2005 HONDA CIVIC SEDAN oil additives

Help assure your vehicle’s f uture
reliability and perf ormance by paying
extra attention to how you drive
during the f irst 600 miles (1,000 km).
During this period:Avoid full-throttle starts and rapid
acceleration.
Avoidhardbrakingforthefirst
200 miles (300 km).
Do not change the oil until the
scheduled maintenance time.
You should also f ollow these
recommendations with an
overhauled or exchanged engine, or
when the brakes are replaced. You may hear a knocking noise from
the engine if you drive the vehicle at
low engine speed (below about 1,000
rpm) in a higher gear. To stop this,
raise the engine speed by shif ting to
a lower gear.
We recommend using gasoline
containing detergent additives that
help prevent f uel system and engine
deposits.
In addition, in order to maintain good
perf ormance, f uel economy, and
emissions control, we strongly
recommend, in areas where it isavailable, the use of gasoline that
does NOT contain manganese-based
f uel additives such as MMT.
Use of gasoline with these additives
may adversely af f ect perf ormance,
and cause the Malfunction Indicator
Lamp on your instrument panel to
come on. If this happens, contact
your dealer f or service.
Some gasoline today is blended with
oxygenates such as ethanol or
MTBE. Your vehicle is designed to
operate on oxygenated gasoline
containing up to 10 percent ethanol
by volume and up to 15 percent
MTBE by volume. Do not use
gasoline containing methanol.
If you notice any undesirable
operating symptoms, try another
service station or switch to another
brand of gasoline.
For f urther important f uel-related
inf ormation, please ref er to your
.
Your vehicle is designed to operate
on unleaded gasoline with a pump
octane number of 86 or higher. Use
of a lower octane gasoline can cause
a persistent, heavy, metallic rapping
noise in the engine that can lead to
mechanical f ailure.
On vehicles with manual transmission
Break-in Period
Fuel Recommendation
Quick Start Guide
Break-in Period, Fuel Recommendation
122

Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.
Always change the oil and f ilter
according to the recommendations in
the maintenance schedule. The oil
and f ilter collect contaminants that
can damage your engine if they are
not removed regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.
You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil: it
displays the API Certif ication Seal,
and it is the proper weight. You must
f ollow the oil and f ilter change
intervals given on the maintenance
schedule.
Your vehicle does not require any oil
additives. Additives may adversely
af f ect your engine’s or transmission’s
perf ormance and durability.
1.
2.
Changing the Oil and Filter
Synthetic Oil
Engine Oil A dditives
A dding Engine Oil, Changing the Oil and Filter
Maint enance
155
DRAIN BOLT WASHER

µµ
If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certif ication seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stiffer shifting. Replace as
soon as it is convenient.
The transmission should be drained
and ref illed with new f luid according
to the time and distance recommen-
dations in the maintenance schedule.
In very high temperatures
(over 110°F, 43°C).
In very low temperatures
(under 20°F, 29°C).
Check the f luid level with the
transmission at normal operating
temperature and the vehicle sitting
on level ground. Remove the
transmission f iller bolt, and caref ully
f eel inside the bolt hole with your
f inger. The f luid level should be up
to the edge of the bolt hole. If it is
not, add Honda Manual
Transmission Fluid (MTF) until it
starts to run out of the hole. Reinstall
the f iller bolt, and tighten it securely. The timing belt should be replaced
at the intervals shown in the
maintenance schedule. Replace the
belt at 60,000 miles (100,000 km) if
you regularly drive your vehicle in
one or more of these conditions:
Manual T ransmission Fluid, T iming Belt
Timing Belt
Manual Transmission Fluid
160
FILLER BOLT
Correct Level

CONT INUED
....................................
Accessories .127
ACCESSORY (Ignition Key .......................................
Position) .71
...............
Accessory Power Socket . 86
....................
Additives, Engine Oil . 155
.............................
Airbag (SRS) .11, 23
...
Airbags, Additional Information . 23
...
Additional Safety Precautions . 29
.............................
Airbag Service .28
How the Side Airbag Cutof f ......................
Indicator Works .28
..
How the SRS Indicator Works . 27
How Your Front Airbags .........................................
Work .24
...
How Your Side Airbags Work . 26
........................
SRS Components .23
................
Air Conditioning System . 88
.......................
Air Pressure, Tires .173
..................
High Speed Driving . 173
.........................
Normal Driving .173
.......................
Alcohol in Gasoline .213
......................................
Antif reeze .157
Anti-lock Brakes (ABS) ...............................
Indicator .57, 143 ...................................
Operation .143
..............
Anti-thef t, Audio System . 114
Anti-thef t Steering Column ..............................................
Lock .71
..................................
Audio System .92
...
Automatic Seat Belt Tensioners . 21
.............
Automatic Speed Control . 117
..............
Automatic Transmission . 138
..........................
Capacity, Fluid .208
...............
Checking Fluid Level . 159
.......................................
Shif ting .138
.
Shif t Lever Position Indicator . 138
................
Shif t Lever Positions . 138
....................
Shif t Lock Release . 140
Battery Charging System ...........................
Indicator .56, 194
............................
Jump Starting .190
..............................
Maintenance .178
............................
Specif ications .209
..............................
Bef ore Driving .121
..................................
Belts, Seat .10, 20
.............................
Beverage Holder .86 Brakes
...........
Anti-lock System (ABS) . 143
.............
Break-in, New Linings . 122
....................
Bulb Replacement .166
...........................................
Fluid .161
.......................................
Parking .141
.................
System Indicator . 57,196
........................
Wear Indicators .142
.............................
Braking System .142
.................
Break-in, New Vehicle . 122
..
Brightness Control, Instruments . 66
........................
Brights, Headlights .65
Bulb Replacement ..........................
Back-up Lights .167
..............................
Brake Lights .166
................
Front Parking Lights . 165
........
Front Side Marker Lights . 165
.................................
Headlights .163
.........
High-mount Brake Light . 168
.........
Rear Side Marker Lights . 166
............................
Specif ications .209
Bulb Replacement ....................
Turn Signal Lights . 165
..............................
Bulbs, Halogen .163
Index
A
B
INDEX
I