2005 Alfa Romeo 156 check oil

GETTING TO KNOW YOUR CAR68
If the display shows an anomaly message, see paragraph
“Warning lights and indications” in this chapter.
INITIAL CHECK
By turning the ignition key to the MARposition, the Infocenter display will show the message CHECK ACTIVE: this indicates the start of the
diagnosis phase for all the electronic systems available on the vehicle; this phase lasts a few seconds (in diesel versions only, the Infocenter
display is able to provide the engine oil level indication too, see following paragraph “Engine oil level check”). If, during this phase, no anom-
aly is found and after the engine has been started, the display will show the message CHECK OK.
Standard screen display
JTD versions only
If no
failures
are
present
Is the
engine
started?
YES
NO
or
continues on next page

GETTING TO KNOW YOUR CAR70
Engine oil level check
(JTD versions only)
By turning the ignition key to the MAR
position, the Infocenter display will show the
engine oil level display for about 3 seconds.
During this phase, to clear the display and
move to the following screen, press
ç
.
WARNINGTo ensure correct reading of
the engine oil level, the check must be car-
ried out with the vehicle on level ground.The following display in fig. 90refers to
correct engine oil level. As the oil level grad-
ually falls, the full bars go off leaving room
for the empty bars.
fig. 90
A0B2129g
fig. 91
A0B2134g
fig. 92
A0B2135g
The following fig. 91andfig. 92re-
fer to the display with an oil level below the
foreseen minimum. Under this condition, the
bars are all empty with symbol and warn-
ing messages.

GETTING TO KNOW YOUR CAR71
The following refers to the display
(fig. 93) (appearing for about 3 seconds)
with an oil level above the foreseen maxi-
mum. Under this condition the bars are all
full.fig. 93
A0B2136g
Contact Alfa Romeo Au-
thorized Services to have
the engine oil restored to
its correct level.
Restore correct engine oil
level (see paragraph
“Checking fluid levels” in
chapter “Car maintenance”).Do not add oil with dif-
ferent characteristics from
those of the oil already
used in the engine (see “Fluids and
lubricants” in chapter “Car main-
tenance”).

GETTING TO KNOW YOUR CAR96
<
SEAT BELTS NOT FASTENEDThe warning light on the check panel will turn on for some seconds when, with the ignition key at
MAR, the driver’s seat belt is not fastened properly.
Warning lightMessage
on displayv
LOW OIL PRESSUREWhen the ignition key is turned to MAR, the warning light on the check panel comes on but
must go out as soon as the engine is started.
w
LOW BATTERY CHARGEWhen the ignition key is turned to MAR, the warning light on the check panel comes on, but must
go out as soon as the engine is started (a slight delay is permitted when the engine is running at
idle). It if stays on, contact Alfa Romeo Authorized Services immediately.
If the warning light
v
comes on when travelling (together with
the message + symbol shown on the display), switch the engine off im-
mediately and contact Alfa Romeo Authorized Services.WARNING

GETTING TO KNOW YOUR CAR
179
If the
x
low brake fluid
warning light comes on (to-
gether with the message + symbol
shown by the display), stop the car
immediately and contact the near-
est Alfa Romeo Authorized Ser-
vices. Indeed, any leak of fluid
from the hydraulic system com-
promises the effectiveness of both
the conventional brake system and
the system with antilock system.
WARNING
The turning on of the
>
warning light (together
with the message + symbol shown
by the display) with the engine
running normally indicates an ABS
system fault. In this case the brak-
ing system preserves its effec-
tiveness, without however making
use of the antilock device. Under
these circumstances, the EBD sys-
tem may fail to give top perfor-
mance. In this case, too, you are
recommended to contact Alfa
Romeo Authorized Services imme-
diately, driving in such a way as to
avoid abrupt braking, to have the
system checked.
WARNING
VDC AND ASR
SYSTEMS(where required)VDC SYSTEM (VEHICLE
DYNAMICS CONTROL):
GENERALThe VDC is an electronic vehicle stability
control system which, acting on the torque
and braking the wheels in a differentiated
manner, helps to bring the car back to the
correct course in the event of loss of grip.
While travelling the car is subjected to lat-
eral and longitudinal forces that may be
controlled by the driver up to when the
tyres offer adequate road-holding; when
this falls below the minimum level, the car
starts to deviate from the course required
by the driver.
Above all on rough surfaces (such as cob-
bles, or due to the presence of water, ice
or soil), changes in speed (when accelerat-
ing or braking) and/or course (bends or the
need to avoid obstacles) can cause the tyres
to lose grip.When the sensors detect the conditions
that would lead to skidding, the VDC system
acts on the engine and brakes generating
a stabilising torque.
The system performance
levels, in terms of active
safety, should not induce the dri-
ver to run pointless and unjustified
risks. Driving conduct should al-
ways be suited to the conditions of
the road surface, vision and traf-
fic. The responsibility for road
safety is always and anyway the
vehicle driver’s concern.
The VDC system helps the driver
to keep control of the car in the
event of loss of tyre grip.
The forces induced by the VDC sys-
tem to control the lack of stability
of the car always and anyway de-
pend on the grip between the tyre
and the road surface.
WARNING

