CD/SD85
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP
MP3 ctrl control buttonForward/reverse within the trackFig. 86 MP3: Forward within a track–Press the MP3 ctrl control button in the MP3 menu.
–Select >> (“Forward”) fig.86 or << (“Rewind”) by
rotating the control knob..
– Hold down the control knob.The track advances or reverses for as long as you hold the control
knob down.
MP3 track next/previousFig. 87 MP3: Track next–Press the MP3 ctrl control button in the MP3 menu.
– Select >| (“Next”) fig.87 or |< (“Previous”) by rotating
the control knob.
– Press the control knob.The next or previous track will be played.
Adjusting sound settings93
General operation
RADIO, CD
NAME, TEL
NAV, INFO
CAR, SETUP The following sound adjustments are possible:
Balance (left/right volume relationship)
Fader (front/rear sound relationship)
Tr e b l e
Bass
DSP (Digital Signal Processing)
page 93
Volume settings (Navigation info)
page 94
The sound setting for the Tre b l e and Bass (lows) can be adjusted
separately for radio, CD and MP3 operation.
The settings that you enter apply to the operating mode that is
currently active in the Navigation System. If you change the bass
setting, for example, when playing a CD, it will not affect radio or
MP3 operation.
DSP (Digital Signal Processing)Fig. 98 DSP: GALA settings– Press the control button for the Sound function from an
audio or Setup menu.
– Select DSP.
– Select GALA.
– Select one of the five levels, or
– Select off to switch the function off.Th e GALA function matches the volume to the speed to compensate
for road and wind noise.
If you set level 1, the volume is increased less as speed increases. If
you set level 5, the volume is increased more as speed increases.
Navigation (NAV) 134Memory control buttonPrevious destinations
The previous destinations are stored and can be
loaded directly as a navigation destination.Fig. 140 Navigation: select previous destinations–Press the Memory c o n t r o l b ut t o n i n t h e n a v i g a t i o n m e n u .
– Select Previous destinations. You will see a list of the
most recently entered destinations. This list is updated
automatically.
– Select your desired entry.
– Select Start route guidance.Tips
There may be entries which cannot be displayed fully in the
display because they contain too many letters and are too long. If
you select one of these entries using the control knob, a second
window will open up after a few seconds. You will be given addi-
tional information about the selected entry in this window.
The list of previous destinations can be deleted in the Setup
Navigation menu
page 156.
To p c a t e g o r i e sFig. 141 Navigation: Top categories–Press the Memory control button in the navigation menu.
