Page 255 of 307
VEHICLE MAINTENANCE
253
1Engine oil - 2Battery - 3Brake fluid -4
Windscreen/rearscreen/headlamp
washer fluid - 5Engine coolant fluid -
6Power steering fluid - 7Selespeed
transmission oil (2.0 JTS Selespeed ver-
sions)
CHECKING LEVELS
Never smoke while
working in the engine
compartment; gas and
inflammable vapours may be pre-
sent, with the risk of fire.
When topping up take
care not to confuse the
various types of fluids:
they are incompatible with one
another and could seriously dam-
age the vehicle.fig. 1 - 1.8 T. SPARK version
A0A0736b
A0A0681b
fig. 1a - 2.0 JTS version
Page 257 of 307

VEHICLE MAINTENANCE
255
ENGINE OIL (fig. 4-4a-5-6)
The engine oil should be checked with
the vehicle on a level surface a few min-
utes (about 5) after the engine has been
switched off.
Remove the dipstick (A), clean it, put it
back in completely, remove it and check
that the level is within the MINand
MAXmarks on the dipstick. The interval
between the MINandMAXmarks cor-
respond to about one litre of oil.When the engine is hot,
take care when working
inside the engine com-
partment to avoid burns.
Remember that when the engine
is hot, the fan may cut in: danger
of injury.
Do not add oil with spec-
ifications (classification,
viscosity) other than
those of the oil already in the
engine.
fig. 4 - 1.8 T. SPARK version
A0A0737b
fig. 6 - JTD 16Vversion
A0A0398b
AB
fig. 5 - 3.2 V6version
A0A0406b
If the oil level is near or even below the
MINmark, add oil through the filter neck
(B), until reaching the MAXmark.
IMPORTANTIf a routine check
reveals that the level is above the MAX
mark, contact Alfa Romeo Authorised
Services to have the correct level restored.
IMPORTANTAfter topping up the oil,
before checking the level again, run the
engine a few seconds and wait for a few
minutes ater stopping it.
fig. 4a - 2.0 JTS version
A0A0682b
Page 258 of 307

VEHICLE MAINTENANCE
256
Used engine oil and filter
contain harmful sub-
stances for the environ-
ment. Contact Alfa Romeo
Authorised Services to have the
oil and the filter changed, as they
are equipped to dispose of the
waste oil and filters respecting
nature and the law.
SELESPEED TRANSMISSION
OIL
(fig. 7)
The Selespeed transmission oil should be
checked with the vehicle on a level sur-
face and with the engine stopped and
cold.
To check the level, proceed as follows:
– turn the ignition key to MAR;
– disconnect the breather tube and
remove the cap (A) checking that the
level corresponds with the MAXmark on
the dipstick integrated with the cap;
– if the oil is below the MAXmark, top
up to reach the correct level;Do not add oil with spec-
ifications other than that
already in the gearbox.
fig. 7
A0A0197b
Used gearbox oil con-
tains dangerous sub-
stances for the environ-
ment. For changing the oil we
advise contacting Alfa Romeo
Authorised Services who are
equipped for disposing of used oil
respecting nature and the law.
Be very careful working
inside the engine com-
partment if the engine is
hot: danger of burns. Remember
that the fan may cut in if the
engine is very hot: danger of
injury.
Engine oil consumption
Max engine oil consumption is usually
400 grams every 1000 km.
During the initial period of use the
engine settles, therefore engine oil con-
sumption may be considered stabilised
only after the first 5000 ÷ 6000 km.
IMPORTANTEngine oil consumption
depends on the way of driving and the
conditions of use of the vehicle.– after refitting the cap, insert the
breather tube firmly on the housing on the
cap and turn the ignition key to STOP.
Page 260 of 307

Oil consumption is very
low; if topping up again is
needed shortly after-
wards, have the system checked
for possible leaks by Alfa Romeo
Authorised Services.
VEHICLE MAINTENANCE
258
When loosening the
reservoir cap do not
allow the fluid to come
into contact with painted parts. If
it does, wash it off immediately
with water. Do not allow the power
steering fluid to touch hot
parts of the engine: it is
inflammable.
fig. 10
A0A0217b
fig. 9
A0A0400b
BRAKE AND HYDRAULIC
CLUTCH FLUID
(fig. 10)
Slacken the cap (A) and check that the
fluid contained in the reservoir reaches the
maximum mark.
POWER STEERING FLUID
(fig. 9)
Check that the level of the oil in the
reservoir is at maximum.
This operation should be carried out with
the vehicle on a level surface and the
engine switched off and cold.
Check that the level reaches the MAX
mark on the reservoir or coincides with the
upper notch (maximum level) on the dip-
stick (A) integral with the reservoir cap.
If the oil level in the reservoir is below
the specified one, top up only with one of
the products listed in the “Fluid and lubri-
cant Specification” table in the “Technical
Specifications” chapter proceeding as fol-
lows:– Start the engine and wait for the oil
level in the reservoir to stabilise.
– With the engine running, turn the
steering wheel lock to lock a few times.
– Top up to the MAXlevel notch, then
refit the cap.
Page 294 of 307

INDEX
292
- windows ............................... 269
Climate control, automatic
two-zone ................................. 109
Climate control system .......... 103-111
Controls ..................................... 124
CO
2emissions ............................ 287
CODE card .................................. 7
Compact spare wheel .................. 214
- characteristics ........................... 277
Correct use of the car........... 200
Courtesy light
- changing bulbs ....................... 234
Cruise control ............................. 49
Dashboard................................. 52
Demisting-defrosting
- door mirrors ................ 24-107-123
- rearscreen ....................... 105-123
- windscreen and front
side windows ................... 107-122
Diesel fuel filter ........................... 260
Digital multifunction display .......... 57
Direction indicators
- changing front bulbs ................ 229
- changing rear bulbs ................. 230- changing side bulbs ................. 229
- switching on .................... 44-45-46
Door locking system .................... 125
Door mirrors ............................... 23
Doors
- central locking ........................ 16
- opening/closing from inside ..... 15
- opening/closing from outside ... 15
- remote control ........................ 7
- remote locking/unlocking ........ 6-7
Electronic alarm system ............... 11
Emergency starting ...................... 210
- coasting ................................ 212
- starting with an auxiliary
battery .................................. 211
Engine
- identification codes/marking .... 272
- specifications ......................... 273
Engine compartment
- bonnet .................................. 147
Engine starting ........................... 200
- emergency starting ................. 202- ignition switch ........................ 14
- procedure for JTD versions ........ 201
- procedure for petrol versions ..... 200
- switching off .......................... 202
- warming the engine ................ 201
Engine oil consumption ................ 256
EOBD (system) ........................... 155
External lights (switching on) ....... 44
First-aid kit................................. 246
Flashing high beams .................... 45
Fluids (specifications) .................. 284
Follow me home device ............... 46
Foglights
- changing bulbs ................. 225-227
- switching on .......................... 124
Front ceiling light ........................ 138
- changing bulbs ....................... 232
Fuel
- at the filling station ................. 273
- automatic shut off switch ......... 125
- consumption .......................... 286
- fuel cap ................................. 198
- level gauge and reserve ........... 56