Headlamp and Panel Dimmer Control
Rotate the
control clockwise
to the first position
to turn on the
parking lamps.
Rotate to the second position to also turn on
the headlamps. Rotate counterclockwise toactivate autolamp (if equipped), which
provides light sensitive automatic on off
control of the exterior lights.
When the control is in any position except
high beams or off, pull the control towardyou to activate the foglamps (if equipped).
Use the instrument panel dimmer control,
to the right of the headlamp control,
to adjust the brightness of the instrumentpanel during headlamp and parking lamp operation.
Turn Signal and Wiper/Washer Control
For front wiper operation, rotate the
ring on the left to the desired interval, low or high speed position. In the
intermittent position, rotate the control
up for fast or down for slow intervals. In
addition, the speed sensitive front wipers
automatically adjust as the vehicle’s
speed changes if the control is set for
intermittent operation. Push the end of the lever briefly for a single wipe
(no wash). Push and hold for three
swipes with wash. The ring on the right
operates the rear window wiper. Rotate
the control to the normal speed (INT 2),
or intermittent (INT 1).
ABS Warning Lamp
Your anti lock braking system (ABS)
detects the onset of wheel lockup
during brake applications and helps
prevent wheels from locking during
extreme braking situations. The ABS
warning light will illuminate when you startyour engine. However if it stays on, continuesto flash, or fails to illuminate, see your
dealership’s service department immediately.
Tire Pressure Warning Lamp(if equipped)
Please see Additional Features
for details.
Hazard Flasher Control
Press to activate all hazard flashers
simultaneously in an emergency to warn
traffic of vehicle breakdown or approaching
danger. Press the control again to turn
the flashers off. The hazard flashers will operate in any ignition position.
Service Engine Soon Lamp
Illuminates briefly to ensure the
system is functional. If it illumi nates while driving, it can mean
that one of the engine’s emissionsystems has failed or that your fuel
cap is not properly installed.
A loose fuel cap can cause the “Check Fuel
Cap” lamp to illuminate or create a “Check Fuel
Cap” warning message in the optional message
center. These warnings reset after the cap is
tightened and your vehicle is driven a short
distance. To prevent activation of these
systems, always secure your fuel cap by turning
it clockwise 1/8 of a turn until it stops.
Gearshift/Overdrive Control
Overdrive is the normal drive position for the
best fuel economy. Only deactivate overdrive(O/D OFF) when driving with a heavy load,towing a trailer up or down steep hills, or
when additional engine braking is desired.
To deactivate, press the switch located on
the end of the gearshift lever. When the
battery is disconnected or a new battery is
installed, the engine must relearn its idle and
fuel trim strategy. Therefore, the transmission
2
3
4
6
5
7
8
