2005 HONDA ACCORD display

ÛÝ
In the AUTO mode, the vehicle’s
interior temperature is
independently regulated f or the
driver and passenger. If the driver’s
side of the vehicle is getting too
much sun, the system will adjust to a
lower temperature.
Select . The system
automatically switches to f resh air
mode and turns on the A/C. The
A/C indicator will not come on if it
was off to start with.
Select .
Set the f an and temperature
controls to maximum level.
The automatic climate control
system adjusts the f an speed and
airflow levels to maintain the interior
temperature you select.
Press the Auto button. With
navigation system, the indicator in
the button comes on.
To clear the windows f aster, you can
close the dashboard corner vents by
rotating the wheel below each vent.
This sends more warm air to the
windshield def roster vents. Once the
windshield is clear, select f resh air
mode to avoid f ogging the windows.
For your saf ety, make sure you have
a clear view through all the windows
bef ore driving. Set the desired temperature by
pressing the to raise the
temperature or the to lower the
temperature. The selected
temperature will show in the upper
display.
Set the desired temperature by
turning the temperature control
dial. You will see AUTO in the
system’s display.
1.
1.
2.3. 2.
CONT INUED
With navigation system
Without navigation system
On EX with Leather and EX-V6 models
EX with Leather and EX-V6 models withnavigation system
Vents, Heating, and A/C
T o Remove Exterior Frost or Ice
From the Windows Automatic Climate Control
Features
111
——y
y
(%y

y

µ
In cold weather, the f an will not
come on automatically until the
heater starts to develop warm air. Making any manual selection causes
thewordAUTOinthedisplaytogo
out.
The system automatically selects the
proper mix of conditioned and/or
heated air that will, as quickly as
possible, raise or lower the interior
temperature to your pref erence.
You can manually select various
f unctions of the climate control
system when it is in f ully automatic
mode. All other f eatures remain
automatically controlled.
If you press the A/C button next to
the display, the manual selections
will show in the display. Making any
manual selection causes the
indicator in the AUTO button to turn
off.
When you set the temperature to its
lower limit ( ) or its upper limit
( ), the system runs at f ull
cooling or heating only. It does not
regulate the interior temperature.
When
the indicator in the dual button is on,
the driver’s side and passenger’s side
temperature can be controlled
independently (see page ). When the climate control system is
turned OFF, the temperature in the
upper display will also turn of f . To keep stale air and mustiness
f rom collecting, you should have
the f an running at all times.
Keep the system completely of f
f or short periods only.
Turningthefanspeedand
temperature control dials all the way
to the left shuts off the system
completely.
If you press OFF, the climate control
system shuts of f completely.
113
Without navigation system With navigation system
With navigation system
On EX with Leather and EX-V6 models Except EX with Leather and EX-V6
models
On EX with Leather and EX-V6 models
Vents, Heating, and A/C
To Turn Everything Of f
Semi-automatic Operation
Dual Temperature Control
112
——y
y
(%y

y

ÛÝÛÝ When you set the temperature to its
lower limit or its upper limit, it will be
displayed as or .
To set the driver’s side temperature
to a different value than the
passenger’s, press the DUAL button,
then turn the driver’s control dial or
press the or buttons on the
driver’s side. To set the passenger’s
side to a dif f erent value than the
driver’s, turn the passenger’s control
dial or press the or buttons on
the passenger’s side. You can adjust
the passenger’s side without
pressing the DUAL button first.
Push AUTO or . The selected
temperatures appears in the display
(in the upper display with the
navigation system). When the
indicator in the DUAL button is of f ,
you can adjust both sides to the
same temperature by adjusting the
driver’s side temperature control dial
or buttons.
Dual Temperature Control
T emperat ure Cont rol Dials/But t ons
114
DRIVER’S SIDE PASSENGER’S SIDE
——y
y
(%y

y

Playing the AM/FM Radio
118
AM/FM BUTTON
PWR/VOL KNOBSEEK BAR UPPER DISPLAY
AUDIO DISPLAY BUTTON TUNE/SOUND KNOB
SOUND ICON
AUDIO SELECT ICON
SCAN BUTTON
STEREO INDICATOR
SCAN ICONPRESET ICONS
EX with Leather and EX-V6 models
with navigation system (U.S. only)
——y
y
(%y

y

µ
µ
µ
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob or the AM/FM
button. Adjust the volume by turning
the PWR/VOL knob.
Pushing the AUDIO DISPLAY
button will also turn on the system.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
XM Satellite Radio inf ormation is
available on page . You can use any of f ive methods to
f ind radio stations on the selected
band: , , , the
preset bars/icons, and
. The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it, or
touch the SCAN icon (models with
navigation system). You will see
SCAN in the display. The system will
scan f or a station with a strong signal.
When it f inds one, it will stop and
play that station for about 5 seconds.
Use the TUNE bar or
knob to tune the radio to a desired
f requency. Press the side of the
bar or turn the knob right to tune to
a higher f requency, and press the side or turn the knob left to
tune to a lower f requency.
The SEEK f unction
searches up and down f rom the
current f requency to f ind a station
with a strong signal. To activate it,
press the or side of the
bar, then release it. If you do nothing, the system will
scan f or the next strong station and
play it f or 5 seconds. When it plays a
station you want to listen to, press
the SCAN button or touch the SCAN
icon again.
124
CONT INUED
On models with navigation system
To Select a Station T UNE SEEK SCA N AUTO
SEL ECT SCAN
TUNE SEEK
To Play the AM/FM Radio
Playing the AM/FM Radio
Features
119
——y
y
(%y
y

