DRIVING YOUR HYUNDAI
32
TO START THE ENGINE
KEY POSITIONS
BEFORE STARTING THE ENGINE
!
C020A01A-AATBefore you start the engine, you should always:
1. Look around the vehicle to be sure there are
no flat tires, puddles of oil, water or other
indications of possible trouble.
2. After entering the car, check to be sure the
parking brake is engaged.
3. Check that all windows and lights are clean.
4. Check that the interior and exterior mirrors
are clean and in position.
5. Check your seat, seatback and headrest to
be sure they are in their proper positions.
6. Lock all the doors.
7. Fasten your seat belt and be sure that all
other occupants have fastened theirs.
8. Turn off all lights and accessories that are
not needed.
9. When you turn the ignition switch to "ON",
check that all appropriate warning lights are
operating and that you have sufficient fuel.
10.Check the operation of warning lights and all
bulbs when key is in the "ON" position.
C030A01A-AATCOMBINATION IGNITION SWITCHo If your Hyundai is equipped with a manual
transaxle, place the shift lever in neutral and
depress the clutch pedal fully.
o If your Hyundai has an automatic transaxle,
place the shift lever in "P" (park).
o To start the engine, insert the ignition key and
turn it to the "START" position. Release it as
soon as the engine starts. Do not hold the
key in the "START" position for more than 15
seconds.NOTE:o For safety, the engine will not start if the
clutch pedal is not depressed fully
(Manual Transaxle) or the shift lever is
not in "P" or "N" Position (Automatic
Transaxle).
o The ignition key cannot be turned from
"ACC" position to "LOCK" position un-
less the shift lever is in the "P" (Park)
position or the negative battery terminal
is disconnected from the battery. To
remove the key, always confirm that the
shift lever is securely positioned in "P"
(Park) (For Automatic Transaxle)
o For additional information about start-
ing, see page 2-4.
C040A01A-AAT
WARNING:
The engine should not be turned off or the
key removed from the ignition key cylinder
while the vehicle is in motion. The steering
wheel is locked by removing the key.o "START"The engine is started in this position. It will crank
until you release the key.
C040A01E-1
LOCKACC
ON
START
xdflhma-2.p652/5/2008, 2:08 PM 3
6
DO-IT-YOURSELF MAINTENANCE
31
G270E01E-AATSIDE MARKER LIGHT1. Remove the cover with a flat blade screw-
driver.2. Disconnect the power cord.
3. Replace with a new bulb.
HXDFL338HXDFL339
HXDFL340G270G01E-GAT
INTERIOR LIGHT
Room Light1. Remove the plastic cover with a flat blade
screwdriver.
HXDFL1020
Screwdriver
xdflhma-6.p652/5/2008, 2:14 PM 31
6
DO-IT-YOURSELF MAINTENANCE
33
Soket type
-
S8.5/8.5
S8.5/8.5
BA 15s
BAY 15d
BAY 15d
W2.1 x 9.5D
BA 15s Soket type
P14,5s/PX 26d
P22d
BA15s
W2.1x9.5d
W2.1x9.5D
S8.5/8.5
W2.1x9.5d
BA 15s
BULB WATTAGEG280A04E-AAT
23 678
G280A03E-A
(High beam)(Low beam)4 DOOR 5 DOOR
1
1512 7
4
9 10
9
10 118
Wattage
55/55
51
27
5
10
10
5Part Name
High Mounted Stop Light
Luggage Compartment Light
License Plate Light
Rear
Combination Light
Tail Light
Back-up Light Part Name
Head Light (High/Low)
Front Fog Light
Front Turn Signal Light
Side Marker Light
Interior
Front Door Edge Warning Light
High Mounted Stop Light
No.
1
2
3
4
5
6
7
Wattage
5
5
27
27/8
8
Map Light
Room Light
No.
7
8
9
10
11
12
5 Door 2.6(LED)
Turn Signal Light
Stop/Tail Light
4 Door
5 Door16
27
4 Door 16
xdflhma-6.p652/5/2008, 2:15 PM 33
