2005 FORD F150 turn signal

U.S. federal safety standards (this includes any garage door opener
model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLinkat:www.homelink.comor1–800–355–3515.
Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLinkequipped vehicle
purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelinkbuttons be erased for security purposes, refer to
Programmingin this section.
Programming
Do not program HomeLinkwith the vehicle parked in the garage.
Note:Your vehicle may require the ignition switch to be turned to the
ACC position for programming and/or operation of the HomeLink.Itis
also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLinkfor quicker
training and accurate transmission of the radio-frequency signal.
1. Press and hold the two outside
buttons releasing only when the
indicator light begins to flash after
20 seconds.Do notrepeat Step one
to program additional hand-held
transmitters to the remaining two
HomeLinkbuttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink.
2. Position the end of your
hand-held transmitter 1–3 inches (2–8 cm) away from the HomeLink
button you wish to program (located on your visor) while keeping the
indicator light in view.
3. Simultaneously press and hold
both the HomeLinkand hand-held
transmitter button.Do not release
the buttons until Step 4 has
been completed.
Some entry gates and garage door
openers may require you to replace
Step 3 with procedures noted in the
“Gate Operator and Canadian Programming”in this section for Canadian
residents.
REVIEW COPY
2005 F150(f12), Owners Guide (post-2002-fmt)(own2002),
Market:USA_English(fus)
Driver Controls
73

4. The indicator light will flash slowly and then rapidly. Release both
buttons when the indicator light flashes rapidly. (The rapid flashing light
indicates acceptance of the hand-held transmitters’radio frequency
signals.)
5. Press and hold the just-trained HomeLinkbutton and observe the
indicator light. If the light is constant, programming is complete and your
device should activate when the HomeLinkbutton is pressed and
released.Note:To program the remaining two HomeLinkbuttons,
begin with Step 2 in the“Programming”section—do notrepeat Step 1.
Note:If the indicator light blinks rapidly for two seconds and then turns
to a continuous red, proceed with steps 6 through 8 to complete
programming of a rolling code equipped device.
6. At the garage door opener receiver (motor-head unit) in the garage,
locate the“learn”or“smart”button (usually near where the hanging
antenna wire is attached to the unit).
7. Press and release the“learn”or“smart”button. (The name and color
of the button may vary by manufacturer.)
Note:There are 30 seconds in which to initiate Step eight.
8. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLinkbutton. Repeat the press/hold/release sequence
again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.
HomeLinkshould now activate your rolling code equipped device. To
program additional HomeLinkbuttons begin with Step 2 in the
“Programming”section. For questions or comments, please contact
HomeLink atwww.homelink.comor1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting—
not allowing enough time for
HomeLinkto accept the signal
from the hand-held transmitter.
After completing steps 1 and 2
outlined in the“Programming”
section, replace Step 3 with the following:
Note:If programming a garage door opener or gate operator, it is
advised to unplug the device during the“cycling”process to prevent
overheating.
REVIEW COPY
2005 F150(f12), Owners Guide (post-2002-fmt)(own2002),
Market:USA_English(fus)
Driver Controls
74

3. Attach the trailer to the vehicle and adjust the hitch equalizers so that
the front bumper height is within12”(13 mm) of the reference point.
After proper adjustment, the rear bumper should be no higher than in
Step 2.
Note:Adjusting an equalizing hitch so the rear bumper of the vehicle is
higher than it was unloaded will defeat the function of the load
equalizing hitch and may cause unpredictable handling.
Safety chains
Always connect the trailer’s safety chains to the frame or hook retainers
of the vehicle hitch. To connect the trailer’s safety chains, cross the
chains under the trailer tongue and allow slack for turning corners.
If you use a rental trailer, follow the instructions that the rental agency
gives to you.
Do not attach safety chains to the bumper.
Trailer brakes
Electric brakes and manual, automatic or surge-type trailer brakes are
safe if installed properly and adjusted to the manufacturer’s
specifications. The trailer brakes must meet local and Federal
regulations.
Do not connect a trailer’s hydraulic brake system directly to your
vehicle’s brake system. Your vehicle may not have enough
braking power and your chances of having a collision greatly increase.
The braking system of the tow vehicle is rated for operation at the
GVWR not GCWR.
Trailer lamps
Trailer lamps are required on most towed vehicles. Make sure all running
lights, brake lights, turn signals and hazard lights are working. See your
dealer or trailer rental agency for proper instructions and equipment for
hooking up trailer lamps.
Using a step bumper (if equipped)
The rear bumper is equipped with an integral hitch and only requires a
ball with a one inch (25.4 mm) shank diameter. The bumper has a 5,000
lb. (2,270 kg) trailer weight and 500 lb. (227 kg) tongue weight capacity.
If it is necessary to relocate the trailer hitch ball position, a
frame-mounted trailer hitch must be installed.
REVIEW COPY
2005 F150(f12), Owners Guide (post-2002-fmt)(own2002),
Market:USA_English(fus)
Tires, Wheels and Loading
186

