2005 Acura RL set time

µ
You’ll f ind many saf ety
recommendations throughout this
section, and throughout this manual.
Therecommendationsonthispage
are the ones we consider to be the
most important.
Excessive speed is a major f actor in
crash injuries and deaths. Generally,
the higher the speed, the greater the
risk, but serious injuries can also
occur at lower speeds. Never drive
f aster than is saf e f or current
conditions, regardless of the
maximum speed posted.
Having a tire blowout or a
mechanical f ailure can be extremely
hazardous. To reduce the possibility
of such problems, check your tire
pressures and condition f requently,
and perform all regularly scheduled
maintenance (see page ).
A seat belt is your best protection in
all types of collisions. Airbags are
designed to supplement seat belts,
not replace them. So even though
your vehicle is equipped with airbags,
make sure you and your passengers
always wear your seat belts, and
wear them properly (see page ).
Children age 12 and under should
ride properly restrained in a back
seat. Infants and small children
should be restrained in a child seat.
Larger children should use a booster
and a lap/shoulder belt until they
canusethebeltproperlywithouta
booster (see pages ). While airbags can save lives, they
can cause serious or fatal injuries to
occupants who sit too close to them,
or are not properly restrained.
Inf ants, young children, and short
adults are at the greatest risk. Be
sure to f ollow all instructions and
warnings in this manual.
Alcohol and driving don’t mix. Even
one drink can reduce your ability to
respond to changing conditions, and
your reaction time gets worse with
every additional drink. So don’t drink
and drive, and don’t let your f riends
drink and drive, either.
17
50 53 298
Important Saf ety Precautions
Always Wear Your Seat BeltControl Your Speed
K eep Your Vehicle in Saf e
Condition
Restrain All Children Be Aware of Airbag Hazards
Don’t Drink and Drive
8

This indicator normally comes on
when you turn the ignition to ON (II)
and goes off after the engine starts.
If it comes on at any other time,
there is a problem with the power
steering system. You will also see a
‘‘CHECK POWER STEERING
SYSTEM’’ message on the multi-
inf ormation display (see page ). If
this happens, stop the vehicle in a
saf e place, and turn of f the engine.
Reset the system by restarting the
engine, and watch this indicator. If it
does not go of f , or comes back on
again while driving, take the vehicle
to your dealer to have it checked.
With the indicator on, the ECPS is
turned of f , which could make the
vehicle harder to steer.This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). If it comes
on at any other time, it indicates that
there is a problem with the system.
You will also see a ‘‘CHECK
KEYLESS ACCESS SYSTEM’’
message on the multi-inf ormation
display (see page ). For more
inf ormation, see page .
This indicator comes on when there
is a system message in the multi-
inf ormation display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.
The indicator comes on when you
gun the engine while the vehicle is
not moving. To turn the indicator of f ,
restart the engine. 76
140
77 76
69
Instrument Panel Indicators
K eyless Access System
Indicator Message Indicator
Electronically Controlled
Power Steering System
(ECPS) Indicator
66

ÛÝ
The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.You can change the display and
customize your vehicle control
settings by pressing the SEL/RESET
or INFO buttons on the right side of
the steering wheel.With the ignition switch in the ON
(II) position, the lower part of the
multi-inf ormation display changes as
shown in the illustration, each time
you press the SEL/RESET button.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-inf ormation display. When you
turn the ignition switch from ON (II)
position to ACCESSORY (I) position,
a ‘‘Goodbye’’ message is shown on
the display.
Multi-Inf ormation Display
Inst rument s and Cont rols
69
SEL
RESET
BUTTON
U.S.
CANADA
INFO ( / )
BUTTONS

The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial
regulations to disconnect, reset, or
alter the odometer with the intent to
change the number of miles or
kilometers indicated.This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
To reset a trip meter, display it, then
press and hold the SEL/RESET
button until the number resets to
‘‘0.0’’.When you reset Trip A, average f uel
economy A is reset at the same time.
When you reset Trip B, average f uel
economy B is reset.
In the customizing mode, you can set
Trip A and average f uel economy A
to reset at the same time when you
ref uel your vehicle (see page ).
84
Multi-Inf ormation Display
Odometer T rip Meter
70
ODOMETER
TRIP METER

Along with the trip meter, the trip
computer calculates these values:Range is the estimated distance you
cantravelonthefuelremainingin
the tank. This distance is estimated
f rom the f uel economy you received
over the last several miles, so it will
vary with changes in speed, traf f ic,
etc.
When you turn the ignition switch to
the LOCK (0) position, ELAPSED
TIME is reset.
When Trip A is reset, average f uel
economy A is reset at the same time.
When Trip B is reset, average f uel
economy B is reset at the same time. Instant Fuel Economy
Range
Average Vehicle Speed Elapsed Time
Average Fuel Economy
Trip Computer
Multi-Inf ormation Display
Inst rument s and Cont rols
73