µµµ
µ
Each side of the bars (1
6) or preset icon can store one
f requency on AM, and two
f requencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each side of
the preset bar or each preset icon.
Press the SOUND button repeatedly
to display the bass (BAS), treble
(TRE), balance (BAL), and f ader
(FAD) settings. On models with
navigation system, touch the
SOUND icon or press the TUNE
knob.press the
A.SEL button or touch the AUTO
SELECTicon.Thisrestoresthe
presets you originally set.
If you do not like the stations auto
select has stored, you can store
other f requencies on the preset bars
or icons as previously described.
You will see a ‘‘0’’ displayed af ter
pressing a preset bar or icon if auto
select cannot f ind a strong station f or
every preset bar or icon.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
The preset f requencies will be lost if
your vehicle’s battery goes dead, is
disconnected, or the radio f use is
removed. If you are
traveling far from home and can no
longer receive your preset stations,
you can use the auto select feature to
find stations in the local area.
Press the A. SEL button or touch the
AUTO SELECT icon. ‘‘A. SEL’’
f lashes in the display (the upper
display on models with navigation
system), and the system goes into
scan mode f or several seconds. It
stores the f requencies of six AM,
and twelve FM stations in the preset
bars or icons.
Pick a preset number (1 6), and
hold it until you hear a beep.
Press the lef t or right side of the
bar or icon and hold it until you
hear a beep.
UsetheTUNE,SEEK,orSCAN
function to tune the radio to a
desired station.
First push the AUDIO DISPLAY
button to view the preset icons.
1. 2. 3. 4.
To turn of f auto select,
On models without navigation system
Preset
Adjusting the Sound
AUTO SELECT
Playing the AM/FM Radio
120
——y
y
(%y
y

µ
µ
µ µ
If you want to adjust the sound while
the radio/CD is playing, push the
AUDIO DISPLAY button, then touch
the SOUND icon in the display.
Touch the arrows next to the BAS or
TRE icons. The adjustment shows
you the current setting. Touch the
lef t or right bars on the sound grid.
Balance is equalized when the
vertical lines are centered on the
grid. Touch the f ront or rear bars on
the sound grid. The f ader is
equalized when the horizontal lines
arecenteredonthegrid.
Adjusts the balance, or side-
to-side strength of the sound.
The system will return to the audio
display about 5 seconds af ter you
stopadjustingamode.Onmodels
with navigation system, touch the
RETURN icon to go back to the
audio screen.
Eachmodeisshowninthedisplayas
it changes. Turn the PWR/VOL
knob to adjust the setting to your
liking. When the level reaches the
center, you will see a ‘‘ ’’ in the
display. Adjusts the bass.
Adjusts the treble. Adjusts the fader, or the
f ront-to-back strength of the sound.
On models with navigation system
On models with navigation system
On models without navigation system
BAL
BAS
TRE
FAD
Playing the AM/FM Radio
Features
121
FADER ADJUST ICONS
SOUND GRID
RETURN ICONBALANCE
ADJUST ICONS
BASS ADJUST ICONS TREBLE ADJUST ICONS
With navigation system
——y

y
(%y
y

The radio can receive the complete
AM and FM bands.
Those bands cover these f requen-
cies:
AM band: 530 to 1,710 kilohertz
FM band: 87.7 to 107.9 megahertzHow well the radio receives stations
is dependent on many f actors, such
as the distance from the station’s
transmitter, nearby large objects,
and atmospheric conditions.
Driving very near the transmitter of
a station that is broadcasting on a
f requency close to the f requency of
the station you are listening to can
also af f ect your radio’s reception.
You may temporarily hear both
stations,orhearonlythestationyou
are close to.
Radio stations on the AM band are
assigned f requencies at least ten
kilohertz apart (530, 540, 550).
Stations on the FM band are
assigned f requencies at least 0.2
megahertz apart (87.9, 88.1, 88.3).
Stations must use these exact
f requencies. It is f airly common f or
stations to round-of f the f requency in
their advertising, so your radio could
display a f requency of 100.9 even
though the announcer may identif y
the station as ‘‘FM101.’’ A radio station’s signal gets weaker
as you get f arther away f rom its
transmitter. If you are listening to an
AM station, you will notice the sound
volume becoming weaker and the
stationdriftinginandout.If youare
listening to an FM station, you will
see the stereo indicator f lickering of f
and on as the signal weakens.
Eventually, the stereo indicator will
go of f and the sound will f ade
completely as you get out of range of
the station’s signal.
Radio Reception
A M/FM Radio Frequencies
A M/FM Radio Recept ion
122
——y
y
(%y
y