2005 HONDA ACCORD COUPE homelink

The HomeLinkUniversal
Transceiver built into your vehicle
canbeprogrammedtooperateupto
three remote controlled devices
around your home, such as garage
doors, lighting, or home security
systems.
If you are training HomeLink to
operate a garage door or gate, you
should unplug the motor f or that
device during training. Repeatedly
pressing the remote control button
could burn out the motor. HomeLink stores the code in a
permanent memory. There should
be no need to retrain HomeLink if
your vehicle’s battery goes dead or is
disconnected.
If your garage door opener was
manuf actured bef ore April 1982, you
may not be able to program
HomeLink Universal Transceiver to
operate it. They do not have a saf ety
feature that causes the motor to stop
and reverse if an obstacle is detected
during closing, increasing the risk of
injury.
Always ref er to the opening
instructions and saf ety inf ormation
that came with your garage door
opener or other equipment you
intend to operate with HomeLink. If
you do not have this inf ormation,
contact the manuf acturer of the
equipment.
HomeLink
is a registered
trademark of Johnson Controls .
On EX-V6 model
General Inf ormation Important Saf ety Precautions
HomeL ink Universal T ransceiver
154
TM
——y
y
(y
y

µPress and hold the remote control
button and one of the HomeLink
buttons at the same time.
If you just
received your vehicle and have not
trained any of the buttons in
HomeLink bef ore, you should erase
any previously learned codes bef ore
training the f irst button. To do this,
press and hold the two outside
buttons on the HomeLink
Transceiver for about 20 seconds, or
until the red light f lashes. Release
the buttons, then go to step 1. If you are training the second or
third buttons, go directly to Step 1.
Unplug the garage door opener
motor f rom the house current.
Holdtheendof thegaragedoor
opener remote control 2 to 5
inches f rom HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink.
2.
3.
1.
CONT INUED
T raining HomeL ink
Bef ore you begin
HomeL ink Universal T ransceiver
Features
155
——y


y
(y
y

Canadian Owners:The remote control
you are training f rom may stop trans-
mitting after 2 seconds. This is not
enough f or HomeLink to learn the
code. Release and press the button
on the remote control every 2
seconds until HomeLink has learned
the code.
The red indicator in HomeLink
should begin f lashing. It will f lash
slowly at first, then rapidly.
When the red indicator f lashes
rapidly, release both buttons.
HomeLink should have learned
the code f rom the remote control.
Plug in the garage door opener
motor, then test the HomeLink
button by pushing it. If the button does not work, repeat
this procedure to train it again. If it
still does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink button you just trained.
If the red indicator blinks for 2
seconds,thenstayson,youhavea
rolling code garage door opener.
Go to ‘‘Training With a Rolling
Code System’’.
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The f ollowing procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.
For security purposes, newer garage
door opening systems use a ‘‘rolling’’
or variable code. Inf ormation f rom
the remote control and the garage
door opener are needed bef ore
HomeLink can operate the garage
door opener.
4. 5. 7.
6. T raining With a Rolling Code
System
HomeL ink Universal T ransceiver
156
——y
y
(y
y

Make sure you have properly
completed the ‘‘Training
HomeLink’’ procedure.
Find the ‘‘Training’’ button on your
garage door opener unit. The
location will vary, depending on
the manufacturer.Press the training button on the
garage door opener unit until the
indicator next to the button comes
on, then release it. The indicator
may blink, or come on and stay on.
You then have approximately 30
seconds to complete the following
steps.Press and hold the button on
HomeLink f or 3 to 4 seconds.
Press and hold the HomeLink
button again f or 3 to 4 seconds.
This should turn of f the training
light on the garage door opener
unit. (Some systems may require
youtopressthebuttonuptothree
times.)
Press the HomeLink button again.
It should operate the garage door.
6.
2.
4. 5.
1.
3.
HomeL ink Universal T ransceiver
Features
157
TRAINING BUTTON
——y
y
(y
y

Toerasethecodesstoredinallthree
buttons, press and hold the two
outside buttons until the red light
begins to f lash, then release the
buttons.
Youshoulderaseallthreecodes
bef ore selling the vehicle.
Totrainanalreadyprogrammed
HomeLink button with a new device,
you do not have to erase all the
memory. Train the selected button
over the existing memory code
f ollowing the steps under. If you have problems with training
the HomeLink Wireless Control
System, or would like inf ormation on
home products that can be operated
by HomeLink, call (800) 355-3515.
On the Internet, go to www.
homelink.com.
HomeLink
is a registered
trademark of Johnson Controls, Inc.
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, including
interf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not cause
interf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.Erasing Codes
Retraining a Button
‘‘T raining
HomeL ink’’ Customer Assistance
HomeL ink Universal T ransceiver
158
——y
y
(y

y

CONT INUED
.
Evaporative Emissions Controls . 282
...............................
Exhaust Fumes . 52
Expectant Mothers, Use of Seat
........................................
Belts by . 18
.............
Halogen Headlight Bulbs . 226
..............
Hazard Warning Flashers . 72
........................................
Headlights . 70
........................................
Aiming . 226
..............
Automatic Lighting Off . 71
............
Daytime Running Lights . 72
............
Low Beams, Turning on . 70
.........................
Reminder Chime . 70
........
Replacing Halogen Bulbs . 226
...................................
Turning on . 70
..............................
Head Restraints . 90
.....................
Heating and Cooling . 106
.................................
Heated Mirror . 95
HomeLink Universal
................................
Transceiver . 154
..
Hood, Opening and Closing the . 163
...........................
Hydraulic Clutch . 224
...............
Gas Mileage, Improving . 167
..........................................
Gasohol . 280
.........................................
Gasoline . 160
...........................................
Gauge . 66
................
Octane Requirement . 160
........................
Tank, Filling the . 162
................
Gas Station Procedures . 162
Gauges
...
Engine Coolant Temperature . 65
...............................................
Fuel . 66
...............................
Speedometer . 64
.................................
Tachometer . 64 Gearshif t Lever Positions
..........
Automatic Transmission . 178
...................
Manual Transmission . 176
......................................
Glove Box . 104
...................................
Fan, Interior . 108
.........................................
Features . 105
....................
Filling the Fuel Tank . 162
Filter
.........................
Dust and Pollen . 233
...............................................
Oil . 214
Manual Transmission ...............
Checking Fluid Level . 222
Manual Transmission ................................
Shif ting the . 176
.............
Flashers, Hazard Warning . 72
...................
Flat Tire, Changing a . 247
Fluids
.
Automatic Transmission . 219, 220
..........................................
Brake . 223
.........................................
Clutch . 224
..............
Manual Transmission . 222
..........................
Power Steering . 224
..................
Windshield Washer . 216 ...........................
Folding Rear Seat . 91
.....
Foreign Countries, Driving in . 281
..........................
Four-way Flashers . 72
.................................................
Fuel . 160
...............................
Cap Message . 66
......................
Fill Door and Cap . 162
...........................................
Gauge . 66
................
Octane Requirement . 160
...............................
Oxygenated . 280
........................
Tank, Filling the . 162
.....................
Fuses, Checking the . 265
Index
F
G H
INDEX
III
——y
y
(yy