2005 CHRYSLER SEBRING SEDAN checking oil

•To avoid drawing exhaust gases into the vehicle, close
the trunk while driving. However, if for some reason it
must remain open, close all windows. Adjust the
heating or cooling system to force outside air into the
vehicle. Set the blower at high speed.
Safety Checks You Should Make Inside the
Vehicle
Seat Belts
Inspect the belt system periodically, checking for cuts,
frays and loose parts. Damaged parts must be replaced
immediately. Do not disassemble or modify the system.
Safety belt assemblies must be replaced after a collision if
they have been damaged (bent retractor, torn webbing,
etc.). If there is any question regarding belt or retractor
condition, replace the belt.
Airbag Light
The light should come on and remain on for 6 to
8 seconds as a bulb check when the ignition
switch is first turned ON. If the bulb is not lit
during starting, have it replaced. If the light stays on or
comes on while driving, have the system checked by an
authorized dealer.
Defrosters
Check operation by selecting the defrost mode and place
the blower control on high speed. You should be able to
feel the air directed against the windshield.
Periodic Safety Checks You Should Make Outside
the Vehicle
Tires
Examine tires for excessive tread wear or uneven wear
patterns. Check for stones, nails, glass, or other objects
lodged in the tread. Inspect for tread cuts or sidewall
cracks. Check wheel nuts for tightness, and tires (includ-
ing spare) for proper pressure.
Lights
Have someone observe the operation of exterior lights
while you work the controls. Check turn signal and high
beam indicator lights on the instrument panel.
Fluid Leaks
Check area under vehicle after overnight parking for fuel,
water, oil, or other fluid leaks. Also, if gasoline fumes are
present, the cause should be corrected immediately.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 49
2

WARNING!
You can be badly injured working on or around a
motor vehicle. Do only that service work for which
you have the knowledge and the proper equipment.
If you have any doubt about your ability to perform
a service job, take your vehicle to a competent
mechanic.
MAINTENANCE PROCEDURES
The pages that follow contain therequiredmaintenance
services determined by the engineers who designed your
vehicle.
Besides the maintenance items for which there are fixed
maintenance intervals, there are other items that should
operate satisfactorily without periodic maintenance.
However, if a malfunction of these items does occur, it
could adversely affect the engine or vehicle performance.
These items should be inspected if a malfunction is
observed or suspected.
Engine Oil
Checking Oil Level
To assure proper lubrication of your vehicle’s engine, the
engine oil must be maintained, at the correct level. Check
the oil level at regular intervals, such as every fuel stop.
The best time to check the oil level is about 5 minutes
after a fully warmed engine is shut off or before starting
the engine after it has sat overnight.
Checking the oil while the vehicle is on level ground will
improve the accuracy of the oil level readings. Maintain
the oil level between the MIN and MAX markings on the
dipstick. Adding one quart of oil when the reading is at
the MIN mark will result in a MAX reading on these
engines.
206 MAINTAINING YOUR VEHICLE

Refrigerant Recovery and Recycling
R-134a Air Conditioning Refrigerant is a hydrofluorocar-
bon (HFC) that is endorsed by the Environmental Pro-
tection Agency and is an ozone-saving product. How-
ever, the manufacturer recommends that air conditioning
service be performed by dealers or other service facilities
using recovery and recycling equipment.
NOTE:Use only manufacturer approved A/C System
Sealers, Stop Leak Products, Seal Conditioners, Compres-
sor Oil, or Refrigerants.
Power Steering—Fluid Check
Checking the power steering fluid level at a defined
service interval is not required. The fluid should only be
checked if a leak is suspected, abnormal noises are
apparent, and/or the system is not functioning as antici-
pated. Coordinate inspection efforts through a certified
“DaimlerChrysler Dealership”.
Before removing the reservoir cap, wipe the outside of
the cap and reservoir so that no dirt can fall into the
reservoir.
WARNING!
Fluid level should be checked on a level surface with
the engine off to prevent injury from moving parts,
and to insure accurate fluid level reading. Do not
overfill. Use only the manufacturer’s recommended
fluid.
Power Steering Fluid Reservoir
MAINTAINING YOUR VEHICLE 215
7

