2005 HONDA CIVIC HYBRID clock

Your Vehicle at a Glance
4
ECON BUTTON
ACCESSORY POWER
SOCKET
HORN
HEADLIGHTS/TURN SIGNALS
REAR WINDOW
DEFOGGER
MIRROR CONTROLS WINDSHIELD WIPERS/WASHERS
HAZARD WARNING BUTTON
(P.
67)
(P. 65)
(P.
66)
(P. 68)
(P.69) AUDIO SYSTEM
CRUISE CONTROL
MASTER BUTTON
(P. 108)
(P. 80) (P.
108) (P.
83)
(P.
87)
(P.
107)
(P.
93)
CRUISE CONTROL BUTTONS CLOCK
STEERING WHEEL ADJUSTMENT

Control L ocations
50
HEATING/COOLING CONTROLS
FUEL FILL DOOR RELEASE
TRUNK RELEASE MIRROR
CONTROLS
HOOD RELEASE
HANDLE
POWER WINDOW
SWITCHES AUDIO SYSTEM
ACCESSORY POWER
SOCKET
(P. 74)
(P.
73)
(P. 79)
POWER DOOR LOCK
MASTER SWITCH
CRUISE CONTROL
MASTER BUTTON
(P. 108)
AT model is shown. (P.
113)
(P.115) (P.
108) (P.
83)
(P.
93)
CLOCK
(P. 107)
HAZARD WARNING BUTTON
(P.
67)
(P.
86)
(P. 80)
CRUISE CONTROL BUTTONS

´
Ü Õ
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR2025 To replace the battery, move the
round cover on the back of the
transmitter by turning it
counterclockwise with a coin. Insert
a new battery with the side facing
up. Install the cushion ring. Align the
mark on the cover with the
mark on the transmitter. Set
the cover in place and turn it
clockwise.
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.Replacing the Transmitter
Battery
Remote Transmitter
76
ROUND
COVER
CUSHION
RING
BATTERY

The standard audio system has
many f eatures. This section de-
scribes those f eatures and how to
use them. (If you selected an
optional audio system, ref er to the
operating instructions that came
with it.) The heating and air conditioning
systems in your vehicle provide a
comf ortable driving environment in
all weather conditions.
Your vehicle has an anti-theft audio
system that requires a code number
to enable it................
Vents, Heating, and A/C . 86
............................
Playing the Radio .93
..............................
Radio Reception .96
....................................
Playing a CD .98
.....................................
CD Changer .99
....................
Protecting Your CDs .100
.........
CD Player Error Messages . 101
.....
CD Changer Error Messages . 102
...............................
Playing a Tape .103
.................
Radio Thef t Protection . 106
..........................
Setting the Clock .107
...............................
Cruise Control .108
Features
Features
85

The outside air intakes f or the
heating and cooling system are at
the base of the windshield. Keep this
area clear of leaves and other debris.
ThesystemshouldbeleftinFresh
Air mode under almost all conditions.
Keeping the system in Recirculation
mode, particularly with the A/C of f ,
can cause the windows to fog up.
Switch to Recirculation mode when
driving through dusty or smoky
conditions, then return to Fresh Air
mode.Air flows from the center
and corner vents in the dashboard.
Air f lows f rom the f loor
vents. When you select , the
system automatically switches to
Fresh Air mode.
Air f lows f rom the def roster
vents at the base of the windshield.
When the dial is set to AUTO, the
system controls the f an speed
automatically.
Turning this dial clockwise increases
the temperature of the airflow.
When you select or ,
the system automatically switches to
Fresh Air mode and turns on the
A/C and turns off the ECON mode.
Turn this dial to increase or decrease
the fan speed and airflow.
This button turns the air
conditioning on and of f . The
indicatorinthebuttonisonwhen
the A/C is on.
When the recirculation indicator is
on, air f rom the vehicle’s interior is
sent throughout the system again.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (Fresh Air mode).
Use the mode control dial to select
the vents the air flows from. Some
air will f low f rom the dashboard
vents in all modes. Airf low is divided between
the vents in the dashboard and the
f loor vents.
Airf low is divided between
the f loor vents and the def roster
vents at the base of the windshield.
Fan Control Dial
Air Conditioning (A/C) Button T emperature Control Dial
Recirculation Button
Mode Control Dial
Vents, Heating, and A/C
88

If your vehicle’s battery is
disconnected or goes dead, you will
need to set the clock.Press and hold the CLOCK (SCAN/
RPT) button until you hear a beep.
Change the hours by pressing the H
(preset 4) button until the numbers
advance to the desired time. Change
the minutes by pressing the M
(preset 5) button until the numbers
advance to the desired time. When
you are f inished, press the CLOCK
button again.You can quickly set the time to the
nearest hour. If the displayed time is
bef ore the half hour, press the
CLOCK button until you hear a beep,
then press the R (preset 6) button to
settheclockbacktotheprevious
hour. If the displayed time is af ter
the half hour, the clock sets forward
to the beginning of the next hour.
For example: 1:06 will reset to 1:00
1:52 will reset to 2:00
Setting the Clock
Features
107
M BUTTON
H BUTTON
RESET BUTTON
CLOCK BUTTON

If the reserve tank is completely
empty, you should also check the
coolant level in the radiator.When the radiator and engine are
cool, relieve any pressure in the
cooling system by turning the
radiator cap counterclockwise,
without pressing down.
Remove the radiator cap by
pushing down and turning
counterclockwise.The coolant level should be up to
the base of the f iller neck. Add
coolant if it is low.
Do not add any rust inhibitors or
other additives to your vehicle’s
cooling system. They may not be
compatible with the coolant or
engine components. Pour coolant into the reserve tank.
Fill it to half way between the MAX
and MIN marks. Put the cap back
on the reserve tank. Put the radiator cap back on and
tighten it. Pourthecoolantslowlyand
caref ully so you do not spill. Clean
up any spill immediately; it could
damage components in the engine
compartment.
1.
2. 3.
4.
5.
Engine Coolant
154
RADIATOR CAP
Removing the radiator cap
while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.

Remove the electrical connector
f rom the bulb by pushing on the
tab and pulling the connector
down.
Remove the bulb by turning it one-
quarter turn counterclockwise.Insert the new bulb into the hole
and turn it one-quarter turn clock-
wise to lock it in place.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the headlights to test the
new bulb.
(Driver’s side)
Reinstall the upper part of the
windshield washer reservoir.
Install the holding clip on the stay
and lock it by pushing on the
center of clip.
If you are changing the bulb on
the driver’s side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger’s side, turn
the steering wheel to the left.
2. 4.
5.
6.
3. 7.
1.
Lights
Replacing the Front Side Marker/
Turn Signal and Parking L ight
Bulb
160
BULBCONNECTOR TAB HOLDING CLIP