You can receive or make phone calls
f rom your cell phone through your
Acura’s HandsFreeLink (HFL)
system without touching your cell
phone.When the engine oil lif e reaches 15
percent, the display shows
‘‘SERVICE DUE SOON’’ and the
code f or the maintenance items to be
perf ormed.
When the engine oil lif e reaches 5
percent, the display shows
‘‘SERVICE DUE NOW’’ along with
the same maintenance items.Have your dealer do the indicated
maintenance as soon as you see this
message, and have them reset the
display af ter completing the service.
If you do not perf orm the indicated
maintenance or do not reset the
display, the message changes to
‘‘SERVICE PAST DUE’’ when the
engine oil lif e becomes 0 percent.
These messages appear on the multi-
inf ormation display each time you
turn the ignition switch to ON (II).
For details on engine oil lif e and
maintenance messages, ref er to page
.
Also ref er to page f or important
maintenance saf ety precautions.
To use the system, your cell phone
and the HFL system must be linked.
Not all cell phones are compatible
with this system. Ref er to page
for instructions on how to link
your cell phone to the HFL and how
to receive or make phone calls. 291
290
230
HandsFreeL ink
Maintenance Messages
Multi-Inf ormation Display
Inst rument s and Cont rols
75
TM

ÛÝ
µ™´
µ™´¶
¶
With the multi-information display
and the , , and SEL/RESET
buttons on the right side of the
steering wheel, you can change
several vehicle control settings to
your pref erence (see page ).
To change the settings, the ignition
switch must be in the ON (II)
position.
Here are the settings you can
change: 81
CUST OMIZE MENU
ENGLISH
FRENCH
SPANISH5°F 5°F
3°C 3°C
ON
OFF
ON
OFF
ON
OFF
ALL DOORS
ON
OFF
ON
OFF
60 SEC
30 SEC
15 SEC
60 SEC
30 SEC
See page
83
See page
83
See page
84
See page
86
See page
86
See page
89
See page
89
See page
90
See page
92
See page
92
LANGUAGE
SELECTION
ADJUST OUTSIDE
TEMP. DISPLAY
TRIP A & AVG. FUEL A
RESET with REFUEL
EXIT
MEMORY POSIT ION
LINK
AUTO TILT &
TELESCOPIC
EXIT
DOOR UNLOCK MODE
KEYLESS ACCESS
LIGHT FLASH
KEYLESS ACCESS
BEEP
EXIT
INTERIOR LIGHT
DIMMING T IME
HEADLIGHT AUT O
OFF TIMER
MET ER SET UP
POSITION SETUP
KEYLESS ACCESS
SETUP
LIGHTING SETUP
DEFAULT
ENGLISH
0°F
0°C
OFF
ON
ON
ON
ON
30 SEC
15 SECCUST OMIZE SET UP
DRIVER DOOR ONLY
CUST OMIZE GROUP
DRIVER
DOOR ONLY
Multi-Inf ormation Display
Customized Settings
78

If you turn the ignition switch to
ACCESSORY (I) or LOCK (0), or
move the shift lever out of Park, the
display will change to the normal
screen.
To have the driver’s ID detected,
make sure your remote is linked to
the system (seeon page ). Then use your
remote to unlock the doors (see on page ).
When the ignition switch is in the
ON (II) position, the multi-
inf ormation display shows the driver’s
ID.
You cannot customize the setting; When the keyless memory
settings are of f (see page ).
When you disconnect the vehicle
battery, and then do not unlock
the door.
When the multi-information
display does not show the driver’s
ID. 86
88
167CUST OMIZE MENU 15 SEC
0SEC
MAX
HIGH
MID
LOW
MIN
SHIFT FROM P
WITH VEH SPD
OFF
SHIFT TO P
IGN OFF
OFF
DRIVER DOOR
ALL DOORS
ON
OFF
90 SEC
60 SEC
30 SEC
INTERMITTENT
WITH VEH SPDDEFAULT
15 SEC
MID
WITH VEH
SPD
SHIFT TO
P
DRIVER
DOOR
ON
30 SEC
WITH VEH
SPD
See page
92
See page
93
See page
95
See page
96
See page
97
See page
97
See page
98
See page
100
LIGHTING SETUP
DOOR/WINDOW
SETUP
WIPER SETUP
HEADLIGHT AUT O
OFF TIMER
AUTO LIGHT
SENSITIVITY
EXIT
AUTO DOOR LOCK
AUTO DOOR UNLOCK
DOOR LOCK MODE
SECURITY RELOCK
TIMER
EXIT
WIPER ACTION
EXIT
EXITCUST OMIZE SET UP
CUST OMIZE GROUP
KEYLESS LOCK
ACKNOWLEDGMENT
Multi-Inf ormation Display
Memory Position
Link
K eyless A ccess Setup
Inst rument s and Cont rols
79