2005 DODGE POWER WAGON wheel alignment

▫Four-Wheel Anti-Lock Brake System (ABS)
—If Equipped.......................284

Power Steering........................286

Tire Safety Information...................286
▫Tire Markings........................286
▫Tire Identification Number (TIN)..........289
▫Tire Loading And Tire Pressure...........291

Ti re s—General Information................295
▫Tire Pressure.........................295
▫Tire Inflation Pressures.................296
▫Radial-Ply Tires......................299
▫Compact Spare Tire—If Equipped.........299
▫Limited Use Spare—If Equipped.........300▫Tire Spinning........................301
▫Tread Wear Indicators..................302
▫Replacement Tires.....................302
▫Alignment And Balance.................303

Supplemental Tire Pressure Information.......304

Tire Chains...........................304

Snow Tires...........................305

Tire Rotation Recommendations............306

Fuel Requirements......................307
▫Reformulated Gasoline.................307
▫Gasoline/Oxygenate Blends..............308
▫MMT In Gasoline.....................308
▫Sulfur In Gasoline.....................309
STARTING AND OPERATING 217
5

Stabilizer/Sway Bar System
Power Wagon vehicles are equipped with an electronic
disconnecting stabilizer/sway bar. This system allows
greater front suspension travel in off-road situations.
This system is controlled by the electronic control sway
bar switch located on the instrument panel.The switch has two positions, on-road and off-road. The
system is normally in on-road mode, indicated by a solid
green light. The stabilizer/sway bar should remain in
on-road mode during normal driving conditions.
To disconnect the stabilizer/sway bar, shift to either 4HI
or 4LO as shown in Four Wheel Drive Operation and
press the top of the stabilizer/sway bar button to obtain
the off-road position. The amber indicator light will flash
until the stabilizer/sway bar has been fully disconnected.
(See page 277 for more information.)
NOTE:The stabilizer/sway bar may be torque locked
due to left and right suspension height differences. This
condition is due to driving surface differences or vehicle
loading. In order for the stabilizer/sway bar to
disconnect/reconnect, the right and left halves of the bar
must be aligned. This alignment may require that the
vehicle be driven onto level ground or rocked from side
to side.
Electronic Control Sway Bar Switch
STARTING AND OPERATING 223
5

vehicle in motion, the transfer case will engage / disen-
gage faster if you momentarily release the accelerator
pedal after completing the shift. Apply a constant force
when shifting the transfer case lever.
2H or 4H⇔4L
With the vehicle rolling at 2 to 3 mph (3 to 5 km/h), shift
an automatic transmission to N (Neutral) or depress the
clutch on a manual transmission. While the vehicle is
coasting at 2 to 3 mph (3 to 5 km/h), shift the transfer
case lever firmly to the desired position. Do not pause in
transfer case N (Neutral).
NOTE:Pausing in transfer case N (Neutral) in vehicles
equipped with an automatic transmission may require
shutting the engine OFF to avoid gear clash while
completing the shift. If difficulty occurs, shift automatic
transmission to N (Neutral), hold foot on brake, and turn
engine OFF. Make shift to the desired mode.NOTE:Shifting into or out of 4L is possible with the
vehicle completely stopped, however difficulty may oc-
cur due to the mating clutch teeth not being properly
aligned. Several attempts may be required for clutch
teeth alignment and shift completion to occur. The pre-
ferred method is with the vehicle rolling 2 to 3 mph (3 to
5 km/h). Avoid attempting to engage or disengage 4L
with the vehicle moving faster than 2 to 3 mph (3 to 5
km/h).
NOTE:Do not attempt to shift to or from 4L while the
transmission is in gear or clutch is engaged.
Transfer Case Reminder Light
The four-wheel-drive operating light (4WD), located in
the instrument cluster, is used to alert the driver that the
front axle is fully engaged and all four wheels are
driving.
280 STARTING AND OPERATING

WARNING!
•Do not use a tire, wheel size or rating other than that
specified for your vehicle. Some combinations of
unapproved tires and wheels may change suspen-
sion dimensions and performance characteristics,
resulting in changes to steering, handling, and brak-
ing of your vehicle. This can cause unpredictable
handling and stress to steering and suspension com-
ponents. You could lose control and have an accident
resulting in serious injury or death. Use only the tire
and wheel sizes with load ratings approved for your
vehicle.
•Never use a tire with a smaller load index or capacity,
other than what was originally equipped on your
vehicle. Using a tire with a smaller load index could
result in tire overloading and failure. You could lose
control and have an accident.
•Failure to equip your vehicle with tires having
adequate speed capability can result in sudden tire
failure and loss of vehicle control.
CAUTION!
Replacing original tires with tires of a different size
may result in false speedometer and odometer read-
ings.
Alignment And Balance
Poor suspension alignment may result in:
•Fast tire wear.
•Uneven tire wear, such as feathering and one-sided
wear.
•Vehicle pull to right or left.
Tires may also cause the vehicle to pull to the left or right.
Alignment will not correct this condition. See your dealer
for proper diagnosis.
STARTING AND OPERATING 303
5

