2004 YAMAHA GRIZZLY 125 fuel

5-7
w
Always check the brakes at the start of every
ride. Do not ride the ATV if you find any
problem with the brakes or you could lose
braking ability, which could lead to an acci-
dent. If a problem cannot be corrected by the
adjustment procedures provided in this man-
ual, have the ATV inspected by a Yamaha
dealer.
EBU09981
Fuel
Make sure there is sufficient gasoline in the
tank.q
w
1. Filler tube 2. Fuel level1. Tube de remplissage 2. Niveau de carburant1. Tubo de llenado 2. Nivel de combustible
1C5-9-60-05 15/12/03 7:59 PM Page 8

5-9
NOTE:
(for Europe only)
If knocking or pinging occurs, use a different
brand of gasoline or higher octane grade.
cC
Use only unleaded gasoline. The use of lead-
ed gasoline will cause severe damage to
internal engine parts, such as the valves and
piston rings, as well as to the exhaust sys-
tem.
Recommended fuel:
Unleaded gasoline only
For Europe: Regular unleaded gasoline
only with a research octane number of
91 or higher
Fuel tank capacity:
Total: 7.6 L
Reserve: 1.3 L
1C5-9-60-05 15/12/03 7:59 PM Page 10

5-11
w
8Do not overfill the fuel tank. Fuel expands
when it heats up. If the fuel tank is over-
filled, fuel could spill out due to heat from
the engine or the sun.
8Be careful not to spill fuel, especially on
the engine or exhaust pipe which can
cause a fire and severe injury. Wipe up
any spilled fuel immediately.
8Do not refuel right after the engine has
been running and is still very hot.
8Be sure the fuel tank cap is closed secure-
ly.
EBU11163
Engine and final transmission oil
Make sure the engine and final transmission oil
is at the specified level. Add oil as necessary.
(See page 8-13–8-25.)
1C5-9-60-05 15/12/03 7:59 PM Page 12

6-3
EBU00510
Starting a cold engine
w
Always make sure all control cables work
smoothly before you begin riding in cold
weather. If the control cables are frozen or
do not work smoothly, you could be unable
to control the ATV, which could lead to an
accident or collision.
1. Set the parking brake.
2. Turn the fuel cock to “ON”.
3. Turn the main switch to “ON” and the engine
stop switch to “RUN”.
4. Shift the drive select lever to neutral.
1C5-9-60-06 11/12/03 7:25 PM Page 4

6-23
EBU00211
Parking
When parking, stop the engine and shift into
neutral. Turn the fuel cock to “OFF” and apply
the parking brake.
1
1. Locked position1. Verrouillé1. Posición de bloqueada
1C5-9-60-06 11/12/03 7:25 PM Page 24

8-7
EBU00262
PERIODIC MAINTENANCE/LUBRICATION
INITIAL EVERY
ITEM ROUTINE
13661
monthmonths months monthsyear
Valves*• Check valve clearance.
1111
• Adjust if necessary.
• Check condition.
Spark plug• Adjust gap and clean.11111
• Replace if necessary.
Air filter element
• Clean. Every 20–40 hours
(for engine and V-belt
• Replace if necessary. (more often in wet or dusty areas)
case)
Carburetor*• Check idle speed/starter operation.
1111
• Adjust if necessary.
Cylinder head cover• Check breather hose for cracks or damage.
111
breather system*• Replace if necessary.
• Check leakage.
Exhaust system*• Retighten if necessary.111
• Replace gasket if necessary.
Fuel line*• Check fuel hose for cracks or damage.
111
• Replace if necessary.
Engine oil• Replace (warm engine before draining).1111
Oil strainer*• Clean.
111
• Replace if necessary.
Drive chain• Check and adjust slack/alignment/clean/lube.11111
Final transmission oil• Check oil level/oil leakage.
11
• Replace every 12 months.
1C5-9-60-08 9/12/03 8:38 PM Page 8-8

8-45
EBU00303
Valve clearance adjustment
The correct valve clearance changes with use,
resulting in improper fuel/air supply or engine
noise. To prevent this, the valve clearance must
be adjusted regularly. This adjustment however,
should be left to a professional Yamaha service
technician.
EAU00307
Throttle lever adjustment
NOTE:
Adjust the engine idling speed before adjusting
the throttle lever free play.
1. Loosen the locknut.
2. Turn the adjusting bolt until the throttle lever
free play is 3–5 mm.
3. Tighten the locknut.a q
w
1. Locknut 2. Adjusting bolt a.Free play1. Contre-écrou 2.Dispositif de réglagea. Jeu 1. Contratuerca 2.Tornillo de ajustea. Juego
1C5-9-60-08 9/12/03 8:38 PM Page 8-46

8-95
EBU00413
Troubleshooting
Although Yamaha machines receive a rigid
inspection before shipment from the factory,
trouble may occur during operation.
Any problem in the fuel, compression, or ignition
systems can cause poor starting and loss of
power. The troubleshooting chart describes a
quick, easy procedure for making checks. If
your machine requires any repair, take it to a
Yamaha dealer.
The skilled technicians at a Yamaha dealership
have the tools, experience, and know-how to
properly service your machine. Use only gen-
uine Yamaha parts on your machine. Imitation
parts may look like Yamaha parts, but they are
often inferior. Consequently, they have a short-
er service life and can lead to expensive repair
bills.
1C5-9-60-08 9/12/03 8:38 PM Page 8-96