Page 206 of 223
Downloaded from www.Manualslib.com manuals search engine 200
HYDRAULICS
SUSPENSION SPHERES: SPECIFICATION - IDENTIFICATION
Stiffness regulator accumulators (front).
NOTE:The dampers are integral to the hydractive regulator.
Engine version Suspension sphere marking Pressure rating (bars)
ES9A
KR 70
DT17BTED4
Stiffness regulator accumulators (rear).
NOTE:The dampers are integral to the hydractive regulator.
Engine version Suspension sphere marking Pressure rating (bars)
ES9A
KS 40
DT17BTED4
The suspension cylinders on the same axle have to be equipped with the same type of suspension accumulators.
IMPORTANT: Tightening torque for the suspension accumulators : 2,7 ± 0,5 m.daN.
Angl-C6-page195-202-2005 4/02/05 17:36 Page 200
Page 207 of 223
![CITROEN C6 2005 Owners Manual Downloaded from www.Manualslib.com manuals search engine 201
HYDRAULICS
DE-PRESSURISING THE HYDRAULIC SUSPENSION CIRCUITTools.
[1] PROXIAstation: 4165-T
[2] LEXIAstation: 4171-T
De-pressurisation.
NOT](/manual-img/9/57744/w960_57744-206.png "CITROEN C6 2005 Owners Manual Downloaded from www.Manualslib.com manuals search engine 201
HYDRAULICS
DE-PRESSURISING THE HYDRAULIC SUSPENSION CIRCUITTools.
[1] PROXIAstation: 4165-T
[2] LEXIAstation: 4171-T
De-pressurisation.
NOT")
Downloaded from www.Manualslib.com manuals search engine 201
HYDRAULICS
DE-PRESSURISING THE HYDRAULIC SUSPENSION CIRCUITTools.
[1] PROXIAstation: 4165-T
[2] LEXIAstation: 4171-T
De-pressurisation.
NOTE:It is possible to de-pressurise the suspension by individual axle.
Using a diagnostic tool.
Start the engine.
Place the height control in the «LOW»position.
Wait for the vehicle height to reach the position required.
Stop the engine.
Connect the diagnostic tool [1]or [2]to the vehicle's diagnostic socket.
Switch on the ignition.
Carry out a global test.Go into the menu:
- Suspension.
- De-pressurisation.
Follow the instructions displayed on the screen.
Wait for the vehicle's suspension to sink completely.
NOTE:This operation takes around 3 minutes.
Switch off the ignition.
Disconnect the battery.
Without a diagnostic tool.
IMPERATIVE: Any LDS fluid that is collected must not be re-used.
NOTE:Collect the LDSfluid in order to keep the work area clean.
Respect the environment.
Start the engine.
Place the height control in the «LOW»position.
Stop the engine.
Angl-C6-page195-202-2005 4/02/05 17:36 Page 201
Page 208 of 223
Downloaded from www.Manualslib.com manuals search engine 202
HYDRAULICS
DE-PRESSURISING THE HYDRAULIC SUSPENSION CIRCUIT
Front suspension:Undo the pressure release screw (1)by one turn.
Wait for the pressure in the hydraulic circuit to drop fully.
Rear suspension:Undo the pressure release screw (2)by one turn.
Wait for the pressure in the hydraulic circuit to drop fully.
B3FP7HDDB3BP1BED
Angl-C6-page195-202-2005 4/02/05 17:36 Page 202
