Inspection I
Only those items of inspection work which apply to your vehicle will be performed. This list is
subject to amendment.
Undercarriage
7
3 Series325i, 325Ci, 325iT
+ Conv. SULEV (PZEV)
Change oil and oil filter while engine is at normal operating • •
temperature. We recommend BMW 5W-30 High Performance
Synthetic Oil, p/n 07 51 0 017 866.
Check transmission for leaks. • •
Check rear axle for leaks. • •
Half-shafts: Check for leaks at flexible boots. • •
Visually check fuel tank, lines and connections for leaks. • •
Check condition, position, and mounting of exhaust system. • •
Examine for leaks.
Check power steering system for leaks. Check power steering • •
fluid level; add fluid if necessary.
Check steering for absence of play, condition of suspension track • •
rods, front axle joints, steering linkage and joint disc.
Check overall thickness of front and rear disc brake pads using • •
special tool. If replacement is necessary: Examine brake disc surfaces.
Clean brake pad contact points in calipers. Grease wheel centering
hubs. Check thickness of parking brake linings only when replacing
rear brake pads.
Check brake system connections and lines for leaks, damage • •
and incorrect positioning.
Check parking brake actuation. Adjust if necessary. • •
Check all tire pressures (including spare). Correct if necessary. • •
Check condition of tires (outer surface [left/right]), tread wear and
pattern; in case of uneven tread wear, readjust wheel alignment
if requested (invoice separately).
Inspect entire body according to terms of rust perforation limited • •
warranty (Must be performed at least every two years).
Engine Compartment
Read out diagnostic system. • •
Check engine cooling system/heater hose connections for leaks. • •
Check coolant level and antifreeze protection level. Add coolant
if required.
Check windshield washer fluid level and antifreeze protection. • •
Fill up and/or correct if required.
Check air conditioner for operation. • •
Replace microfilter. (Note: reduce replacement interval in dusty • •
operating conditions.)
Reset service interval indicator.••
3 Series325i, 325Ci, 325iT
+ Conv. SULEV (PZEV)
Replace air cleaner element. (Note: Reduce replacement interval • •
in dusty operating conditions).
Inspection II
Includes all items listed under Inspection I, and the following checks
and maintenance operations.
Engine Compartment
9
Brake Fluid Service
Replace brake fluid every 2 years (time interval begins from the • •
vehicle’s production date).
Oxygen Sensor Service
Replace Oxygen Sensor every 120,000 miles (non-SMG). •
Replace Oxygen Sensor every 100,000 miles (only SMG). •
Replace Oxygen Sensor every 150,000 miles. •
Spark Plug Service
Replace spark plugs every 100,000 miles. • •
Automatic Transmission Service
Replace ATF every 100,000 miles. • •
BMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
11
BMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
12
BMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Inspection I BMW Inspection IBMW Inspection I BMW Inspection I
BMW Inspection I
Date/Stamp/Signature
BMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/SignatureBMW Engine Oil Service BMW Engine Oil ServiceBMW Engine Oil Service BMW Engine Oil Service
BMW Engine Oil ServiceDate/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
BMW Inspection II BMW Inspection IIBMW Inspection II BMW Inspection II
BMW Inspection II
Date/Stamp/Signature
13
The maintenance schedule as shown
is required for the proper functioning
of the emission control systems for
optimum vehicle performance and fuel
economy.
Abbreviations:
I - Inspect
R - Replace part(s) and/or fluid listed
Basic Engine
Engine oil....................................................
Engine oil filter..........................................
Fuel System
Air filter.......................................................
Ignition System
Spark plugs...............................................
Emission Control Components
Oxygen sensor..........................................
Emission Control Maintenance Schedule
3 Series and 325i, 325Ci, 325iT SULEV (PZEV)
Oxygen Sensor Service: The oxygen sensor deteriorates strictly on a mileage basis and must
therefore be replaced to maximize vehicle fuel economy and minimize exhaust pollution.
The mileage interval varies according to individual driving conditions and is determined by the
service interval indicator.
14
Oil Service
Inspection I
Oil Service
Inspection II
RRR R
RRR R
R
Replace at intervals of
100,000 miles
Replace at intervals of
120,000 miles
(SMG: 100,000 miles)3 Series
Oil Service
Inspection I
Oil Service
Inspection II
RRR R
RRR R
R
Replace at intervals of
100,000 miles
Replace at intervals of
150,000 miles 325i, 325Ci, 325iT
SULEV (PZEV)
If your car is driven only for short distances of
less than 10 miles over a prolonged period of
time, without an occasional drive at highway
speeds, the engine’s charging system will not
maintain the battery. Insufficient use of the
vehicle could result in short term starting
problems and in the long term could damage
the battery.
