Page 52 of 243
ÎÎ
ÎThe U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Instrument Panel
Inst rument s and Cont rols
51
HIGH BEAM INDICATOR
CRUISE CONTROL INDICATOR
PARKING BRAKE AND BRAKE SYSTEM
INDICATOR
MALFUNCTION INDICATOR LAMP
LOW OIL PRESSURE INDICATOR
CHARGING SYSTEM INDICATOR MAINTENANCE REQUIRED
INDICATOR
IMMOBILIZER SYSTEM
INDICATOR
SECURITY SYSTEM
INDICATOR (P.
54)
ANTI-LOCK BRAKE SYSTEM INDICATOR (P. 53)
(P. 54)
(P. 54)
(P. 56)
(P.
55)
(P.53)
(P. 205)
(P. 53, 204)
(P. 53, 204) SUPPLEMENTAL RESTRAINT SYSTEM INDICATOR
(P.
52)
SIDE AIRBAG OFF INDICATOR (P. 52)
TURN SIGNAL AND HAZARD
WARNING INDICATOR (P.
54)
(P. 52)
SEAT BELT REMINDER
INDICATOR
(P. 54) SELECT/RESET
BUTTON
DOOR-OPEN INDICATOR
LOW FUEL INDICATOR (P.
54)
Page 55 of 243

Only on models equipped with CruiseControl System
This indicator comes on when you
set the cruise control. See page f or inf ormation on operating the
cruise control.
This indicator comes on if either
door is not closed tightly.
This indicator comes on as a
reminder that you must ref uel soon.
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicator does not
blink or blinks rapidly, it usually
means one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press on the Hazard
Warning button, both turn signal
indicators blink. All turn signals on
the outside of the vehicle should
flash.
This indicator comes on with the
high beam headlights. For more
inf ormation, see page .This indicator comes on f or a f ew
seconds when you turn the ignition
switch to ON (II). It will go of f if you
have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page ).
This indicator also blinks several
times when you turn the ignition
switch f rom ON (II) to ACCESSORY
(I) or LOCK (0).
115
61
174
65
Instrument Panel Indicators
Cruise Control Indicator
Door-open Indicator
Low Fuel Indicator
Turn Signal and
Hazard Warning
Indicators
High Beam Indicator Immobilizer System
Indicator
54
Page 65 of 243
The valet key works only in the
ignition and the door locks. You can
keepthegloveboxlockedwhenyou
leave your vehicle and the valet key
at a parking facility.
Youshouldhavereceivedakey
number tag with your keys. You will
need this key number if you ever
have to get a key replaced. Use only
an Acura-approved key blank.These keys contain electronic
circuits that are activated by the
Immobilizer System. They will not
work to start the engine if the
circuits are damaged.
Protect the keys f rom direct
sunlight, high temperature, and
high humidity.
Donotdropthekeysorsetheavy
objects on them.
Keep the keys away f rom liquids.
If they get wet, dry them
immediately with a sof t cloth.
The keys do not contain batteries.
Do not try to take them apart.
The master key fits all the locks on
your vehicle.
Keys and Locks
64
KEY
NUMBER
TAG
MASTER KEY
(BLACK)
VALET
KEY
(GREY)
Page 67 of 243

µµ
µ
µ You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or
ACCESSORY (I) position and open
thedriver’sdoor.Removethekeyto
turn of f the beeper.
If your vehicle has an automatic
transmission, the shif t lever must be
in Park bef ore you can remove the
key f rom the ignition switch.
The ignition switch has f our
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III). You can insert or
remove the key only in this position.
To turn the key, you must push the
key in slightly. If your vehicle has an
automatic transmission, the shif t
lever must also be in park. If the f ront wheels are turned, the
anti-thef t lock may make it dif f icult
to turn the key. Firmly turn the
steering wheel to the lef t or right as
you turn the key.
You can
operate the audio system and the
accessory power sockets in this
position.
This is the normal key
position when driving. Several of the
indicators on the instrument panel
come on as a test when you turn the
ignition switch f rom ACCESSORY
(I) to ON (II).
Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key.
Ignition Switch
LOCK (0) A CCESSORY (I)
ON (II)
ST A RT (III)
66
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control of the
vehicle.
Remove the key from the
ignition switch only when
parked.
Page 68 of 243
To lock both doors and the hatch,
press the master door lock switch on
either door, press the lock tab down
on the driver’s door, or use the key
on the outside lock.
Pulling up on either master door lock
switch will unlock both doors and the
hatch.
To unlock the driver’s door f rom the
outside, turn the key and release it.
If you turn and hold it, both doors
and the hatch unlock. Both doors
and the hatch unlock when you use
the key in the passenger’s door.
Each door has a lock tab at the top of
the door. When you push down the
lock tab on the driver’s door, both
doors and the hatch lock. The lock
tab on the passenger’s door locks
and unlocks only that door. Pulling
up on the driver’s door lock tab only
unlocks the driver’s door.
Door L ocks
Door L ocks Power Door/Hatch L ocks
Inst rument s and Cont rols
67
LOCK TAB MASTER DOOR AND HATCH
LOCK SWITCH
Page 69 of 243
To open the hatch, pull the handle,
then lif t up the hatch.
To close the hatch, press down on
the back edge.
The hatch will not lock or unlock
when the battery is disconnected.See page f or cargo loading and
weight limit inf ormation. Keep the
hatch closed at all times while
driving to avoid damaging the hatch
and to prevent exhaust gas from
getting into the interior. See
on page .45
129
Door L ocks
Hatch
Carbon
Monoxide Hazard
68
Pull
Page 70 of 243

µµ
”
CONT INUED
Pressthisbuttontolock
both doors and the hatch. You
cannot lock the doors or the hatch if
either door or the hatch is not f ully
closed or if the key is in the ignition
switch. Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.Pressthisbuttonfor
about 1 second to attract attention;
the horn will sound and the exterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter, or turn the ignition
switch to ON (II).
Press this button once
to unlock the driver’s door. Push it
twice to unlock the passenger’s door
and the hatch.
Some exterior lights will f lash each
time you press the button.
The interior lights will come on
when you press the UNLOCK button.
If you do not open either door or the
hatch within 30 seconds, the lights
f ade out. If you relock the doors and
the hatch with the remote
transmitter before 30 seconds have
elapsed, the light will go of f
immediately;
If you do not open either door or the
hatch within 30 seconds, they will
automatically relock and the security
system sets. If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.
Remote Transmitter
LOCK PA NIC
UNL OCK
Remote Transmitter Care
Inst rument s and Cont rols
69
LED
UNLOCK
BUTTON LOCK
BUTTON
PANIC
BUTTON
Page 71 of 243

´
If it takes several pushes on the
button to lock or unlock the doors
and the hatch, replace the battery as
soon as possible.
Battery type: CR2025
To replace the battery, place a cloth
on the edge of the transmitter and
remove the upper half by carefully
prying on the edge with a small f lat-
tip screwdriver.
Insert a new battery with the side
f acing up.
Snapthetwohalvesof the
transmitter case back together.
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Remote Transmitter
Replacing the Transmitter Battery
70