INSTRUMENT AND CONTROL FUNCTIONS
3-14
3
EAU13430
Catalytic converter This model is equipped with a catalytic
converter in the exhaust chamber.
WARNING
EWA10860
The exhaust system is hot after op-
eration. Make sure that the exhaust
system has cooled down before do-ing any maintenance work.CAUTION:
ECA10700
The following precautions must be
observed to prevent a fire hazard or
other damages.
Use only unleaded gasoline.
The use of leaded gasoline will
cause unrepairable damage to
the catalytic converter.
Never park the vehicle near pos-
sible fire hazards such as grass
or other materials that easily
burn.
Do not allow the engine to idletoo long.
EAU14080
Seats Rider seat
To remove the rider seat1. Insert the key into the seat lock,
and then turn it as shown.
2. Pull the rider seat off.
To install the rider seat1. Insert the projection on the front of
the rider seat into the seat holder
as shown, and then push the rear
of the seat down to lock it in place.2. Remove the key.
Passenger seat
To remove the passenger seat
1. Remove the rider seat.
2. Pull the passenger seat up.
To install the passenger seat1. Slide the receptacle on the rear of
the passenger seat over the seat
holder as shown, and then push
the front of the seat down.
1. Rider seat lock
2. Unlock.
1. Projection
2. Seat holder
5JWE3.book Page 14 Friday, September 5, 2003 3:08 PM
PERIODIC MAINTENANCE AND MINOR REPAIR
6-6
6
To install the panel
1. Place the panel in the original posi-
tion, and then tighten the quick fas-
tener and install the bolts.2. Install panel A (to complete the in-
stallation of panel B) or panel D (to
complete the installation of panel
C).
EAU19192
Panel D
To remove the panelRemove the bolts, and then take the
panel off.
To install the panelPlace the panel in the original position,
and then install the bolts.
EAU33370
Panels E and F
To remove one of the panels1. Remove the seats. (See page
3-14.)
2. Remove the bolts, the quick fas-
tener screw and the quick fasten-
ers, and then take the panel off.
To install the panel1. Place the panel in the original posi-
tion, and then install the quick fas-
teners and quick fastener screw,
and tighten the bolts.
2. Install the seats.
1. Bolt
2. Quick fastener
1. Bolt
2. Quick fastener
1. Bolt
1. Bolt
2. Quick fastener screw
3. Quick fastener
5JWE3.book Page 6 Friday, September 5, 2003 3:08 PM
