B
A
2
3
4
26
I
I N B R I E F
IC R U I S E C O N T R O L /«C R U I S E»
This driving assistance function allows you to drive at the speed of your
choIce without the need to action the accelerator.
It is available at speeds above 40 km/h (25 mph), in the higher gears
only.
Control A for cruise control is located below the lighting/signalling control
stalk.
Note: Information relating to the cruise control is displ ayed in zone B
on the display.
To select the function
Turn control 1 to the « CRUISE » position.
To select a cruise speed
On selection of the function via control 1, no cruise
speed has yet been memorised.
Accelerate to the desired speed, then give a short press on button 2 or
button 4.
The cruise speed is then memorised. It is displayed
in zone B on the screen.
The trip mileage recorder then displays.
You can then release the accelerator pedal. The veh icle will
automatically keep to that chosen speed
Note : The vehicle speed may vary slightly from that memor ised.
Cruise control should only be used when the traffi c conditions permit driving at a constant speed.
B
1
A
2
3
4
28
I
I N B R I E F
IS P E E D L I M I T E R / « L I M I T »
This driving assistance function allows you to choo se a maximum speed that you wish not to exceed. This has to be a speed greater than 30 km/h (approx. 20 mph).
Control A for the speed limiter is located below the lightin g/signalling Acontrol stalk.
Note: The information relating to the speed limiter is shown in zone B on the screen.
To select the function
Turn control 1 to the position « LIMIT ».
On selection of the function via control 1, the last speed memorised is displayed.
To adjust the maximum speed
Provided the engine is running, you adjust the memo rised speed by pressing :- button 4 to increase the memorised speed,- button 2 to decrease the memorised speed.Note: successive presses will modify the speed in steps of 1 km/h and a continuous press in steps of 5 km/h.
Activation of the maximum speedAs you see the desired maximum speed displayed, pre ss control 3 to activate 3the limitation.
The information « OFF » then disappears from zone B.
The trip mileage recorder is shown.
While the function is active, action on the accelerator pedal will not
permit the programmed speed to be exceeded, unless you press the
pedal hard down to go beyond the tight spot (see «Temporary override of the maximum speed»).
Note : the vehicle speed may vary slightly from that memor ised.
