Page 94 of 307

GETTING TO KNOW YOUR CAR
92
Warning
light on dialMessage
on display
GLOW PLUGS
Turning the key to MARthe warning light on the reconfigurable multifunction display turns on;
the warning light turns off when the glow plugs have reached the pre-established temperature.
Start the engine as soon as the warning light goes off.
IMPORTANTWith a high environment temperature, the warning light may turn on for an
imperceptible length of time.
WATER IN FUEL OIL FILTER
The message + symbol are shown by the reconfigurable multifunction display when there is
water in the fuel oil filter.
The presence of water in the supply circuit may cause serious dam-
age to the entire injection system and cause irregular engine opera-
tion. If the message + symbol are shown by the reconfigurable multi-
function display, contact Alfa Romeo Authorised Services as soon as possible
to have the system relieved.
GLOW PLUG WARMING FAILURE
The message + symbol are shown by the reconfigurable multifunction display when there is a
failure in the glow plug warming system. Contact Alfa Romeo Authorised Services as soon as pos-
sible to have the fault eliminated.
Page 124 of 307

GETTING TO KNOW YOUR CAR
122
WING MIRROR AND
REARSCREEN
DEFROSTING/DEMISTING
BUTTON
(fig. 113)
Pressing button (9)
(turns on demist-
ing/defrosting of the rearscreen and, if pre-
sent, the wing mirror coils.
The turning on of this function is shown by
the turning on of the led on the button.
This function is timed and switches off au-
tomatically after 20 minutes, or pressing the
button again; the function is also switched
off when the engine is stopped and will not
be switched on again the next time the en-
gine is started.
IMPORTANTThe system automatically
turns on rearscreen heating if the tempera-
ture is below 3
°C.
IMPORTANTDo not apply stickers on
the inside of the rearscreen over the heat-
ing filaments to avoid damage that might
cause it to stop working properly.
POLLEN FILTER
Have the conditions of the filter checked
by Alfa Romeo Authorised Services at least
once a year, preferably at the onset of sum-
mer.
If the vehicle is used mainly in dusty or pol-
luted areas it should be checked and, if nec-
essary, replaced at shorter intervals.
A0A0214b
The filter has the specific capability of com-
bining the mechanical filtering of the air with
an electrostatic effect so that the outside air
admitted to the passenger compartment is
purified and free of particles such as dust,
pollen, etc.
In addition to the above mentioned func-
tion, it also reduces the concentration of pol-
lutants.
The filtering action takes place under all
air inlet conditions and it is clearly most ef-
fective with the windows shut.The failure to replace the
filter may considerably re-
duce the effectiveness of
the climate control system up to
blocking the air flow from the out-
lets and vents.
fig. 113
Page 244 of 307
IN AN EMERGENCY
242
40
30
50
15
15
15
15
25
7,5
15
15
30
30
50
20
150
40
60
20 F05 (MAXI-FUSE)
F06 (MAXI-FUSE)
F07 (MAXI-FUSE)
F10
F21
F22
F21
F60 (*)
F16
F61 (*)
F62 (*)
F08
F72 (MAXI-FUSE)
F01 (MAXI-FUSE)
F20
F70 (MEGA-FUSE)
F06 (MAXI-FUSE)
F07 (MAXI-FUSE)
F22 53
53
53
53
53
53
53
52
53
52
52
53
54
53
53
54
53
53
53
SERVICES FIGURE FUSE AMPERES
(*) Fuse behind dashboard control box on an auxiliary bracket.
Climate control fan
Radiator fan (first speed - petrol versions)
Radiator fan (second speed - petrol versions)
Horn
Fuel pump
Injectors (petrol versions)
Ignition coils
Tailgate electric unlocking
Electronic injection system
Bose system
Bose system
Additional heater
Ignition switch
Glow plug warming (JTD versions)
Heated fuel oil filter (JTD versions)
Engine compartment control box (JTD versions)
Radiator fan (first speed – JTD versions)
Radiator fan (second speed – JTD versions)
Injectors (JTD versions)
Page 251 of 307
●●
●
●
●
●●●
●●●●
●●
●●●●●●●●●
●●●
●●●●●●●●●
●●●●●●●●●
●●●●
VEHICLE MAINTENANCE
249
20 40 60 80 100 120 140 160 180Thousands of km
(*) Or every 3 years for harsh conditions (cold climates, city driving or prolonged lengths of time at idle speed, dusty roads or roads covered with sand and/or salt).
Or every 5 years, regardless of mileage.
Sight check for conditions of timing gear drive toothed belt
Change counter-rotating shaft drive belt
Change timing gear drive belt (*)
Change accessory poly-V drive belt
Change spark plugs
Check operation of engine control system (through diagnosis socket)
Check mechanical transmission oil level
Change engine oil and engine oil filter
Change brake fluid (or every 2 years)
Change fuel filter (JTD versions)
Change pollen filter (or every year)
Check emissions/smoke at the exhaust (JTD versions)
Page 252 of 307

