2005 Citroen C4 bleed

Downloaded from www.Manualslib.com manuals search engine 410
BRAKESBLEEDING AND FILLING THE BRAKING SYSTEM
Bleeding the braking circuit without the bleed apparatus.
NOTE:Two operators are necessary.
For each brake circuit:
- Apply the brake pedal to place the circuit under pressure.
- Couple a transparent tube on the bleed screw.
- Submerge the other end of the tube in a clean container.
- Open the bleed screw.
- Wait until the fluid flows out without air bubbles.
- Close the bleed screw.
NOTE:Recommence the process a second timeif that is necessary.
Check the level of the brake fluid
(between the «DANGER»level and
the «MAXI»level).
Fill if necessary with the the approved and recommended synthetic
brake fluid.Bleeding the secondary braking circuit.
WARNING: During the bleed operations: take care to maintain the
level of the brake fluid in the reservoir, keep it topped up.
NOTE:The bleed apparatus [1]is still connected on the brake fluid
reservoir (4).
Use the diagnostic tools [2]or [3].
Select the menu corresponding to the vehicle:
- ABSmenu
(according to equipment).- ESPmenu (according to equipment).
Follow the instructions of the diagnostic tool.
At the end of the bleed programme, check the level of the brake fluid,
top up if necessary.
Check the travel of the brake pedal: it must not be excessive. If it is,
restart the bleed procedure.
C4
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 410

Downloaded from www.Manualslib.com manuals search engine 420
BRAKESBLEEDING THE BRAKING SYSTEM XSARA
Bleeding: The brakes can be bled either:
- using brake bleeding equipment, in which case the pressure of the equipment should be set to2 bars.
- or in the conventional way.
IMPERATIVE order of bleeding
Wheels:
- Rear Right.
- Front Left.
- Rear Left.
- Front Right.
Top up using brake fluid supplied by CITROËN Replacement Parts.
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 420

Downloaded from www.Manualslib.com manuals search engine 427
BRAKES
BLEEDING THE BRAKING SYSTEMXSARA PICASSO
Tools Bleeding equipment of type «LURO» or similar.
IMPERATIVE: For bleeding the secondary circuit, use ELIT, LEXIA or PROXIA diagnostic tools.
Draining.
Drain the brake fluid reservoir as empty as possible using a syringe.
Disconnect the brake fluid warning lamp connector.
Retrieve the brake fluid reservoir from its supply pipes by pulling upwards.
Finish emptying the reservoir of brake fluid.
Clean the brake fluid reservoir.
Refit the brake fluid reservoir.
Reconnect the brake fluid warning lamp connector.
Filling.
Refill the reservoir with brake fluid.
WARNING: Use only the recommended hydraulic fluids.
Bleeding.
NOTE:Two technicians are required.
IMPERATIVE: During bleed operations, ensure that the level of brake fluid is maintained
in the reservoir and top it up, use only new brake fluid.
Bleed each wheel cylinder, proceeding in the following order:
- Rear right hand wheel.
- Front left hand wheel.
- Rear left hand wheel.
- Front right hand wheel.
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 427