2005 GMC YUKON DENALI fuel

[x] Cancel search: fuel

Page 296 of 468

GMC YUKON DENALI 2005  Owners Manual Towing a Trailer
Do not tow a trailer during break-in. SeeNew Vehicle
Break-In on page 2-19for more information.
{CAUTION:
If you do not use the correct equipment and
drive properly, you can lose cont

Page 298 of 468

GMC YUKON DENALI 2005  Owners Manual Tow/Haul Mode
The Tow/Haul feature assists when pulling a heavy
trailer or a large or heavy load. The purpose of
the Tow/Haul mode is to:
Reduce the frequency and improve the predictability
of transm

Page 309 of 468

GMC YUKON DENALI 2005  Owners Manual Service............................................................5-3
Doing Your Own Service Work.........................5-4
Adding Equipment to the Outside of Your
Vehicle..........................

Page 313 of 468

GMC YUKON DENALI 2005  Owners Manual Adding Equipment to the Outside of
Your Vehicle
Things you might add to the outside of your vehicle can
affect the air�ow around it. This may cause wind
noise and affect windshield washer performance.

Page 314 of 468

GMC YUKON DENALI 2005  Owners Manual California Fuel
If your vehicle is certi�ed to meet California Emission
Standards (see the underhood emission control label), it
is designed to operate on fuels that meet California
speci�cations. If

Page 315 of 468

GMC YUKON DENALI 2005  Owners Manual Notice:Your vehicle was not designed for fuel that
contains methanol. Do not use fuel containing
methanol. It can corrode metal parts in your fuel
system and also damage the plastic and rubber
parts.

Page 316 of 468

GMC YUKON DENALI 2005  Owners Manual Filling Your Tank
{CAUTION:
Fuel vapor burns violently and a fuel �re can
cause bad injuries. To help avoid injuries to
you and others, read and follow all the
instructions on the pump island. Turn of

Page 317 of 468

GMC YUKON DENALI 2005  Owners Manual When replacing the fuel cap, turn it to the right
(clockwise) until it clicks. It will require more effort to
turn the fuel cap on the last turn as you tighten it. Make
sure the cap is fully installed