’04 Tacoma U (L/O 0309)
325
2004 TACOMA from Sep. ’03 Prod. (OM35814U)
AUTOMATIC TRANSMISSION
Fluid capacity (drain and refill),
L (qt., Imp. qt.):
Tw o −wheel drive models except Pre
Runner
Up to 2.4 (2.5, 2.1)
Four −wheel drive models and Pre Run-
ner
Up to 2.0 (2.1, 1.8)
Fluid type:
2RZ− FE engine—
Toyota Genuine ATF D −II or
DEXRON III (DEXRON II)
3RZ− FE and 5VZ −FE engines—
Toyota Genuine ATF Type T −IV
Change automatic transmission fluid
only as necessary. Generally, it is necessary to change
automatic transmission fluid only if
your vehicle is driven under one of
the Special Operating Conditions listed
in your “Scheduled Maintenance
Guide” or “Owner ’s Manual Supple-
ment”. When changing the automatic
transmission fluid, use only “Toyota
Genuine ATF Type T
−IV” (ATF
JWS3309 or NWS6500) to aid in
assuring optimum transmission perfor-
mance.
Notice: Using automatic transmis-
sion fluid other than “Toyota Genu-
ine ATF Type T IV” may cause dete-
rioration in shift quality, locking up
of your transmission accompanied
by vibration, and ultimately damage
the automatic transmission of your
vehicle.
Please contact your Toyota dealer for fur-
ther details.
TRANSFER
Oil capacity, L (qt., Imp. qt.): 1.0 (1.1, 0.9)
Oil type: Gear Oil API GL−4 or GL−5
Recommended oil viscosity: SAE 75W −90 DIFFERENTIAL
Oil capacity, L (qt., Imp. qt.):
Tw o −wheel drive models except Pre
Runner 2RZ− FE engine 1.35 (1.4, 1.2)
5VZ− FE engine 2.55 (2.7, 2.2)
Four −wheel drive models and Pre
Runner
Front (except Pre Runner) 1.15 (1.2, 1.0)
Rear Short wheel baseWith rear differential lock system 2.65 (2.8, 2.3)
Without rear differential lock sys-
tem 2.55 (2.7, 2.2)
Extra long wheel base With rear differential lock system 2.95 (3.1, 2.6)
Without rear differential lock sys-
tem 2.45 (2.6, 2.2)
Oil type: Hypoid Gear Oil API GL −5
’04 Tacoma U (L/O 0309)
326
2004 TACOMA from Sep. ’03 Prod. (OM35814U)
Recommended oil viscosity:Front SAE 75W −90
Rear Above −18 C (0 F)
SAE 90
Below −18 C (0 F)
SAE 80W or 80W −90
CHASSIS LUBRICATION
Wheel bearings: Lithium base wheel bearing grease,
NLGI No.2
Front drive shaft thrust bushings: Synthetic oil and lithium soap base
chassis grease, NLGI No.1
Propeller shafts: SpidersLithium base chassis grease, NLGI
No.2
Slide yoke and double cardan joint Molybdenum −disulfide lithium base
chassis grease, NLGI No.2 BRAKES
Minimum pedal clearance when depressed
with a pressure of 490 N (50 kgf, 110 lbf)
when the engine is stopped and after de-
press the brake pedal several times,
mm (in.):
105 (4.1)
Pedal free play, mm (in.): 1—6 (0.04—0.24)
Pad wear limit, mm (in.): 1.0 (0.04)
Lining wear limit, mm (in.): 1.0 (0.04)
Parking brake adjustment when pulled with
the force of 196 N (20 kgf, 44 lbf): 16—30 clicks
Fluid type: SAE J1703 or FMVSS No.116 DOT 3
STEERING
Wheel free play: Less than 30 mm (1.2 in.)
Power steering fluid type: Automatic transmission fluid DEXRON II
or III
