2005 Citroen XSARA filter

Downloaded from www.Manualslib.com manuals search engine 340
CLUTCH
GEARBOX
TRANSMISSION
CHECKS AND ADJUSTMENTS: BE4/5 GEARBOX CONTROLS
Tools.
[1]Tool for positioning the gear lever: 9607-T
Adjustments.
WARNING: Cables should be adjusted each time
the gearbox, gear controls or power unit are
removed.
Inside the vehicle.
Remove the trim under the gear lever.
Lock the gear lever in neutral position, using tool [1].
Under the bonnet.
Remove the air filter assembly.
Unlock the ball-joint keys at «a».
Place the gear selection and control levers on neutral.
Lock the cable lengths with the ball-joint locking keys.Checks.
Remove the tool [1].
Check that all the gears engage without «tightness».
Check that the gear lever moves identically forwards
and backwards and to right and left.
If it does not, repeat the adjustment.
Refit the trim under the gear lever.
Refit the air filter assembly.
Adjusting the gear controls Engines: NFV - 6FZ - RFN - WJY - 8HX - 8HZ - 9HZ - 9HY - RHY - RHZ
XSARA - XSARA PICASSO
B2CP3C6CB2CP3C0C
Angl.-t2-page306-360-2005 9/01/06 10:20 Page 340

Downloaded from www.Manualslib.com manuals search engine 406
BRAKES
B3FP7EQC
BLEEDING AND FILLING THE BRAKING SYSTEM
Tools.
[1]Bleeding apparatus: «LURO» or similar
[2]LEXIA diagnostic tool: 4171-T
[3]PROXIA diagnostic tool: 4165-T
NOTE:Bleeding of the secondary braking circuit is done with the aid of diagnostic tools [2]and [3].
Draining of the brake fluid reservoir.
Remove the screws (3)and the battery tray (2).
Remove the filter of the brake fluid reservoir (4).
Drain the brake fluid reservoir (4)to the maximum extent
(if necessary, use a clean syringe).
Remove the screws (1).
Uncouple the clickfit union at «a».
Remove the brake fluid reservoir (4).
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 406

Downloaded from www.Manualslib.com manuals search engine 407
BRAKES
B3FP7ESD
BLEEDING AND FILLING THE BRAKING SYSTEM
Disconnect the connector «b».
Uncouple the pipe (5).
Remove the reservoir (6), moving aside the tabs «c»of the pins (7).
Clean the brake fluid reservoir (4) and the brake fluid reservoir (6).
Refit the brake fluid reservoir (6).
Couple the pipe (5).
Reconnect the connector «b».
Couple the clickfit union, at «a».
Refit:
- The brake fluid reservoir (4).
- The screws (1).
- The filter of the brake fluid reservoir.
- The battery tray.
- The screws (3).
- The battery.
Reconnect the battery.
IMPERATIVE: Carry out the operations that are necessary following a reconnection of the
battery
(see corresponding operation).
B3FP7ERC
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 407

Downloaded from www.Manualslib.com manuals search engine 431
AIR
CONDITIONING C5HP1C6C
Pollen filter
Note:The pollen filter is located in the engine compartment
on the RH side.
Removing.
Remove:
- The plastic pins (1).
- The plastic cover (2).
- The flap (3).
- The pollen filter (4).
Refitting.
Proceed in reverse order.
SPECIAL FEATURES: AIR CONDITIONING SYSTEM (R 134.a)
C5HP1C5CC5HP1C7C
C4
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 431

Downloaded from www.Manualslib.com manuals search engine 432
AIR
CONDITIONING
SPECIAL FEATURES: AIR CONDITIONING SYSTEM (R 134.a)
Pollen filter
XSARA
Removing-refitting.
Remove:
- The interior trim (1).
- The cover (4).
- The pollen filter (3).
Concerns vehicles equipped with aircon without temperature regulation.
Fitting of a new pollen filter necessitates the following operations:
- Engage the pollen filter upwards
(following arrow «c»).- Slide the pollen filter towards the rear (following arrow «d»).- Position the index(4)on the cover forward of the pollen filter ((4)Index on
the cover).
C5HP07JC
C5FP075D
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 432

Downloaded from www.Manualslib.com manuals search engine 433
AIR
CONDITIONING
SPECIAL FEATURES: AIR CONDITIONING SYSTEM (R 134.a)
Pollen filter
Remove:
- The three screws (1).
- The cover (2).
Remove the pollen filter.
XSARA PICASSO
B1BP23ED
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 433

Downloaded from www.Manualslib.com manuals search engine AIR
CONDITIONING
434
C5HP1CKC
Changing the filtering/drying cartridge
The condenser (4)has a cylinder acting as a fluid reservoir with a filtering cartridge incorporated in it.
a:Inlet union
b:Outlet union
NOTE:The filtering cartridge cannot be swapped.
SPECIAL FEATURES: AIR CONDITIONING SYSTEM (R 134.a)C4
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 434

Downloaded from www.Manualslib.com manuals search engine 435
AIR
CONDITIONING
SPECIAL FEATURES: AIR CONDITIONING SYSTEM (R 134.a)
Changing the filtering/drying cartridge
Tools.
[1]Charge station:
(according to workshop equipment)[2]TORX adaptor: TORX 70 FACOM
Removing.
Depressurise the aircon circuit, using tool [1].
Uncouple the hose (2).
Remove:
- The air filter assembly (3).
- The nuts (1).
Protect the radiator harness with strong cardboard cut to the dimensions of the radiator.
Move aside the cooling fan.
Remove:
- The screws (4).
- The brackets (5).
B1BP23FCB1BP23GC
XSARA PICASSO
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 435