WARNING!
Riding the brakes can lead to brake failure and
possibly an accident. Driving with your foot resting
or riding on the brake pedal can result in abnormally
high brake temperatures, excessive lining wear, and
possible brake damage. You may not have your full
braking capacity in an emergency.
Brake and Power Steering System Hoses
When servicing the vehicle for scheduled maintenance,
inspect surface of hoses and nylon tubing for evidence of
heat and mechanical damage. Hard and brittle rubber,
cracking, checking, tears, cuts, abrasion, and excessive
swelling suggest deterioration of the rubber. Particular
attention should be made to examining those hose sur-
faces nearest to high heat sources, such as the exhaust
manifold.
Inspect all hose clamps and couplings to make sure they
are secure and no leaks are present.
Insure nylon tubing in these areas has not melted or
collapsed.
NOTE:Often, fluids such as oil, power steering fluid,
and brake fluid are used during assembly plant opera-
tions to ease the assembly of hoses to couplings. There-
fore, oil wetness at the hose-coupling area is not neces-
sarily an indication of leakage. Actual dripping of hot
fluid when systems are under pressure (during vehicle
operation) should be noted before hose is replaced based
on leakage.
NOTE:Inspection of brake hoses should be done
whenever the brake system is serviced and every engine
oil change.
WARNING!
Worn brake hoses can burst and cause brake failure.
You could have an accident. If you see any signs of
cracking, scuffing, or worn spots, have the brake
hoses replaced immediately.
MAINTAINING YOUR VEHICLE 225
7

Use the schedule that best describes your driving condi-
tions. Where time and mileage are listed, follow the
interval that occurs first.
NOTE:Under no circumstances should oil change
intervals exceed 6 months or 6,000 miles, whichever
comes first.
CAUTION!
Failure to perform the required maintenance items
may result in damage to the vehicle.
At Each Stop for Fuel
•
Check the engine oil level about 5 minutes after a fully
warmed engine is shut off. Checking the oil level while
the vehicle is on level ground will improve the accu-
racy of the oil level reading. Add oil only when the
level is at or below the ADD or MIN mark.
•Check the windshield washer solvent and add if
required.
Once a Month
•
Check tire pressure and look for unusual wear or
damage.
•Inspect the battery and clean and tighten the terminals
as required.
•Check the fluid levels of coolant reservoir, brake
master cylinder, and transaxle and add as needed.
•Check all lights and all other electrical items for correct
operation.
•Check rubber seals on each side of the radiator for
proper fit.
248 MAINTENANCE SCHEDULES
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Daytime Brightness, Interior Lights.......... 65
Daytime Running Lights.................. 67
Dealer Service......................... 205
Defroster, Rear Window.................. 136
Defroster, Windshield...............49,130,135
Diagnostic System, Onboard............... 203
Dimmer Control........................ 64
Dimmer Switch, Headlight................. 68
Dipsticks
Automatic Transaxle................... 228
Disposal
Antifreeze (Engine Coolant)............. 223
Engine Oil.......................... 210
Door Ajar Warning...................... 17
Door Locks............................ 15
Door Locks, Automatic................... 17
Door Opener, Garage..................... 74
Drive Belts............................ 210
Driving
On Slippery Surfaces.................. 195
Electrical Outlet, Auxiliary................. 81
Electrical Power Outlets................... 81Electronic Speed Control.................. 71
Emergency, In Case of
Freeing Vehicle When Stuck............. 196
Jacking............................. 187
Jump Starting........................ 192
Overheating......................... 186
Towing............................. 196
Emergency Trunk Release...............24,25
Emission Control System Maintenance....204,246
Engine............................201,202
Air Cleaner Filter..................... 211
Block Heater......................... 146
Break-In Recommendations............... 48
Checking Oil Level.................... 206
Compartment.....................201,202
Coolant (Antifreeze)................220,244
Cooling............................ 220
Exhaust Gas Caution.................. 177
Fails to Start......................... 146
Fuel Requirements.................174,243
Oil ..........................206,243,244
Oil Change Interval................... 207
Oil Selection......................208,243
INDEX 281
10

Lubrication, Body....................... 216
Luggage/Cargo Capacity................. 179
Lumbar Support........................ 60
Maintenance Free Battery................. 212
Maintenance Procedures.................. 206
Maintenance Schedule................... 247
Light Duty ScheduleB................ 250
ScheduleA......................... 260
ScheduleB......................... 250
Malfunction Indicator Light.............91,204
Manual, Service........................ 272
Mirrors............................... 56
Automatic Dimming.................... 56
Electric Remote....................... 57
Outside............................. 57
Rearview............................ 56
Vanity.............................. 58
Modifications/Alterations, Vehicle............ 7
Mopar Parts........................205,272
Multi-Function Control Lever............... 66
Navigation System...................... 119New Vehicle Break-In Period............... 48
Occupant Restraints...................... 26
Odometer............................. 92
Tampering........................... 92
Trip ................................ 92
Oil, Engine......................206,243,244
Capacity............................ 243
Change Interval...................... 207
Checking........................... 206
Disposal............................ 210
Filter...........................210,244
Filter Disposal....................... 210
Identification Logo.................182,208
Materials Added to.................... 210
Pressure Gauge....................... 93
Quality..........................182,208
Recommendation..................208,243
Synthetic........................... 209
Viscosity.........................209,243
Onboard Diagnostic System............203,204
Opener, Garage Door..................... 74
Operator Manuals (Owner’s Manuals)......... 4
286 INDEX