2004 TOYOTA YARIS spare wheel

1452005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)

Do not put any part of your
body under the vehicle sup-
ported by the jack. Personal in-
j u ry may occu r.

Do not start or run the engine
while your vehicle is supported
by the jack.

Stop the vehicle on a level firm
ground, firmly set the parking
brake and put the transmission
in “P” (automatic) or reverse
(manual). Block the wheel diag-
onally opposite to the one be-
ing changed if necessary.

Make sure to set the jack prop-
erly in the jack point. Raising
the vehicle with jack improper-
ly positioned will damage the
vehicle or may allow the ve-
hicle to fall off the jack and
cause personal injury.

Never get under the vehicle
when the vehicle is supported
by the jack alone.
Use the jack only for lifting
your vehicle during wheel
changing.

Do not raise the vehicle with
someone in the vehicle.

When raising the vehicle, do
not put an object on or under
the jack.

Raise the vehicle only high
enough to remove and change
the tire.
NOTICE
Do not continue driving with a
deflated tire. Driving even a
short distance can damage a
tire and wheel beyond repair.
SZ41023
Compact spare tire
The compact spare tire is designed
for temporary emergency use only.
The compact spare tire is identified
by the distinctive wording “TEM-
PORARY USE ONLY” molded into the
sidewall of the tire.
To keep the compact spare tire no-
ticeable, do not hide the wheel by a
wheel cover or such.
04 05.18

1472005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU41111b
1. Get the required tools andspare tire.
1. Tool tray
2. Spare tire
3. Jack
SU41114b
Tool tray
1. Jack handle
2. Wheel nut wrench
SU41121a
Glove box
Ti e −down belt
To prepare yourself for an emergency,
you should familiarize yourself with
the use of the jack, each of the tools
and their storage locations.
04 05.18
—R eq u ired to o ls an d sp are
tire

1492005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
When storing the spare tire, put it in
place with the outer side of the wheel
facing up. Then secure the tire by re-
peating the above removal steps in
reverse order to prevent it from flying
forward during a collision or sudden
braking.
The compact tire storage area is de-
signed only for a compact spare tire.
Standard size tire cannot be stored
in this storage area.
—Blocking the wheel
SY41007
2. Block the wheel diagonally op-posite the flat tire to keep the
vehicle from rolling when it is
jacked up.
When blocking the wheel, place a
wheel block in front of one of the front
wheels or behind one of the rear
wheels.
—Loosening wheel nuts
SY41012
3. Loosen all the wheel nuts.
Always loosen the wheel nuts before
raising the vehicle.
The nuts turn counterclockwise to
loosen. To get maximum leverage, fit
the wrench to the nut so that the han-
dle is on the right side, as shown
above. Grasp the wrench near the
end of the handle and pull up on the
handle. Be careful that the wrench
does not slip off the nut.
Do not remove the nuts yet—just un-
screw them about one −half turn.
04 05.18

1502005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
CAUTION
Never use oil or grease on the
bolts or nuts. The nuts may loos-
en and the wheels may fall off,
which could cause a serious ac-
cident.
—Positioning the jack
SU41125
4. Position the jack at the correctjack point as shown.
Make sure the jack is positioned on
a level and solid place.
—Raising your vehicle
SU41126
5. After making sure that no one is in the vehicle, raise it high
enough so that the spare tire
can be installed.
Remember you will need more ground
clearance when putting on the spare
tire than when removing the flat tire.
To raise the vehicl e, insert the jack
handle into the jack (it is a loose fit)
and turn it clockwise. As the jack
touches the vehicle and begins to lift,
double −check that it is properly posi-
tioned.
04 05.18

1512005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
CAUTION
Never get under the vehicle when
the vehicle is supported by the
jack alone.
—Changing wheels
SY41015
6. Remove the wheel nuts andchange tires.
Lift the flat tire straight off and put it
aside.
Roll the spare wheel into position and
align the holes in the wheel with the
bolts. Then lift up the wheel and get
at least the top bolt started through
its hole. Wiggle the tire and press it
back over the other bolts.
SY41016
Before putting on wheels, remove any
corrosion on the mounting surfaces
with a wire brush or such. Installation
of wheels without good metal− to−met-
al contact at the mounting surface can
cause wheel nuts to loosen and
eventually cause a wheel to come off
while driving.
04 05.18

1532005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
CAUTION

When lowering the vehicle,
make sure all portions of your
body and all other persons
around will not be injured as
the vehicle is lowered to the
ground.

Have the wheel nuts tightened
with torque wrench to 103 N·m
(10.5 kgf·m, 76 ft·lbf), as soon
as possible after changing
wheels. Otherwise, the nuts
may loosen and the wheels
may fall off, which could cause
a serious accident.
—Stowing flat tire
9. Restow all the tools and jack se-
curely. Then secure the flat tire
and the spare tire cover with the
tire tie −d o w n bel t s an d th e IS O-
FIX bar in the luggage compart-
ment as follows.
CAUTION
Before driving, make sure all the
tools, jack and flat tire are se-
curely in place in their storage
location to reduce the possibility
of personal injury during a colli-
sion or sudden braking.
SU41034
Aluminum wheels—Before stowing
the flat tire, remove the center wheel
ornament.
Be careful not to lose the wheel orna-
ment.
04 05.18

1542005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU41116c
Put the belt on the ISOFIX bar.
SU41117a
Place a flat tire against the seatback
with the tire in an upright position.
Pass one of the belt hooks through
the center hole located on the wheel
of the flat tire.
SU41118b
Put the spare tire cover against the
flat tire, and then pass the rest of the
belt hooks thorough the hole in the
cover.
04 05.18

1552005 ECHO HATCHBACK from Jul. ’04Prod. (OM52624U)
SU41119d
Tie the tire and board together with
the belt, and then draw the buckle on
the belt toward yourself.
SU41120a
Hold the buckle and pull the belt. Se-
curely tie the tire and spare tire cover.
—After changing wheels
10.Check the air pressure of the re- placed tire.
Adjust the air pressu re to the specifi-
cation designated on page 217 in
Section 8. If the pressure is lower,
drive slowly to the nearest service
station and fill to the correct pressure.
Do not forget to reinstall the tire valve
cap as dirt and moisture could get into
the valve core and possibly cause air
leakage. If the cap is missing, have
a new one put on as soon as possible.
As soon after changing wheels as
possible, tighten the wheel nuts to the
torque specified on page 217 in Sec-
tion 8 with a torque wrench. And have
a technician repair the flat tire.
04 05.18