Improper alignment will not cause vehicle vibration.
Vibration may be a result of tire and wheel out-of-
balance. Proper balancing will reduce vibration and
avoid tire cupping and spotty wear.
SUPPLEMENTAL TIRE PRESSURE INFORMATION
A light load vehicle condition is defined as two passen-
gers {150 lbs (68 kg) each} plus 200 lbs (91kg) of cargo.
Cold tire inflation pressures for a lightly loaded vehicle
will be found on a“Supplemental Tire Pressure Inflation”
label located on the face of the driver’s door or in the Tire
Information Pressures pamphlet in the glove box.
TIRE CHAINS
Use“Class U”chains on Power Wagon models, or other
traction aids that meet SAE Type“U”specifications.
NOTE:Chains must be the proper size for the vehicle,
as recommended by the chain manufacturer.
CAUTION!
To avoid damage to your vehicle, tires or chains, observe the
following precautions:
•Because of limited chain clearance between tires and other
suspension components, it is important that only chains in
good condition are used. Broken chains can cause serious
vehicle damage. Stop the vehicle immediately if noise
occurs that could suggest chain breakage. Remove the
damaged parts of the chain before further use.
•Install chains as tightly as possible and then retighten after
driving about 1/2 mile (0.8 km).
•Do not exceed 45 mph (72 km/h).
•Drive cautiously and avoid severe turns and large bumps,
especially with a loaded vehicle.
•Do not install tire chains on front wheels of 4x2 vehicles.
•Do not drive for a prolonged period on dry pavement.
•Observe the tire chain manufacturer’s instructions on
method of installation, operating speed, and conditions for
usage. Always use the lower suggested operating speed of
the chain manufacturer if different than the speed recom-
mended by the manufacturer.
304 STARTING AND OPERATING

Speed Control.......................... 118
Speedometer........................... 159
Springs................................ 82
Stabilizer Bars, Electronic Disconnecting........ 81
Starting............................... 267
Automatic Transmission................. 268
Engine Fails to Start.................... 268
Manual Transmission................... 267
Steering
Column Controls...................... 113
Column Lock.......................... 15
Linkage............................. 368
Power...........................286,367
Wheel, Tilt........................... 117
Storage, Behind the Seat................... 142
Storage Compartment, Center Seat........... 142
Storage, Vehicle......................... 393
Storing Your Vehicle...................... 393
Sun Roof.............................. 136Supplemental Tire Pressure Information........ 304
Synthetic Engine Oil...................... 359
Tachometer............................ 158
Tailgate............................... 148
Tether Anchor, Child Restraint.............63,66
Tilt Steering Column..................... 117
Tire and Loading Information Placard....291,292,304
Tire Identification Number (TIN)............. 289
Tire Markings.......................... 286
Tire Safety Information.................... 286
Tires .............................74,82,295
Air Pressure.......................... 295
Alignment........................... 303
Chains.............................. 304
Changing............................ 337
Compact Spare........................ 299
General Information.................... 295
High Speed.......................... 298
452 INDEX

Maintenance.......................379,380
Manual........................267,275,379
Shifting..........................270,276
Transmitter, Garage Door Opener............ 130
Tread Wear Indicators.................... 302
Trip Computer.......................... 123
Trip Odometer.......................163,164
Turn Signals................... 113,158,394,398
Underhood Fuses........................ 393
Universal Transmitter..................... 130
Variance, Compass....................... 128
Vehicle Identification Number................ 6
Vehicle Loading......................292,315
Vehicle Modifications/Alterations.............. 7
Vehicle Storage......................... 393
Voltmeter............................. 158
Warning Lights (Instrument Cluster Description) . 157Warnings and Cautions..................... 5
Warranty Information..................... 433
Washers, Windshield................... 117,369
Washing Vehicle......................... 389
Wheel Alignment and Balance............... 303
Wheel and Wheel Trim.................... 390
Wheel Changing........................ 337
Wheel Flares............................ 82
Wheel Mounting........................ 338
Wheel Nut Torque....................341,342
Wheels................................ 83
Winch..............................81,246
Accessories.......................... 250
Operation........................... 251
Rigging Techniques..................... 263
Usage.............................. 246
Wind Buffeting.......................35,138
Window Airbag.......................... 56
Window Fogging........................ 212
454 INDEX