In case the car is not operated for more than
four weeks it is advisable to:
a) consider using a proper trickle charger,
following the charger manufacturer’s
instructions, to maintain the battery’s state of
charge; or
b) consult your BMW center regarding battery
removal. Once removed, the battery must be
charged and stored in a cool, dry place
where it can be protected from freezing. If
the battery will be stored for over 3 months, it
must be recharged every 3 months, or else it
will become damaged and useless.
Please consult with your BMW center for
further guidance and information.
Corrosion Protection
Extensive corrosion protection measures
implemented by BMW now make it possible to
offer a twelve-year limited mileage anti-
corrosion warranty against rust perforation on
your vehicle provided that the vehicle is
maintained in accordance with the provisions
of the New Vehicle Limited Warranty as
outlined in the Warranty Section of this
Statement (page 30).
The major degree of corrosion protection is
due to the electrophoretic dip painting process
which cathodically deposits paint particles on
all body parts, attracting paint particles into the
minutest cavities or seams. Body parts are
designed to provide optimum corrosion
protection.During manufacture, exterior body parts
receive an additional corrosion protection coat.
Hood, trunk, doors and other body parts with
metal folds are coated with PVC and sealed
from the outside.
All floor panels receive a resilient coating of
PVC for maximum protection against damage
due to stones, etc.
Corrosion protection materials tested over
many years are applied to the surfaces of
cavities and to the entire underside of the
vehicle during and after assembly.
Requirements for maintaining the twelve-year
unlimited mileage anti-corrosion warranty are
outlined in the Warranty Section of this
Statement (page 32).
Restoring corrosion protection
Please take care that anti-corrosion material is
replaced when your car is repaired after body
or chassis damage.
BMW will not accept any liability for any
parts and accessories not approved by
BMW.
Underbody maintenance
The underbody has to be cleaned at least
once a year, in spring, with plain water in order
to remove mud, chemical sediments and other
deposits. If those materials are not removed,
corrosion (rust) will occur.
Your BMW center will do this anti-corrosion
service for you.
WARNING
Do not apply additional undercoating or rust-
proofing on or near the exhaust manifold,
exhaust pipes, catalytic converter or heat
shields. During driving, the substance used
for undercoating could overheat and cause
a fire.
Battery Care
15
Your satisfaction with our product and the
services provided by authorized BMW centers
is of great importance to us. We take pride in
our product, as does the BMW center who
services it. If you should ever have a question
regarding your BMW center’s service or your
BMW's performance, we recommend that you
contact your authorized BMW center. Should
you travel to an unfamiliar area, the BMW
center directory provided at the time of delivery
will help you locate the nearest authorized
BMW center. The centers listed are equipped
to help you with all matters related to your
BMW vehicle.
When contacting an authorized BMW center,
we suggest that depending upon the nature of
your contact, you discuss it with either the
Sales, Service, or Parts Manager.
As all matters are resolved at the BMW center
level, it is important that they be given the
opportunity to provide a solution. Should you
feel that you were not provided with the proper
response, we urge you to contact the General
Manager or BMW Center Operator.
Despite the best intentions of all parties, a
misunderstanding may occur between you
and your BMW center. Should this occur and
you require further assistance, you may wish
to contact the BMW NA Customer Relations
Department at 1- 800-831-1117 or through our
website at www.bmwusa.com. When contact-
ing us, we ask that you provide the following
information:
1. Your name, address and telephone number.
2. Vehicle Identification Number (last seven
digits).
3. Vehicle’s delivery date.
4. Vehicle mileage.
5. Selling BMW center’s name.6. Servicing BMW center’s name.
7. Description of the problem.
A BMW NA Customer Relations Representa-
tive will carefully review all the facts involved
and let you know what further action will be
taken in conjunction with your BMW center.
Please remember: the first step in resolving a
complaint is to contact the authorized BMW
center that performed the work on your vehicle.
They have the necessary equipment and the
personnel to achieve this goal.
We are confident that every effort will be made
to ensure your satisfaction.
Customer Assistance
Information
22