2005 HONDA S2000 spare tire

[x] Cancel search: spare tire

Page 151 of 209

HONDA S2000 2005 2.G Owners Manual Keeping the tires properly inf lated
provides the best combination of
handling, tread lif e, and riding
comf ort.Underinf lated tires wear unevenly,
adversely affect handling and fuel
economy, and are

Page 152 of 209

HONDA S2000 2005 2.G Owners Manual Bumps or bulges in the tread or
side of the tire. Replace the tire if
youfindeitherof theseconditions.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see f abric or cord.

Page 159 of 209

HONDA S2000 2005 2.G Owners Manual This section covers the more
common problems that motorists
experience with their vehicles. It
gives you inf ormation about how to
safely evaluate the problem and what
to do to correct it. If the prob

Page 160 of 209

HONDA S2000 2005 2.G Owners Manual Use the compact spare tire as a
temporary replacement only. Get
your regular tire repaired or replaced,
and put it back on your vehicle as
soon as you can.Follow these precautions:
Replace the tire wh

Page 161 of 209

HONDA S2000 2005 2.G Owners Manual If you have a f lat tire while driving,
stop in a saf e place to change it.
Drive slowly along the shoulder until
you get to an exit or an area that is
far away from the traffic lanes.Thesizedifferenc

Page 162 of 209

HONDA S2000 2005 2.G Owners Manual Unscrew the wing bolt, and take
the spare tire out of the spare tire
shelf .
Remove the three clips holding
the spare tire cover by pulling the
rings straight back. Remove the
sparetirecover.
Loosen e

Page 163 of 209

HONDA S2000 2005 2.G Owners Manual Use the extension and the wheel
nut wrench as shown to raise the
vehicle until the f lat tire is of f the
ground.Bef ore mounting the spare tire,
wipeanydirtoff themounting
surface of the wheel and hu

Page 164 of 209

HONDA S2000 2005 2.G Owners Manual Put on the spare tire. Put the
wheel nuts back on f inger-tight,
then tighten them in a crisscross
pattern with the wheel nut wrench
until the wheel is f irmly against
the hub. Do not try to tighten
t
Page:   1-8 9-16 next >