2005 HONDA S2000 oil additives

Help assure your vehicle’s f uture
reliability and perf ormance by paying
extra attention to how you drive
during the f irst 600 miles (1,000 km).
During this period:Avoid full-throttle starts and rapid
acceleration. Do not exceed 5,500
rpm f or the f irst 600 miles (1,000
km) of operation.
You should also f ollow these
recommendations with an
overhauled or exchanged engine, or
when the brakes are replaced. Avoidhardbrakingforthefirst
200 miles (300 km). Do not change the oil until the
scheduled maintenance time. Your vehicle is designed to operate
on premium unleaded gasoline with a
pump octane of 91 or higher. Use of
a lower octane gasoline can cause
occasional metallic knocking noises
in the engine and will result in
decreased engine perf ormance. Use
of a gasoline with a pump octane less
than 86 can lead to engine damage.
We recommend quality gasoline
containing detergent additives that
help prevent f uel system and engine
deposits.
In addition, in order to maintain good
perf ormance, f uel economy, and
emissions control, we strongly
recommend, in areas where it is
available, the use of gasoline that
does NOT contain manganese-based
f uel additives such as MMT.
Use of gasoline with these additives
may adversely af f ect perf ormance, and cause the Malfunction Indicator
Lamp on your instrument panel to
come on. If this happens, contact
your authorized dealer f or service.
Some gasoline today is blended with
oxygenates such as ethanol or
MTBE. Your vehicle is designed to
operate on oxygenated gasoline
containing up to 10 percent ethanol
by volume and up to 15 percent
MTBE by volume. Do not use
gasoline containing methanol.
If you notice any undesirable
operating symptoms, try another
service station or switch to another
brand of gasoline.
For f urther important f uel-related
inf ormation, please ref er to your
.
Break-in Period
Fuel Recommendation
Quick Start Guide
Break-in Period, Fuel Recommendation
100

µ
The oil’s viscosity or weight is
provided on the container’s label.
Select the oil f or your vehicle
according to this chart.
An oil with a viscosity of 10W-30 is
pref erred f or optimum f uel economy
and year-round protection in your
vehicle. You may use a 5W-40 oil if
the temperature in your area goes
below 0°F ( 20°C).
You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil: it
displays the API Certif ication Seal,
and it is the proper weight. You must
f ollow the oil and f ilter change
intervals given on the maintenance
schedule.
Your vehicle does not require any oil
additives. Additives may adversely
af f ect your engine’s or transmission’s
perf ormance and durability.
Always change the oil and f ilter
according to the recommendations in
the maintenance schedule. The oil
and f ilter collect contaminants that
can damage your engine if they are
not removed regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.
Run the engine until it reaches
normal operating temperature,
then shut it off.
1.
A dding Engine Oil, Changing the Oil and Filter
Synthetic Oil
Engine Oil A dditives Changing the Oil and Filter
132
Ambient Temperature

If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stiffer shifting. Replace as
soon as it is convenient.
The transmission should be drained
and ref illed with new f luid according
to the time and distance recommen-
dations in the maintenance schedule.
If you are not sure how to check and
add f luid, contact your dealer.
Check the f luid level with the
transmission at normal operating
temperature and the vehicle sitting
on level ground. Remove the
transmission f iller bolt, and caref ully
f eel inside the bolt hole with your
f inger. The f luid level should be up
to the edge of the bolt hole. If it is
not, add Honda Manual
Transmission Fluid (MTF) until it
starts to run out of the hole. Install
the f iller bolt, and tighten it securely.
Manual T ransmission Fluid
Maint enance
137
CORRECT LEVEL
FILLER BOLT

CONT INUED
....................................
Accessories .105
ACCESSORY (Ignition Key .......................................
Position) .53
...............
Accessory Power Socket . 69
....................
Additives, Engine Oil . 132
...............................
Airbag (SRS) .9, 19
................
Air Conditioning System . 74
............................................
Usage .76
.......................
Air Pressure, Tires .150
.......................
Alcohol in Gasoline .100
......................................
Antif reeze .134
Anti-lock Brakes (ABS) ...............................
Indicator .41, 119
...................................
Operation .118
.
Anti-thef t Steering Column Lock . 53
............................
Anti-thef t System .94
......................................
Audio Panel .70
..................................
Audio System .78
...
Automatic Seat Belt Tensioners . 17
...............
Automatic Speed Control . 95
........
Back-up Light Replacement . 144Battery
Charging System ...........................
Indicator .40, 170
............................
Jump Starting .166
..............................
Maintenance .154
............................
Specif ications .185
................................
Bef ore Driving .99
....................................
Belts,Seat .8,16
.............................
Beverage Holder .69
..................................
Booster Seats .32
............................................
Brakes .117
...........
Anti-lock System (ABS) . 118
.............
Break-in, New Linings . 100
...........................................
Fluid .139
.........................................
Parking .67
..........................
System Design .118
.................
System Indicator . 40,172
........................
Wear Indicators .118
.............................
Braking System .117
.................
Break-in, New Vehicle . 100
..
Brightness Control, Instruments . 49
........................
Brights, Headlights .48
.........................
Bulb Replacement .140
..........................
Back-up Lights .144
.................................
Headlights .140
...........
Side Turn Signal Lights . 143............................
Specif ications .185
............
Turn Signal Lights . 142,144
..............................
Bulbs, Halogen .140
............................
Capacities Chart .184
.............
Carbon Monoxide Hazard . 35
....................
Cargo, How to Carry .107
..............
CAUTION, Explanation of . ii
...........................................
CD Care .90
.....................................
CD Changer .90
.......
CD Changer Error Messages . 92
........................
CD Error Messages .91
.........................................
CD Player .88
........................
Certif ication Label .182
.................................
Chains, Tires .153
....................
Changing a Flat Tire .159
Changing Oil ........................................
How to .132
......................................
When to .125
...
Charging System Indicator . 40,170
............
Checklist, Bef ore Driving . 113
Index
B A
C
INDEX
I