of this loss, slow down when
driving in these conditions.Driving Tips5-6
RIO ENG CNA 5.qxd 7/29/05 5:07 PM Page 6

In Case Of An Emergency6-16If You Have a Flat TireStoring the Spare Tire, Jack and ToolsThe spare tire, tool bag, jack and jack handle are stored
in the trunk compartment. Move the carpeting out of
the way to reach this equipment.
ARSB06002A
ARSB06002
Spare tire
Jack
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 16

6-19 Changing Tires
Jacking Instructions
The jack is provided for emergency tire changing only.
Follow jacking instructions to reduce the possibility of
personal injury.Tire Replacement
1. Park on a level surface and set the parking brake
firmly.
2. Set the automatic transaxle in P (Park), or shift the
manual transaxle into R (Reverse).
3. Activate the hazard warning flasher.
4. Remove the wheel lug nut wrench, jack, jack
handle, and spare tire from the vehicle.
5. Block both the front and rear of the wheel that is
diagonally opposite the jack position.
WARNING - Changing Tires
 Never attempt vehicle repairs or a tire
change in the traffic lanes of a public road or
highway. Always move the vehicle completely
off the road and onto the shoulder before
trying to change a tire. If you cannot find a
firm, level place off the road, call a towing
service company for assistance.
 Do not exceed the maximum permissible
load of the jack: 600 kg. (1,320 lbs).
 Be sure to use the correct front or rear
jacking positions on the vehicle; never use
the bumpers or any other part of the vehicle
for jack support.
 Never allow any portion of your body to get
beneath the vehicle while using the jack.
 Do not start or run the engine while the
vehicle is supported by the jack.
AS2B06012
Flat tire
Wheel block
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 19

Index
9-1
A
ir Bag - Supplemental Restraint System.....................3-46
Air Cleaner ......................................................................7-27
Automatic Transaxle................................................4-9, 7-23
Battery ............................................................................7-31
Before Driving ..................................................................5-4
Brake System ..................................................................4-15
Brakes and Clutch ...........................................................7-20
Bulb Replacement ...........................................................7-42C
limate Control System ................................................4-44
Connection Jumper Cables ...............................................6-5
Cup Holders and Console Storage Compartment ...........3-66
D
aytime Running Lights(DRL) .....................................4-35
Door Locks........................................................................3-5
Electrical Circuit Protection ............................................6-7
Emergency Starting ...........................................................6-4Emission Control System..................................................5-3
Engine Compartment ......................................................7-13
Engine Cooling System ..................................................7-16
Engine Oil and Oil Filter ................................................7-14
Exterior Care ...................................................................7-49
Fuel Filler Door .............................................................3-59
Fuel Requirements ............................................................5-2G
auges ...........................................................................4-25
H
ood ..............................................................................3-57
How To Use This Manual .................................................1-2
If You Have a Flat Tire ..................................................6-16
Ignition Switch ..................................................................4-2
Instrument Cluster...........................................................4-23
Instrument Panel Overview ..............................................2-4
Interior and Exterior Overview .........................................2-2
9
RIO ENG CNA 9.qxd 7/29/05 5:19 PM Page 9-1