Canadian customers who require roadside assistance, call
1–800–665–2006.
If you need to arrange roadside assistance for yourself, Ford Motor
Company will reimburse a reasonable amount. To obtain reimbursement
information, U.S. Ford or Mercury vehicles customers call
1-800-241-3673; Lincoln vehicle customers call 1–800–521–4140.
Canadian customers who need to obtain reimbursement information, call
1–800–665–2006.
ROADSIDE COVERAGE BEYOND BASIC WARRANTY
In the United States, you may purchase additional roadside assistance
coverage beyond this period through the Ford Auto Club by contacting
your Ford or Lincoln/Mercury dealer.
Similarly in Canada, for uninterrupted Roadside Assistance coverage, you
may purchase extended coverage prior to your Basic Warranty’s Roadside
Assistance expiring. For more information and enrollment, contact
1–877–294–2582 or visit our website at www.ford.ca.
HAZARD FLASHER
The hazard flasher is located on the
steering column, just behind the
steering wheel. The hazard flashers
will operate when the ignition is in
any position or if the key is not in
the ignition.
Push in the flasher control and all
front and rear direction signals will
flash. Press the flasher control again
to turn them off. Use it when your
vehicle is disabled and is creating a
safety hazard for other motorists.
Note:With extended use, the flasher may run down your battery.
FUEL PUMP SHUT-OFF SWITCH
This device stops the electric fuel pump from sending fuel to the engine
when your vehicle has had a substantial jolt.
After an accident, if the engine cranks but does not start, this switch
may have been activated.
REVIEW COPY
2005 F150(f12), Owners Guide (post-2002-fmt)(own2002),
Market:USA_English(fus)
Roadside Emergencies
224

The fuses are coded as follows.
Fuse/Relay
LocationFuse Amp
RatingPassenger Compartment Fuse Panel
Description
1 10A* Run/Accessory - Wipers, Instrument
cluster
2 20A* Stop/Turn lamps, Speed control deactivate
switch
3 5A* Power mirrors, Memory logic power,
Memory seats and pedals
4 10A* DVD battery power, Power fold mirror
5 7.5A* Keep alive memory for Powertrain Control
Module (PCM) and climate control module
6 15A* Parklamps, BSM, Instrument panel
illumination
7 5A* Radio (start signal)
8 10A* Heated mirrors, Switch indicator
9—Not used
REVIEW COPY
2005 F150(f12), Owners Guide (post-2002-fmt)(own2002),
Market:USA_English(fus)
Roadside Emergencies
227

Infant seats
(see Safety seats) .....................138
Inspection/maintenance (I/M)
testing ........................................280
Instrument panel
cleaning ...................................251
cluster ........................................10
lighting up panel and
interior .......................................48
J
Jack ............................................158
positioning ...............................158
storage .....................................158
Jump-starting your vehicle ......232
K
Keyless entry system .................99
autolock .....................................97
programming entry code .........99
Keys ...........................................102
positions of the ignition .........190
L
Lamps
autolamp system .......................46
bulb replacement
specifications chart ..................52
daytime running light ...............47
fog lamps ...................................47
headlamps .................................46
headlamps, flash to pass ..........48
instrument panel, dimming .....48
interior lamps .....................50–51
replacing bulbs .............52, 54–56
Lane change indicator
(see Turn signal) ........................50
Lights, warning and indicator ....10anti-lock brakes (ABS) ..........196
Load limits .................................174
Loading instructions .................179
Locks
autolock .....................................97
childproof ..................................90
Lubricant specifications ...295, 297
Lug nuts ....................................164
Lumbar support, seats .............106
M
Manual transmission .................205
reverse .....................................207
Message center ...........................76
english/metric button ...............80
system check button ................80
warning messages .....................82
Mirrors ...................................58, 65
automatic dimming rearview
mirror ........................................65
fold away ...................................67
heated ........................................66
programmable memory ....93, 107
side view mirrors (power) .......65
signal .........................................66
Moon roof ....................................71
Motorcraft parts ................275, 290
O
Octane rating ............................274
Oil (see Engine oil) ..................259
P
Parking brake ............................197
Parts (see Motorcraft parts) ....290
REVIEW COPY
2005 F150(f12), Owners Guide (post-2002-fmt)(own2002),
Market:USA_English(fus)
Index
310

tilting .........................................58
T
Tailgate ........................................86
Temperature control
(see Climate control) .................36
Tilt steering wheel ......................58
Tires ...........................153–154, 158
alignment ................................171
care ..........................................170
changing ..........................158, 160
checking the pressure ............156
inspecting and inflating .........155
label .........................................169
replacing ..................................158
rotating ....................................172
safety practices .......................171
sidewall information ...............165
snow tires and chains ............174
spare tire .................................158
terminology .............................154
tire grades ...............................154
treadwear ........................153, 170
Towing .......................................179
recreational towing .................188
trailer towing ..........................179
Traction-lok rear axle ...............198
Transfer case
fluid checking .........................287
Transmission .............................199brake-shift interlock
(BSI) ................................199–200
fluid, checking and adding
(automatic) .............................283
fluid, checking and adding
(manual) .................................286
fluid, refill capacities ..............291
lubricant
specifications ..................295, 297
manual operation ....................205
Turn signal ..................................50
V
Vehicle dimensions ...........298, 302
Vehicle Identification Number
(VIN) ..........................................302
Vehicle loading ..........................174
Ventilating your vehicle ...........195
W
Warning lights (see Lights) .......10
Washer fluid ..............................259
Water, Driving through .............219
Windows
power .........................................63
power down back window .......64
Windshield washer fluid and
wipers ..........................................57
checking and adding fluid .....259
replacing wiper blades .............57
REVIEW COPY
2005 F150(f12), Owners Guide (post-2002-fmt)(own2002),
Market:USA_English(fus)
Index
312