2005 CHEVROLET COBALT heater

[x] Cancel search: heater

Page 65 of 362

CHEVROLET COBALT 2005 1.G Owners Manual Keys...............................................................2-2
Remote Keyless Entry System.........................2-3
Remote Keyless Entry System Operation...........2-4
Doors and Locks......

Page 84 of 362

CHEVROLET COBALT 2005 1.G Owners Manual Starting Procedure
1. With your foot off the accelerator pedal, turn your
ignition to START. When the engine starts, let go
of the key. The idle speed will go down as your
engine gets warm.
Notice:Hol

Page 85 of 362

CHEVROLET COBALT 2005 1.G Owners Manual To Use the Engine Coolant Heater
1. Turn off the engine.
2. Open the hood and unwrap the electrical cord. For
the 2.2L engine, the electrical cord is located on the
passenger’s side of the vehicle b

Page 205 of 362

CHEVROLET COBALT 2005 1.G Owners Manual Run your engine only as long as you must. This saves
fuel. When you run the engine, make it go a little
faster than just idle. That is, push the accelerator
slightly. This uses less fuel for the heat

Page 243 of 362

CHEVROLET COBALT 2005 1.G Owners Manual Hydraulic Clutch
The hydraulic clutch linkage in your vehicle is
self-adjusting. This system does not have its own
reservoir. It receives �uid from the brake master cylinder
reservoir.
SeeBrakes on pa

Page 244 of 362

CHEVROLET COBALT 2005 1.G Owners Manual What to Use
Use a mixture of one-half clean, drinkable water and
one-half DEX-COOL®coolant which will not damage
aluminum parts. If you use this coolant mixture, you do
not need to add anything else.

Page 250 of 362

CHEVROLET COBALT 2005 1.G Owners Manual If No Steam Is Coming From Your
Engine
An engine coolant temperature warning can indicate a
serious problem. SeeEngine Coolant Temperature
Warning Light on page 3-29.
If you get an engine coolant temp

Page 252 of 362

CHEVROLET COBALT 2005 1.G Owners Manual If the coolant inside the coolant surge tank is boiling, do
not do anything else until it cools down. The vehicle
should be parked on a level surface.
The coolant level should be at the COLD FILL line
Page:   1-8 9-16 next >