CORRECT USE OF THE CAR
192
SAFE DRIVINGIn designing your Alfa 156, Alfa
Romeo has worked thoroughly to achieve a
vehicle able to offer top levels of safety to
its passengers. However, the behaviour of
the driver is still a decisive factor for road
safety.
Below you will find a few simple rules for
travelling safely under different conditions.
You are certainly familiar with many of them
but it is still helpful to read them all care-
fully.BEFORE DRIVING OFF– Make sure the lights and headlights are
working properly.
– Adjust the seat, steering wheel and
rearview mirrors, in order to obtain a correct
position for driving.
– Adjust the seat back upright and keep
your head as close as possible to the head
restraint.– Carefully adjust the headrests so that
the head and not the neck rests on them.
Check that nothing (mats, etc.) can get un-
der the foot pedals.
– Make sure that any child restraint sys-
tem (seats, cradles, etc.) are correctly fas-
tened on the rear seat.
– Place any objects in the boot with care
to prevent abrupt braking from throwing
them forwards.
– Avoid heavy meals before a journey. A
light meal will help to keep reflexes ready.
Above all avoid alcohol.
Routinely remember to check:
– tyre pressure and conditions;
– engine oil level;
– engine coolant level and system condi-
tions;
– brake fluid level;
– power steering oil level;
– windscreen washer fluid level.
WHEN TRAVELLING– The first rule for safe driving is care.
– Care also means being able to predict
the actions of other road users.
– Strictly respect the traffic regulations in
all countries, especially the speed limits.
– Ensure that both yourself and your pas-
sengers are wearing their seat belts, that
children are carried with the appropriate
seats and that any animals are in appropri-
ate compartments.
– Long distances should be trackled in
good health.
Driving under the influence
of drugs and/or some
medicines is highly dangerous for
oneself and for others.
WARNING

CORRECT USE OF THE CAR
196
Tyres
Tyres should be checked at least every four
4 weeks: if the pressure is too low, fuel con-
sumption increases as the resistance to the
rolling movement of the tyre is higher. In
this state, tyre wear is increased
and vehicle handling suffers which will af-
fect safety.
Unnecessary loads
Do not travel with too much luggage stowed
in the boot. The weight of the vehicle (es-
pecially when driving in town) and its trim
greatly affects consumption and stability.
Luggage/ski rack
Remove luggage or ski racks from the roof
of the vehicle as soon as they are no longer
needed. These accessories reduce the aero-
dynamic penetration of the vehicle and will
increase consumption. When transporting
particularly large objects, use a trailer where
possible.Electrical devices
Use the electric devices for the necessary
time only. The heated rear window, supple-
mentary lights, windscreen wipers, heating
system blower require large amounts of en-
ergy and, increasing the request for power
also increases fuel consumption (up to
+25% when driving in built-up areas).
Air conditioner
The air conditioner is an additional load
which greatly affects the engine leading to
higher consumption (on average up to
+20%). When the temperature outside the
vehicle permits it, use the air vents where
possible.
Spoilers
The use of aerodynamic optional extras
which are not certified for the specific use
on the vehicle, may reduce the aerodynamic
penetration of the vehicle and increase con-
sumption.
STYLE OF DRIVINGStarting
Do not warm the engine when the vehicle
is stationary or at high or low revs: in this
way the engine will warm up gradually in-
creasing consumption and emissions. You
should drive off slowly straight away avoid-
ing high revs so that the engine will warm
up more quickly.
Unnecessary actions
Avoid revving the engine when stopped at
traffic lights or before switching off the en-
gine and avoid doubling the clutch as these
actions have no purpose on modern vehicles
and serve only to increase consumption and
pollution.
Gear selection
As soon as the traffic and road conditions
allow it, shift to a higher gear. Using a lower
gear to liven up acceleration greatly in-
creases consumption. In the same way, im-
proper use of the higher gears will increase
consumption, emissions and wear and tear
on the engine.

CORRECT USE OF THE CAR
204
REMOVING FROM STORAGEBefore using your vehicle after a long pe-
riod of inactivity, the following operations
should first be carried out:
– Do not dust the outside of the vehicle.
– Visually check that there are no leaks
(oil, brake and clutch fluid, engine coolant,
etc.).
– Replace engine oil and filter.
– Check:
- brake-clutch fluid level
- level of engine coolant fluid.
– Check the air cleaner and replace if nec-
essary.
– Check tyre pressure and ensure that they
are not damaged, cracked or cut. If they are
they must be replaced.– Check the state of the drive belts.
– Reconnect the battery negative termi-
nal (–) after checking that the charge is ad-
equate.
– With the gear lever in neutral start the
engine and allow the engine to run for a few
seconds whilst repeatedly working the clutch
pedal.
USEFUL ACCESSORIESIn addition to the legal requirements, we
recommend keeping the following in the car
(fig. 1):
– first aid kit with non-alcoholic base dis-
infectant, steril gauzes, a roll of gauze, plas-
ters, etc.;
– torch;
– round-ended scissors;
– work gloves.fig. 1
A0B0389m
This operation must be per-
formed in the open. The
exhaust gases contain carbon
monoxide which is extremely toxic
and may also be lethal.
WARNING