VEHICLE MAINTENANCE
250
ADDITIONAL
OPERATIONS
Every 1000 kmor before long jour-
neys, check and if necessary top up:
– engine coolant fluid level
– brake/hydraulic clutch control fluid
level
– power steering fluid level
– windscreen and headlamp washer
fluid level
– tyre pressure and conditions.
Every 3000 kmcheck and if necessary
top up the engine oil level.
The use of FL Seleniaproducts is rec-
ommended which have been designed
and made expressly for Alfa Romeo cars
(see “Refuelling” in the “Technical
Specifications” chapter).
ANNUAL INSPECTION
PROGRAMME
For cars with an annual mileage
of below 20,000 km (for exam-
ple about 10,000 km) the follow-
ing yearly inspection programme
is advised:
– Check tyre conditions/wear and if
necessary adjust the pressure (including
spare wheel)
– Check operation of lighting system
(headlights, direction indicators, hazard
warning lights, boot, passenger compart-
ment, glovebox lights, warning lights,
etc.)
– Check operation of windscreen wiper
system, spray jet adjustment
– Check position/wear of windscreen
– Check front disk brake pad conditions
and wear– Sight check for conditions of: engine,
gearbox, transmission, pipes (exhaust -
fuel supply - brakes), rubber parts (boots
- sleeves - bushes etc..), brake and fuel
supply system hoses
– Check for bonnet and boot lock clean-
ness, lever cleanness and lubrication
– Check battery charge
– Sight check for conditions of various
drive belts
– Check and if necessary top up fluid
levels (engine coolant, brakes, wind-
screen washer, battery etc. )
– Change engine oil and engine oil filter
– Change pollen filter.
Page 253 of 307

VEHICLE MAINTENANCE
251
IMPORTANT
Engine oil
Should prevailing use of the car be under
one of the following specially heavy con-
ditions:
– trailer or caravan towing
– dusty roads
– short distances (less than 7-8 km)
repeated and with external temperatures
below zero
– frequently idling engines or long dis-
tance low speed driving or in case of a
long term inactivity
replace engine oil more frequently than
required on Service Schedule.IMPORTANT
Diesel filter
The different grades of purity in diesel
fuel normally available might make it nec-
essary to replace the filter more frequent-
ly than indicated in the Service Schedule.
If the engine misfires it shows the filter
needs changing.IMPORTANT
Air cleaner
Using the car on dusty roads change the
air cleaner more frequently than specified
in the Schedule Maintenance Programme.
For any doubts concerning the intervals
between the engine oil and air cleaner
replacement in relation to how the vehicle
is used, contact Alfa Romeo Authorised
Services.
Page 257 of 307

VEHICLE MAINTENANCE
255
ENGINE OIL (fig. 4-4a-5-6)
The engine oil should be checked with
the vehicle on a level surface a few min-
utes (about 5) after the engine has been
switched off.
Remove the dipstick (A), clean it, put it
back in completely, remove it and check
that the level is within the MINand
MAXmarks on the dipstick. The interval
between the MINandMAXmarks cor-
respond to about one litre of oil.When the engine is hot,
take care when working
inside the engine com-
partment to avoid burns.
Remember that when the engine
is hot, the fan may cut in: danger
of injury.
Do not add oil with spec-
ifications (classification,
viscosity) other than
those of the oil already in the
engine.
fig. 4 - 1.8 T. SPARK version
A0A0737b
fig. 6 - JTD 16Vversion
A0A0398b
AB
fig. 5 - 3.2 V6version
A0A0406b
If the oil level is near or even below the
MINmark, add oil through the filter neck
(B), until reaching the MAXmark.
IMPORTANTIf a routine check
reveals that the level is above the MAX
mark, contact Alfa Romeo Authorised
Services to have the correct level restored.
IMPORTANTAfter topping up the oil,
before checking the level again, run the
engine a few seconds and wait for a few
minutes ater stopping it.
fig. 4a - 2.0 JTS version
A0A0682b
Page 258 of 307

VEHICLE MAINTENANCE
256
Used engine oil and filter
contain harmful sub-
stances for the environ-
ment. Contact Alfa Romeo
Authorised Services to have the
oil and the filter changed, as they
are equipped to dispose of the
waste oil and filters respecting
nature and the law.
SELESPEED TRANSMISSION
OIL
(fig. 7)
The Selespeed transmission oil should be
checked with the vehicle on a level sur-
face and with the engine stopped and
cold.
To check the level, proceed as follows:
– turn the ignition key to MAR;
– disconnect the breather tube and
remove the cap (A) checking that the
level corresponds with the MAXmark on
the dipstick integrated with the cap;
– if the oil is below the MAXmark, top
up to reach the correct level;Do not add oil with spec-
ifications other than that
already in the gearbox.
fig. 7
A0A0197b
Used gearbox oil con-
tains dangerous sub-
stances for the environ-
ment. For changing the oil we
advise contacting Alfa Romeo
Authorised Services who are
equipped for disposing of used oil
respecting nature and the law.
Be very careful working
inside the engine com-
partment if the engine is
hot: danger of burns. Remember
that the fan may cut in if the
engine is very hot: danger of
injury.
Engine oil consumption
Max engine oil consumption is usually
400 grams every 1000 km.
During the initial period of use the
engine settles, therefore engine oil con-
sumption may be considered stabilised
only after the first 5000 ÷ 6000 km.
IMPORTANTEngine oil consumption
depends on the way of driving and the
conditions of use of the vehicle.– after refitting the cap, insert the
breather tube firmly on the housing on the
cap and turn the ignition key to STOP.